硒连续化学提取技术中的若干问题讨论

硒的生物可利用性、毒性、环境行为和生物效应等不仅仅与硒的总量有关,更取决于硒的形态。硒的连续化学提取技术是硒形态研究的一个重要手段。在硒七步连续提取方案的基础上,重点探讨了有机结合态、元素态、硫化物/硒化物结合态硒的提取技术细节,讨论了不同液固比和提取剂对硒提取的影响,并对不同结合态硒提取中存在的问题进行了相应讨论。研究结果表明:在硒的连续化学提取过程中,液固比为20:1到50:1时能够满足不同结合态硒提取的要求;在水浴加热条件下,NaOH浓度0.1～0.5mol/L时能有效提取有机结合态硒;1mol/LNa2SO3溶液是元素硒的较好提取剂;而对于硫化物/硒化物结合态硒,600～700ml/min的载气气流能保证其还原所产生HSe气体的完全吸收。     

退耕还林工程对黄土高原土地利用/覆被变化的影响——以陕西省安塞县为例

退耕还林工程(Sloping land conversion program, SLCP)可快速改变土地利用/覆被格局。论文以黄土高原典型沟壑区--陕西省安塞县为例,利用MSS/TM/ETM+卫星遥感影像,获取研究区6个时期土地利用/覆被的时空信息,通过统计模型,定量分析了研究区SLCP对土地利用/覆被格局的影响。草地、耕地及林地为研究区三大主要土地利用/覆被类型,研究区土地利用/覆被变化整体处于不平衡态势;整个研究时段内,耕地先增后减,整体减少38.4%;林地先减后增,整体增加4.36%;灌木林地和草地减少,而未成林造林地快速增加;SLCP显著加强了耕地的递减趋势,并大幅增加了未成林造林地面积,至2010年未成林造林地面积显著大于天然林地的面积。这些变化可能具有降低土壤侵蚀与产流量、改善土壤结构、增加土壤碳吸收等效应;SLCP能提高农民收入,且大部分农民支持SLCP;但其负面效应亦不可忽视。研究将有助于对SLCP效应的全面理解,并可为该区生态恢复工程的规划与决策及生态环境保护提供参考。     

Preparation of solar-enhanced AlZnO@carbon nano-substrates for remediation of textile wastewaters

Photoactive aluminum doped ZnO(AlZnO) was synthesized by sol-gel method.After that,AlZnO photocatalyst was deposited on five carbon-based materials(CBMs) using ultrasonic route followed by solid-state mixing using ball mill.The CBMs used were poly aniline(PANI),carbon nitride(CN),carbon nanotubes(CNT),graphene(G),and carbon nanofibers(CNF).The crystal phases,elemental compositions,morphological,and optical properties of the AlZnO@CBMs composites were investigated.Experimental results revealed that two of AlZnO@CBMs composites exhibited superior bleaching efficiency(100% removal) and photocatalytic stability(three cycles) for 50 μmol/L Methylene Blue(MB) contaminated water after 60 min irradiation in visible light at pH 6.5,0.7% H_2O_2,and 5 g/L inorganic salts.Under optimum conditions,AlZnO@CBMs nanocomposites were employed for the treatment of mixed dyestuffs composed of MB,Methyl Orange(MO),Astrazone Blue FRR(BB 69),and Rhodamine B(RhB) dyes under dark,ultraviolet,visible,and direct sunlight.For mixed dyestuffs,the AlZnO@G achieved the highest dye sorption capacity(60.91 μmol dye stuffs/g) with kinetic rate 8.22 × 10~(-3) min~(-1) in 90 min via multi-layer physisorption(Freundlich isotherm) on graphene sheet.In additions,AlZnO@CN offered the highest photo-kinetic rate(K_(photo)) of～54.1 × 10~(-3) min~(-1)(93.8% after 60 min) under direct sunlight.Furthermore,the selective radical trapping experiment confirmed that the holes and oxidative superoxide radicals are crucial on dyes photodegradation pathway.Owing to their superior performance,AlZnO@G and AlZnO@CN nanocomposites can offer an effective in-situ solar-assisted adsorption/photocatalytic remediation of textile wastewater effluents.     

UV/H2O2工艺降解微囊藻毒素-LR

采用UV/H₂O₂联合工艺,研究了光强、初始浓度、H₂O₂投加量、pH及阴离子对微囊藻毒素-LR (MC-LR)去除率的影响.结果表明,单独H₂O₂对MC-LR基本无去除效果;单独UV工艺可以一定程度上降解MC-LR;而UV/H₂O₂联合工艺由于发生协同作用明显提高降解效率.试验发现,随着光强的增大,MC-LR的去除率不断提高;随着MC-LR初始浓度的增大,其去除率不断降低;随着H₂O₂投加量的增大,降解速率常数逐渐增大,当H₂O₂投加量由1 mmol/L增大到3 mmol/L时,降解速率常数由0.084 4上升到0.166 4;当pH为3.13时,在相同条件下MC-LR的去除效果最好;阴离子的投加不利于MC-LR的降解,其中CO^2-₃、NO^-₃影响最大.     

基于生态分区的我国湖泊营养盐控制目标研究

为更好地控制我国湖泊的富营养化水平,在五大湖泊生态分区的基础上,对不同生态分区的100个湖泊总氮(TN)、总磷(TP)、TN/TP与叶绿素a(Chl-a)的关系进行了分析,进而提出了不同生态分区的湖泊营养盐控制目标.结果表明,五大湖泊生态分区中,东北湖区富营养化水平最低,华北湖区富营养化水平最高,近几年五大湖区湖泊富营养水平呈上升趋势.从TN、TP对五大生态分区湖泊Chl-a浓度的影响看,TP是东北和华北湖区湖泊藻类生长的限制性营养盐,而TN和TP同时是中东部、云贵和蒙新湖区湖泊藻类生长的限制性营养盐.从TN/TP判断,在TN/TP<10的湖泊中,除华北湖区外的其他4个湖区湖泊Chl-a均受TN显著影响;TP仅对东北、蒙新湖区湖泊的Chl-a有显著影响.在TN/TP>17的湖泊中,除蒙新湖区外的其他4个湖区湖泊Chl-a均受TP显著影响,而在中东部、云贵和蒙新湖区,TN对Chl-a也有显著影响.在10相似文献   

机动车排放检测和维修制度实施效果分析

实施检测和维修制度是机动车污染控制的重要措施 ,机动车排放检测是检测和维修制度的主要内容 .本研究利用累积分布曲线 ,通过双怠速检测排放限值对各类型高排放车辆的识别率 ,从检测数据、现行标准、上线合格率 3个角度对北京市检测和维修制度的排放限值制定、组织形式和实施效果进行分析 ,提出各受检物排放限值的匹配原则 .     

UV/H2O2降解水中2,4-二氯酚实验研究

研究溶液浊度、pH值及不同光源等因素对 2 ,4 二氯酚降解的影响 ,确定了UV/H2 O2 光氧化降解 2 ,4 二氯酚反应器的水质适用范围 (浊度小于 6NTU)。在 30W的紫外光照射下 ,2 0mg/L 2 ,4 二氯酚 ,H2 O2 的投加剂量为 1 .2 8mg/L时 ,90min内 2 ,4 二氯酚去除率可达到 95 % .实验证明UV/H2 O2 光氧化技术是低浊度水深度处理的一种有效方法 .     

Fractionation of residual Al in natural water treatment from reservoir with poly-aluminum-silicate-chloride (PASiC): Effect of OH/Al, Si/Al molar ratios and initial pH

An aluminum fractionation study was conducted for a surface reservoir water treatment to understand the performance of poly-aluminum-silicate-chloride (PASiC) in terms of the residual Al fractions as a function of initial pH. The coagulation performance expressed as turbidity and organic matter removal was established as supporting data. Some extra data were evaluated in terms of the residual Al ratio of the composite PASiC coagulant. The main residual Al sources were the Al fractions derived from the use of PASiC. The turbidity and organic matter removal ability was optimal at initial pH 6.00-7.00, while the concentrations of various residual Al species and the residual Al ratio of PASiC were minimal at an initial pH range of 7.00-8.00. Under the conditions of OH/Al molar ratio = 2.00 and Si/Al molar ratio = 0.05, PASiC had superior coagulation performance and comparatively low residual Al concentrations. The Al fraction in the composite PASiC coagulant seldom remained under such conditions. Experimental data also indicated that the suspended (filterable) Al fraction was the dominant species, and organic-bound or organo-Al complex Al was considered to be the major species of dissolved Al in water treated by PASiC coagulation. Additionally, the dissolved inorganic monomeric Al species dominated the dissolved monomeric Al fraction.     

Effect of manufacturing methods of AgCl/Al2O3 catalyst on selective catalytic reduction of NOx

The AgCl/Al2O3 catalyst has potential for use in the selective catalytic reduction (SCR) of NOx. A compound hydrocarbon, following oxygenation is used as a type of reducing agent. In this experiment, the AgCl/Al2O3 catalyst was produced by four different methods, and the differences among their reduction catalysis of NOx were compared. Ethanol was used as a type of reducing agent. X-ray diffraction analysis was performed to study the crystalline structure and scanning electron microscope and transmission electron microscope (TEM) were applied to determine the microindentation. The results indicated that, in the range of 350–400°C, there was no significant difference on the NOx reduction rate; however, there was dispersion at high and low temperature ranges. The size of the AgCl particles was about 20–100 nm.     

气溶胶中不同类型碳组分粒径分布特征

了解气溶胶碳组分粒径分布特征对于研究区域气溶胶生成转化机制、辐射特性等非常重要,但北京地区针对气溶胶碳组分粒径分布特征的相关研究非常少.本研究利用MOUDI-120采样器在北京地区3个季节开展气溶胶分级样品的采集,并分析其中不同类型的碳组分的含量,进而系统研究不同季节及污染状况下,各碳组分的粒径分布特征、来源及相互关系.结果表明,碳组分主要富集在细粒子中,秋冬季细粒子中碳组分的比重高于夏季.碳组分主要分布在两个模态,即积聚模态和粗模态. OC1和OC2主要分布在积聚模态,在0. 056～0. 56μm范围内有较高比例,OC3+OC4在粗模态的分布较为明显.Soot-EC浓度较低,没有明显的粒径分布特征,在0. 10～0. 18μm粒径段浓度较高,表明高温燃烧排放的EC主要分布在超细粒径段. Char-EC浓度远高于Soot-EC,在EC中占绝大部分比重.各主要碳组分在白天和夜晚的分布形态基本一致.夏季和冬季较有利于SOC的形成,OC/EC比值明显高于秋季. OC/EC值在不同粒径区间中差异很大,由于水溶性有机物(WSOC)主要分布在0. 056～0. 10μm,OC/EC值明显高于其他粒径段.白天及高温有利于气态有机物氧化生成SOC,致使夏季白天的OC/EC比值明显高于夜晚.各碳组分之间,EC1和OC1相关性最强,此外EC1和K+也有很强的相关性.