膜过滤-气相色谱法测定涂料中的苯系物、环己酮和甲苯二异氰酸酯

采用膜过滤-气相色谱法测定涂料中的苯系物、环己酮和甲苯二异氰酸酯（TD I）。用7种规格的石英毛细管色谱柱对混合标准溶液和涂料试样进行了分析实验,实验结果表明,不同属性的涂料试样添加固定量的正十四烷作内标物,经膜过滤净化后,苯系物、环己酮和TD I可采用DB-1-3或DB-1-2色谱柱同时分离并测定。测试数据经多级校准曲线处理后涂料试样中苯系物、环己酮和TD I的加标回收率为98.6%～101.8%,各组分分析结果的变异系数均小于2.0%,检出限均小于1.50×10^-5g。     

阳离子型聚合物对低温低浊水的絮凝效果与形态学特性

采用微絮凝-深床直接过滤工艺,以西安市曲江水厂低温低浊水质为原水(水温低于10 ℃,初始浊度低于10NTU),投加阳离子型聚合物(简称CP)作主混凝剂或助凝剂,借助分形数学理论与图像分析技术,对滤料粒径、原水浊度、原水温度、药剂种类、聚合物分子量及投加量、混合强度等因素对处理效果的影响进行了研究,分析探讨了不同药剂处理低温低浊水的作用机理、絮凝形态学特征以及絮体结构的分形特性.结果表明,①当温度低于4 ℃、初始浊度小于4NTU时,不宜单独采用Al2(SO4)3或PAC作为絮凝剂;当温度为4～10 ℃、初始浊度小于10NTU时,如果只投加Al2(SO4)3或PAC作为絮凝剂,宜用细砂滤料过滤;低温低浊条件下,无机混凝剂形成的絮体粒径小、结构松散脆弱、有效质量密度低、沉速慢,但表征絮体分形特性的分维值较高.②CP作絮凝剂能显著改善低温低浊水的絮凝效果与过滤性能,但混合强度需增大,宜用粗砂滤料过滤;③单独用CP作絮凝剂时,宜投加分子量较低的弱阳性聚合物或投加低剂量较高分子量的强阳性聚合物;CP用作助凝剂时,能显著减少主混凝剂用量,但宜投加强阳性聚合物或增加弱阳性聚合物的剂量.④CP兼备电性中和与吸附架桥絮凝作用,能形成粒径较大、吸附性能与过滤性能良好的网状絮体构型,其有效质量密度高,产生的污泥量少,污泥沉降速度快,脱水效果好,但分维值低.⑤各种水处理药剂的处理效果为:Al2(SO4)3(或PAC) CP＞CP＞PAC＞Al2(SO4)3,这种差别由絮体的形态学特性与构型特征各异引起.     

微波辐照热解废印刷电路板产物的分析研究

为了减少电子废弃物对环境的危害,实现其资源化回收利用,研究了微波辐照热解废印刷电路板的效果,并采用红外光谱、气相色谱质谱和X荧光光谱等方法对热解产物的组成及性质进行了分析.结果显示:微波热解得到的气体、液体、固体的产率分别为7%～33%、26%～45%、31%～51%,其中气体主要由CO、CO2、H2及有机烃类组成,可燃性气体占70%(体积分数)左右,可作为燃料气加以利用;液体分为水相及油相,经常压蒸馏后得到的120～250 ℃馏分主要为单酚化合物,苯酚高达50%(质量分数)左右,甲基苯酚和邻甲基苯酚为25%(质量分数)以上,是良好的化工原料;固体中除炭外,还含有许多金属如铅、锡和铜等,可以回收利用.说明微波热解技术处理电子废弃物可实现资源化回收利用.     

动态膜-生物反应器对化粪池废水的处理

应用动态膜原理,以0.1mm孔径的普通筛绢代替固定膜材料构成一体式动态膜-生物反应器(DMBR)处理实际化粪池污水。HRT=5h,膜通量J=18L/(m2·h)。动态膜生物反应器对COD和NH4+-N的平均去除率分别达到了65.3%和68.2%,同时还对动态膜的通透性进行了研究。     

不同墩高下连续刚构桥抗震性能分析

以某大跨连续高墩刚构桥为依托,采用Midas/civil软件建立仿真模型,通过时程分析方法研究双肢薄壁墩参数在地震响应下对高墩连续刚构桥抗震性能的影响.以桥墩高度为主要参数,以模型阵型频率、桥墩墩顶、墩底位移及内力变化三个方面对其抗震性能进行评价.研究结果表明,随着其中一个桥墩高度的增加,桥梁频率不断减小,矮墩墩底及矮...     

固定化生物活性炭纤维处理洗浴废水的研究

采用混凝-砂滤-固定化生物活性炭纤维的组合处理工艺来处理洗浴废水.利用聚合氯化铝和聚丙烯酰胺为混凝剂对废水进行混凝处理,之后将废水通入砂滤柱,废水在曝气池进行曝气后进入固定化生物活性炭纤维(IBACF)单元.IBACF固定化完成后,连续运行30 d,去除率稳定之后,处理后的浊度、LAS、S0D_(Mn)平均值分别为2.2NTU、0.12 mg·L~(-1)、2.33 mg·L~(-1),平均去除率分别为95.2%、94.7%、84.8%.经处理后的洗浴废水各项指标均可以达到生活饮用水卫生标准或城市供水水质标准,可以直接回用于洗浴用水和其他生活杂用水.     

Transformations of particles, metal elements and natural organic matter in different water treatment processes

Characterizing natural organic matter （NOM）, particles and elements in different water treatment processes can give a useful information to optimize water treatment operations. In this article, transformations of particles, metal elements and NOM in a pilot-scale water treatment plant were investigated by laser light granularity system, particle counter, glass-fiber membrane filtration, inductively coupled plasma-optical emission spectroscopy, ultra filtration and resin absorbents fractionation. The results showed that particles, NOM and trihalomethane formation precursors were removed synergistically by sequential treatment of different processes. Preozonation markedly changed the polarity and molecular weight of NOM, and it could be conducive to the following coagulation process through destabilizing particles and colloids; mid-ozonation enhanced the subsequent granular activated carbon （GAC） filtration process by decreasing molecular weight of organic matters. Coagulation-flotation and GAC were more efficient in removing fixed suspended solids and larger particles; while sand-filtration was more efficient in removing volatile suspended solids and smaller particles. Flotation performed better than sedimentation in terms of particle and NOM removal. The type of coagulant could greatly affect the performance of coagulation-flotation. Pre-hydrolyzed composite coagulant （HPAC） was superior to FeCl3 concerning the removals of hydrophobic dissolved organic carbon and volatile suspended solids. The leakages of flocs from sand-filtration and microorganisms from GAC should be mitigated to ensure the reliability of the whole treatment system.     

Improvement of the antifouling characteristics in a bioreactor of polypropylene microporous membrane by the adsorption of Tween 20

Surface modification by physical adsorption of Tween 20 was accomplished on polypropylene microporous membranes (PPMMs). Attenuated total reflection-Fourier transform infrared spectroscopy (ATR/FT-IR) and scanning electron microscope (SEM) were used to characterize the chemical and morphological changes on the membrane surfaces. Water contact angles and relative pure water fluxes were measured. The data showed that the hydrophilic performance for the modified membranes increased with the increase in the adsorption amount of Tween 20 onto the surface or into the pores of polypropylene microporous membranes. To test the antifouling property of the membranes by the adsorption of Tween 20 in a membrane bioreactor (MBR), filtration for active sludge was performed using synthetic wastewater. With the help of the data of water fluxes and the FE-SEM photos of the modified PPMMs before or after operating in a MBR for about 12 d, the PPMMs with monolayer adsorption of Tween 20 showed higher remained flux and stronger antifouling ability than unmodified membrane and other modification membranes studied.     

Food for Thought: Audience Engagement with Sustainability Messages in Branded Content

Branded platforms are a growing “gray-zone” of marketing and media messages, in which corporations and news journalists partner to create content that supports strategic corporate goals while aligning with a publication’s scope of editorial coverage. As corporations are key influencers of and contributors to environmental communication, this trend has the potential to change environmental dialogue. In this article, we closely examine messages about food and sustainability, created in partnership by Chipotle Mexican Grill and the Huffington Post news site. We illustrate how use of a branded platform expanded the scope of environmental topics, issues, and frames that Chipotle addresses, how frames identified here connect to frames in coverage of science-related issues, as identified by other scholars, and discuss how branded platforms allow corporations to draw attention to polarizing environmental issues while protecting stakeholder relationships and brand reputation.     

铁炭微电解预处理电路板废水

采用铁炭微电解法预处理电路板废水.结果表明,在进水pH为2.00、铁炭质量比为4:1、振荡时间为20 min的铁炭微电解静态实验最佳条件下,絮凝出水COD去除率为30%;在进水pH为2.00、铁炭质量比为4:1、水力停留时间为50 min的铁炭微电解柱动态实验最佳条件下,连续曝气.絮凝出水COD为11021 mg/L,COD去除率约为34%,BOD5/COD从0.12上升到0.32,可生化性提高,Cu2+质量浓度从9.11 mg/L下降至0.76 mg/L,降低了废水的生物毒性,为生化处理创造了条件.