沼泽湿地植物光合特性及固“碳”潜势对外源氮输入的响应

以沼泽湿地典型草甸植被小叶章(Calamagrostis angustifolia)为研究对象,在三江平原进行了野外培养实验,探讨了4个不同氮素输入水平(0(NO)、6(N6),12(N12)、24(N24)g·m-2· a-1)下沼泽湿地植物生长与光合特性的响应特征,并从光合固"碳"的角度分析了小叶章沼泽湿地的固"碳"潜势.结果表明,外源氮输入明显促进了小叶章的株高、叶面积及植株数,显著增加了碳的生物量积累,到植物生长季结束,N6、N12和N24三个施氮水平下,小叶章地上部分生物量分别比对照增加了58.79%、133.11%和190.55%.同时,小叶章叶片全氮含量、叶绿素、可溶性蛋白和游离氨基酸含量也显著增加,净光合速率明显提高,分别比对照增加了20.70%、26.69%和53.54%.从光合固"碳"的角度来看,外源氮输入能够促使沼泽湿地植物通过光合作用固定更多CO2.     

Coupling catalytic hydrolysis and oxidation for CS2 removal

CS2 removal was Obtained by coupling catalytic hyidation on bi-functional catalyst.On the hydrolysis active sites,CS2 is hydrolyzed to H2S,while on the oxidation active sites,H2S is oxidized to elemental S or sulfuric acid deposited on the porous support.The above process can be expressed as followsCS2→H2O COS →H2O H2S→O2 S/SO2- 4.H2S oxidation eliminates its prohibition on CS2 hydrolysis so that the rate of coupling removal CS2 is 5 times higher than that of CS2 hydrolysis.The same active energy of hydrolysis and coupling reaction also indicates that H2S oxidation does not change the reaction mechanism of CS2 hydrolysis.Temperature has obvious effect on the process while the mole ratio of O2 concentration to CS2 concentration (O/S) does not,especially in excess of 2.5.The formation of sulfuric acid on the catalyst surface poisons hydrolysis active sites and causes the decrease of left OH-1 concentration on the catalysts surface.Lower temperature is suggested for this bi-functional catalyst owing to the low yield ratio of S/SO4 2-.     

Geological emission of methane from the Yakela condensed oil/gas field in Talimu Basin, Xinjiang, China

A static flux chamber method was applied to study natural emissions of methane into the atmosphere in the Yakela condensed oil/gas field in Talimu Basin, Xinjiang, China. Using an online method, which couples a gas chromatography/high-temperature conversion/isotope ratio mass spectrometry (GC/C/MS) together, the 13C/12C ratios of methane in the flux chambers were measured. The results demonstrated that methane gases were liable to migrate from deep oil/gas reservoir to the surface through microseepage and p...     

活性炭多维电极法处理活性染料模拟废水的机理研究

以活性嫩黄K-4G染料模拟废水为处理对象,探讨了多维电极系统处理活性染料废水时色度、COD降解的效果和机理。结果表明,活性炭多维电极法对染料废水的处理效果优于单纯电解法和单纯活性炭吸附法;氧化和还原作用对染料的色度和COD去除效果相差不大;增大处理系统中溶液的循环流量可显著改善活性炭多维电极系统对COD和色度的去除效果。     

两种类型的活性炭对Zn(Ⅱ)的吸附作用研究

分别用木炭和煤炭作为吸附剂,对Zn(Ⅱ)进行了吸附试验。虽然木炭的比表面积小于煤炭,但其对Zn(Ⅱ)的吸附作用明显优于煤炭。同时,溶液的pH对活性炭的吸附作用也有很大影响。在pH<7时,活性炭对Zn(Ⅱ)的吸附作用随着pH的增加而增加。     

洗毛废水的不同处理方法对活性炭吸附的影响

通过活性炭吸附2种不同处理方法处理后的洗毛废水,研究了活性炭的吸附容量和吸附机理。结果表明：活性炭吸附无机酸酸化处理后废水和高分子絮凝剂处理后废水中COD的吸附容量分别为：70mg／g和43mg／g。进一步研究发现,2种废水中废水中小分子组分和疏水性组分的含量差异是造成活性炭吸附效果差异的主要原因。     

多维电极体系处理模拟染料废水的实验研究

以自制多维电极体系对模拟染料废水CODcr及色度去除进行研究,同时考察反应器电压、电解时间、主电极极间距、电流密度等因素对去除效果的影响。试验结果表明,在最佳反应条件下,印染废水经电解后,脱色率达90％以上,CODcr去除率达81％以上,为难降解染料废水的处理提供了一种新方法。     

高锰酸钾-粉末活性炭工艺处理城市污水的实验研究

高锰酸钾-粉末活性炭工艺能有效去除微污染水源中的有机物、浊度、色度,该工艺具有操作简便、易控制、投资节省的特点。本文通过改变传统工艺中用聚合氯化铝做混凝剂的做法,选用硫酸铝做混凝剂,确定影响处理效果的因素,得出最佳实验条件。实验结果表明,（1）高锰酸钾-粉末活性炭工艺处理效果与试剂投加顺序有密切关系;（2）高锰酸钾-粉末活性炭处理工艺能显著改善水质,比单独使用粉末活性炭效果更好。     

印染废水治理方案分析

某针织印染厂年产3000吨针织高档服装布料,排放的生产废水中含有大量的有机物,COD、BOD5、色度浓度比较高。该厂选择了"厌氧水解酸化+接触氧化法+活性炭吸附"处理工艺。该工艺采用厌氧水解酸化处理工艺进行前期处理,去除大部分有机物,减轻了后续接触氧化处理工艺的压力,同时通过活性碳过滤进行脱色,达到较好的处理效果。运行结果表明,经该工艺处理后,废水中的COD、BOD5、色度等指标均能达标排放,有利于企业的可持续发展。     

A carbon footprint analysis in the textile supply chain

This research work focuses on the application of life-cycle assessment methodology to determine the carbon footprint of different players involved in a supply chain of the textile sector. A case study of a product by a textile leader company was carried out. This study demonstrates that, in the textile chain, the main contribution to the greenhouse effect is provided by the electrical and thermal energy used and by the transportation (since different production phases are delocalised in a wide range that goes from South Africa, Italy, Romania and all around the world, from the distribution centre to the stores). The Monte Carlo analysis has been used in order to obtain, for each calculated impact, not only the average value but also the distribution curve of the results characterised by uncertainty parameters. Moreover, a sensitivity analysis was carried out to evaluate the impact of management choices such as:

??a change in the transportation modality, from aeroplane to boat;

??a combination of road and rail transportation; and

??a selection among suppliers that allows the firm to cut environmental impacts.