嫌气条件下土壤中有机还原性物质的动态变化

利用示差脉冲伏安法研究了不同有机物料在嫌气培养条件下产生的有机还原性物质的动态变化．结果表明：在培养起始阶段，强还原性有机物质的数量迅速增加，以后逐渐下降．不同有机物料所产生的有机还原性物质的强度和数量各不相同。培养初期，有机还原性物质种类较多，长时间培养后，部分还原能力较弱的有机物质消失。长时间培养后。嫌气培养液中强还原性有机物质可能与金属离子作用，使其活性降低。     

Influence of humic fractions on retention of isoproturon residues in two Moroccan soils

The influence of different fractions of soil organic matter on the retention of the herbicide isoproturon (IPU) has been evaluated. Water and methanol extractable residues of ¹⁴C labeled isoproturon have been determined in two Moroccan soils by β -counting–liquid chromatography. The quantification of bound residues in soil and in different fractions of soil humic substances has been performed using pyrolysis/scintillation-detected gas-chromatography. Microbial mineralization of the herbicide and soil organic matter has been also monitored. Retention of isoproturon residues after 30-days incubation ranged from 22% to 32% (non-extractable fraction). The radioactivity extracted in an aqueous environment was from 20% to 33% of the amount used for the treatment; meanwhile, methanol was able to extract another 48%. Both soils showed quantities of bound residues into the humin fraction higher than humic and fulvic acids. The total amount of residues retained into the organic matter of the soils was about 65 % of non-extractable fraction, and this percentage did not change with incubation time; on the contrary, the sorption rate of the retention reaction is mostly influenced by the clay fraction and organic content of the soil. Only a little part of the herbicide was mineralized during the experimental time.     

消除身边隐患 保障健康安全——国内外玩具安全标准与法规介绍

本文主要介绍了ISO8124《玩具安全》系列标准、美国玩具安全标准和法案、欧盟玩具安全标准和指令以及我国的玩具安全标准GB24613-2009制定背景、适用范围、有害物质限量等,同时还就玩具安全标准未来发展提出了建议。     

缸内直喷汽油车颗粒物化学组分特征

随着缸内直喷汽油车（GDI）的大量使用,其尾气颗粒物排放问题日益凸显.研究缸内直喷汽油车尾气颗粒物构成组分是有效控制其颗粒物排放的重要前期工作之一.选取了5辆满足国六排放标准的缸内直喷汽油车进行了尾气颗粒物碳质成分、水溶性离子和多环芳烃（PAHs）组分分析.结果发现,各类碳质是测试车辆尾气颗粒物中的主要成分,平均占比约70%.颗粒物碳质中有机碳质（OC）多于核态碳质（EC）,OC/EC比值在1.03~3.43之间.测量了颗粒物中多种水溶性离子的含量,结果表明Ca²⁺和SO₄^2-是尾气颗粒物中的主要水溶性离子,主要来源均为机油添加剂.此外,结果还发现GDI车辆尾气颗粒物中高环PAHs排放占比较高,对人体健康危害大,需要重点关注.     

Modeling the binding of triazine herbicides to humic substances using capillary electrophoresis

The binding of 4 s-triazines herbicides and metabolites, ameline, hydroxyatrazine, atraton, and ametryn to 12 structurally different humic substances was studied by affinity capillary electrophoresis. Binding data were confronted to the structural data of humic acids obtained from spectrometric measurements (UV-Vis, FT/IR, NMR), elemental analysis and potentiometric titration. The results obtained with principal component analysis and partial least square analysis clearly show the importance of carboxylic acidity and aromaticity of the humic ligands in relation to the partial positive charge and relative hydrophobicity of the pesticides.     

含水介质中胞外聚合物的影响因素研究

明确含水介质中微生物胞外聚合物(EPS)生成量的影响因素,是解决含水层生物堵塞的关键问题.本文在现场样品采集和微生物培养的基础上,通过砂柱试验模拟人工回灌过程,系统研究了进水碳、氮、磷浓度、盐度和温度对含水介质中EPS组成和含量的影响.结果表明,砂柱中EPS最主要的成分为多糖和蛋白质,其中多糖占总量的72%~99%;砂柱生物堵塞程度与介质上附着的EPS含量呈正相关关系,当回灌水碳、氮、磷浓度、盐度和温度分别为50 mg·L-1、5 mg·L-1、1 mg·L-1、0.5%和30℃时,微生物EPS生成量最高,砂柱渗透系数降低最显著,堵塞程度最严重.此外,碳、磷浓度、盐度和温度是影响EPS生成量的主要因素,而氮浓度对其影响不大;碳浓度和盐度对EPS中多糖、蛋白质的组成影响较大,而氮、磷以及温度则影响不明显.     

生物沥浸处理中微生物菌群和胞外聚合物对城市污泥脱水性能的影响

探讨城市污泥生物沥浸过程中微生物菌群和胞外聚合物(EPS)变化对污泥脱水性能的影响,对进一步揭示生物沥浸法提高污泥脱水性能机理具有重要意义.本研究通过摇瓶试验探讨了硫杆菌和异养微生物菌群数量的变化及EPS在生物沥浸法提高城市污泥脱水性能中的作用.试验结果表明,在生物沥浸处理的前2 d内,由于硫杆菌A.ferrooxidans LX5和A.thiooxidans TS6的大量生长,导致生物沥浸污泥的pH从初始的4.62显著下降至2.47,进而导致污泥中异养菌数量从初始的2.65×108CFU·mL-1下降至8.20×106CFU·mL-1,污泥中EPS含量从初始的28.18 mg·g-1(以VSS计,下同)显著下降为13.53 mg·g-1.A.ferrooxidans LX5和A.thiooxidans TS6的大量生长、异养微生物细胞的死亡破裂及EPS含量的下降共同促使污泥的结合水含量从初始的37.28%下降至21.10%,最终导致污泥比阻从初始的5.14×1012m·kg-1显著下降至6.92×1011m·kg-1.通过验证试验发现,原始污泥在剥离EPS后其比阻仅为原来的11.23%,其脱水性能与生物沥浸2 d后的污泥在0.05水平上没有显著性差异.因此,污泥中A.ferrooxidans LX5、A.thiooxidans TS6和异养微生物菌群数量的改变及EPS含量的减少是生物沥浸法提高污泥脱水性能的两个重要因素.     

Extraction and characterization of bound extracellular polymeric substances from cultured pure cyanobacterium (Microcystis wesenbergii)

Preliminary characterization of bound extracellular polymeric substances（bEPS） of cyanobacteria is crucial to obtain a better understanding of the formation mechanism of cyanobacterial bloom. However,the characterization of bEPS can be affected by extraction methods. Five sets（including the control） of bEPS from Microcystis extracted by different methods were characterized using three-dimensional excitation and emission matrix（3DEEM） fluorescence spectroscopy combined chemical spectrophotometry; and the characterization results of bEPS samples were further compared. The agents used for extraction were NaOH,pure water and phosphate buffered saline（PBS） containing cationic exchange resins,and hot water. Extraction methods affected the fluorescence signals and intensities in the bEPS. Five fluorescence peaks were observed in the excitation and emission matrix fluorescence spectra of bEPS samples. Two peaks（peaks T1 and T2） present in all extractions were identified as protein-like fluorophores,two（peaks A and C） as humic-like fluorophores,and one（peak E） as a fulvic-like substance.Among these substances,the humic-like and fulvic-like fluorescences were only seen in the bEPS extracted with hot water. Also,NaOH solution extraction could result in strong fluorescence intensities compared to the other extraction methods. It was suggested that NaOH at pH 10.0 was the most appropriate method to extract bEPS from Microcystis. In addition,dialysis could affect the yields and characteristics of extracted bEPS during the determination process. These results will help us to explore the issues of cyanobacterial blooms.     

Comparative sorption and desorption behaviors of PFHxS and PFOS on sequentially extracted humic substances

The sorption and desorption behaviors of two perfluoroalkane sulfonates（PFSAs）, including perfluorohexane sulfonate（PFHx S） and perfluorooctane sulfonate（PFOS） on two humic acids（HAs） and humin（HM）, which were extracted from a peat soil, were investigated. The sorption kinetics and isotherms showed that the sorption of PFOS on the humic substances（HSs） was much higher than PFHx S. For the same PFSA compound, the sorption on HSs followed the order of HM 〉 HA2 〉 HA1. These suggest that hydrophobic interaction plays a key role in the sorption of PFSAs on HSs. The sorption capacities of PFSAs on HSs were significantly related to their aliphaticity, but negatively correlated to aromatic carbons,indicating the importance of aliphatic groups in the sorption of PFSAs. Compared to PFOS,PFHx S displayed distinct desorption hysteresis, probably due to irreversible pore deformation after sorption of PFHx S. The sorption of the two PFSAs on HSs decreased with an increase in p H in the solution. This is ascribed to the electrostatic interaction and hydrogen bonding at lower p H. Hydrophobic interaction might also be stronger at lower p H due to the aggregation of HSs.