Development of a combined isotopic and mass-balance approach to determine dissolved organic carbon sources in eutrophic reservoirs

A combined mass-balance and stable isotope approach was set up to identify and quantify dissolved organic carbon (DOC) sources in a DOC-rich (9 mg L⁻¹) eutrophic reservoir located in Western France and used for drinking water supply (so-called Rophemel reservoir). The mass-balance approach consisted in measuring the flux of allochthonous DOC on a daily basis, and in comparing it with the effective (measured) DOC concentration of the reservoir. The isotopic approach consisted, for its part, in measuring the carbon isotope ratios (δ¹³C values) of both allochthonous and autochthonous DOC sources, and comparing these values with the δ¹³C values of the reservoir DOC. Results from both approaches were consistent pointing out for a DOC of 100% allochthonous origin. In particular, the δ¹³C values of the DOC recovered in the reservoir (−28.5 ± 0.2‰; n = 22) during the algal bloom season (May-September) showed no trace of an autochthonous contribution (δ¹³C in algae = −30.1 ± 0.3‰; n = 2) being indistinguishable from the δ¹³C values of allochthonous DOC from inflowing rivers (−28.6 ± 0.1‰; n = 8). These results demonstrate that eutrophication is not responsible for the high DOC concentrations observed in the Rophemel reservoir and that limiting eutrophication of this reservoir will not reduce the potential formation of disinfection by-products during water treatment. The methodology developed in this study based on a complementary isotopic and mass-balance approach provides a powerful tool, suitable to identify and quantify DOC sources in eutrophic, DOC-contaminated reservoirs.     

给水曝气生物滤池内置粉末活性炭复合净水效果的研究

在给水曝气生物滤池内置粉末活性炭,对比分析其对各工艺单元水质净化效果的影响,确定给水曝气生物滤池内置粉末活性炭的作用与最佳投加量,研究表明,给水曝气生物滤池将活性炭截留在滤池内,大幅度提高了粉末活性炭利用率,部分未饱和粉末活性炭通过反冲洗排入后续常规处理系统,作为生物载体仍能够进一步发挥生物强化作用。当粉末活性炭的投加量为8 mg/L时,砂滤出水氨氮、CODMn、浊度和色度均值分别为：0.02 mg/L,1.82 mg/L0,.46 NTU和6度,去除率分别达到99.6%、71.2%、99.1%和80.6%,出水指标达到《生活饮用水卫生标准（》GB5749-2006）和《饮用净水水质标准（》CJ94-2005）规定的标准。与常规工艺相比,投加量降低了20%～60%。     

PVA降解混合菌系生长和产酶的营养条件分析

研究碳源、氮源以及不同金属离子对PVA降解混合菌系生长和产酶的影响。结果表明,混合菌系生长过程中无机氮源优于有机氮源;补充碳源可促进混合菌系的生长,但酶活比不添加时稍有降低。金属离子对酶活影响的正交实验表明Mg2＋浓度影响最大,其次是Fe2＋和K＋浓度,Ca2＋、Mn2＋、Zn2＋和Cu2＋浓度影响较小;最佳浓度分别为Mg2＋0.05 g/L、Fe2＋0.04 g/L、K＋2 g/L和Ca2＋0.05 g/L。     

活性炭纤维(ACF)应用于有机废气回收和净化的进展

活性炭纤维(ACF)有比普通活性炭吸附量大、吸附和脱附速度快等优点,因此应用于有机废气的回收和净化,具有良好的经济、环境和社会效益。文中介绍了ACF的微观结构、表面化学以及吸附性能,并综述了近年来ACF在有机废气回收和治理方面的国内概况。     

Modifications of black carbons and their influence on pyrene sorption

Sorption of pyrene on black carbons (BCs) obtained by heating sawdust at two temperatures (400 and 700 °C, denoted as 400BC and 700BC, respectively), as well as on modified BCs (via oxidation, oximation, and hydrolysis) was studied to investigate the role of BC structural characteristics in sorption of hydrophobic organic compounds. Pyrene was bound strongly by 700BC and 400BC, with organic carbon normalized distribution coefficients (K_oc) of 10^5.04-10^5.86 and 10^4.65-10^5.16, respectively, at equilibrium pyrene concentrations of 10-100 μg L⁻¹. Both chemical composition and pore distribution of the two BCs changed after modifications, which led to changes in their sorption characteristics for pyrene. After modifications, the linearity of pyrene sorption isotherm increased for 700BC but decreased for 400BC. For 700BC, both oxidation and oximation reduced pyrene sorption, with K_oc decreasing by 69.1-73.7% and 18.7-33.9%, respectively, whereas hydrolysis did not exert a significant influence. For 400BC, oxidation and hydrolysis reduced K_oc by 2.28-25.9% and 29.2-33.9%, respectively, while oximation increased K_oc. In most cases, the change in sorption capacity could be explained by the changes in C content and type, polarity, surface area, and micropore volume of the BCs; however, the role of conformation (the accessibility to sorption sites) could not be ignored.     

Combustion-derived substances in deep basins of Puget Sound: historical inputs from fossil fuel and biomass combustion

Reconstructions of 250 years historical inputs of two distinct types of black carbon (soot/graphitic black carbon (GBC) and char-BC) were conducted on sediment cores from two basins of the Puget Sound, WA. Signatures of polycyclic aromatic hydrocarbons (PAHs) were also used to support the historical reconstructions of BC to this system. Down-core maxima in GBC and combustion-derived PAHs occurred in the 1940s in the cores from the Puget Sound Main Basin, whereas in Hood Canal such peak was observed in the 1970s, showing basin-specific differences in inputs of combustion byproducts. This system showed relatively higher inputs from softwood combustion than the northeastern U.S. The historical variations in char-BC concentrations were consistent with shifts in climate indices, suggesting an influence of climate oscillations on wildfire events. Environmental loading of combustion byproducts thus appears as a complex function of urbanization, fuel usage, combustion technology, environmental policies, and climate conditions.     

Inside-sediment partitioning of PAH, PCB and organochlorine compounds and inferences on sampling and normalization methods

Comparability of sediment analyses for semivolatile organic substances is still low. Neither screening of the sediments nor organic-carbon based normalization is sufficient to obtain comparable results. We are showing the interdependency of grain-size effects with inside-sediment organic-matter distribution for PAH, PCB and organochlorine compounds. Surface sediment samples collected by Van-Veen grab were sieved and analyzed for 16 PAH, 6 PCB and 18 organochlorine pesticides (OCP) as well as organic-matter content. Since bulk concentrations are influenced by grain-size effects themselves, we used a novel normalization method based on the sum of concentrations in the separate grain-size fractions of the sediments. By calculating relative normalized concentrations, it was possible to clearly show underlying mechanisms throughout a heterogeneous set of samples. Furthermore, we were able to show that, for comparability, screening at <125 μm is best suited and can be further improved by additional organic-carbon normalization.     

光催化还原CO2的研究进展

介绍了多种将CO2转化为化工产品的光催化还原体系,包括TiO2体系、金属修饰的TiO2体系、有机光敏化剂修饰的TiO2体系和其他光敏半导体材料体系.评述了不同光催化体系的特点及其催化性能.讨论了光源波长、反应温度、CO2压力和浓度、H2O和CO2摩尔比等实验条件对反应产物种类及其产量的影响,指出催化剂的活性、光源波长和...     

活性炭涂层电极电容去离子的性能

采用活性炭涂层电极构建电容去离子吸附装置,以氯化钠模拟含盐原水,研究电压、流量、进水浓度等操作参数对活性炭涂层电极脱盐效率和能耗的影响。实验结果表明,去除率和比吸附量随着电压的增大而增加,且比能耗随之增大。流速越小,出水的浓度越低,当对出水的浓度要求较高时,宜采用小流速。当进水浓度低于活性炭涂层电极的饱和吸附量时,比吸附量随着进水浓度呈线性增加;当达到饱和吸附量时,比吸附量不会随进水浓度的增大而发生改变;比能耗随着进水浓度的增加而降低。     

PW_(12)/g-C_3N_4光催化降解甲基橙

采用浸渍法制备了磷钨酸(PW12)/g-C3N4复合光催化剂,并将其用于溶液中甲基橙的光催化降解,运用IR技术对使用前后的光催化剂进行了表征。表征结果显示,PW12和g-C3N4的结构未在浸渍负载中发生改变,且PW12和g-C3N4结合牢固。实验结果表明:最佳的PW12负载量(光催化剂中PW12的质量分数)为50%;光催化降解甲基橙的优化反应条件为初始甲基橙质量浓度5 mg/L、光催化剂加入量0.6 g/L、初始溶液p H=7;在优化条件下,分别采用紫外光、模拟太阳光、可见光照射120 min后,甲基橙的降解率分别为96.59%,82.23%,42.78%;该光催化剂固载良好,使用中不易发生溶脱,稳定性好,可重复使用。