耐候钢中微量元素的测定

本文分别用化学法和电感耦合等离子体发射光谱法(ICP-AES)测定了Corten-B和Sten3两种耐候钢中Cr、Cu、Mn、Sb、Si、V、P、Ti等8种微量元素的含量,并与传统的化学法进行了对比.试验证明ICP-AES光谱法不但技术简便、快速、易于推广应用,而且ICP-AES光谱法和微波消解技术联用在微量元素测量上有更准确、安全等方面的优点.另外,ICP-AES仅通过对少量样屑的一次溶样即可得到全部元素的分析结果,节省了钢样,这对于难以取样的情况尤为有利.     

微波消解-原子荧光法测定海洋沉积物中As的研究

研究了微波消解海洋沉积物中的As,在比较几种不同的酸消解体系后,得到适合海洋沉积物分析的酸消解体系.与传统的湿法消解比较,测试结果无显著性差异.微波消解具有快速高效、试剂用量少、空白值低、样品不易挥发等优点,已成为海洋沉积物样品前处理的有效手段.     

Anaerobic tapered fluidized bed reactor for starch wastewater treatment and modeling using multilayer perceptron neural network

Anaerobic treatability of synthetic sago wastewater was investigated in a laboratory anaerobic tapered fluidized bed reactor(ATFBR) with a mesoporous granular activated carbon(GAC)as a support material.The experimental protocol was defined to examine the effect of the maximum organic loading rate(OLR),hydraulic retention time(HRT),the efficiency of the reactor and to report on its steady- state performance.The reactor was subjected to a steady-state operation over a range of OLR up to 85.44 kg COD/(m~3.d).The COD removal efficiency was found to be 92% in the reactor while the biogas produced in the digester reached 25.38 m~3/(m~3·d) of the reactor. With the increase of OLR from 83.7 kg COD/(m~3.d),the COD removal efficiency decreased.Also an artificial neural network(ANN) model using multilayer perceptron(MLP)has been developed for a system of two input variable and five output dependent variables. For the training of the input-output data,the experimental values obtained have been used.The output parameters predicted have been found to be much closer to the corresponding experimental ones and the model was validated for 30% of the untrained data.The mean square error(MSE)was found to be only 0.0146.     

Photovoltaic-thermal (PV/t) panel to minimize electrical and air conditioning energy consumption of a typical office in Beirut

A combined photovoltaic–thermal (PV/t) panel is proposed to produce simultaneously electricity and heat from one integrated unit. The unit utilizes effectively the solar energy through achieving higher PV electrical efficiency and using the thermal energy for heating applications. To predict the performance of the PV/t at a given environmental conditions, a transient mathematical model was developed. The model was integrated in a heating application for a typical office space in the city of Beirut to provide the office needs for electricity, heating during winter season, and dehumidification and evaporative cooling during the summer season. To minimize the yearly office energy (electrical and heat) needs, the PV/t panel cooling air flow rate and the dehumidification regeneration temperature were determined for opimal unit operation. Thermal energy savings of up to 85% in winter and 71% in summer were achived compared to conventional systems at a payback period of 8 years for the panels.     

Identifying and modeling key trade-offs between hydrogen fuel cell and electric vehicles

Through a sensitivity analysis, the trade-off between vehicle range and CO₂ emissions is investigated as a function of electric emissions coefficient. Various powertrains were analysed for use in a small crossover sport utility vehicle. Gasoline, gasoline electric hybrid, diesel, fuel cell and battery electric vehicles (BEVs) were considered. Using various upstream fuel pathways and a model for vehicle performance, emissions and energy use were estimated. The hydrogen fuel cell vehicle was found preferable to BEVs under conditions of high CO₂ emissions per kW-hr and a high vehicle range requirement. The BEV was preferable for all other conditions.     

铁炭微电解预处理电路板废水

采用铁炭微电解法预处理电路板废水.结果表明,在进水pH为2.00、铁炭质量比为4:1、振荡时间为20 min的铁炭微电解静态实验最佳条件下,絮凝出水COD去除率为30%;在进水pH为2.00、铁炭质量比为4:1、水力停留时间为50 min的铁炭微电解柱动态实验最佳条件下,连续曝气.絮凝出水COD为11021 mg/L,COD去除率约为34%,BOD5/COD从0.12上升到0.32,可生化性提高,Cu2+质量浓度从9.11 mg/L下降至0.76 mg/L,降低了废水的生物毒性,为生化处理创造了条件.     

废弃印刷线路板碘化法浸金研究

针对碘化法从废弃印刷线路板中提取金的工艺设计,分别考察了碘的质量分数、n(I₂)/n(I^-)比值、固液比、双氧水的质量分数、pH值、浸出时间和浸出温度对金浸出率的影响。结合正交设计优化实验方法,提出了从废弃印刷线路板中碘化法浸取金的最佳工艺条件：碘的质量分数为1.1％,n(I₂)∶n(I^-)=1∶10,双氧水的质量分数为1.5％,浸出时间4 h,固液比为1∶10,浸出温度为常温（25℃）,溶液pH值为中性,此时金浸出率可达97.5％。     

液-固流化床回收印刷线路板中金属的研究

根据废弃印刷线路板中材料密度不同,采用水介质流化床对印刷线路板粉末中的金属进行回收,对0.25～0.177、0.177～0.104、0.104～0.074和-0.074 mm 4个粒级范围内的物料进行分选试验。试验结果表明,在上述4个粒级范围内,随介质流速的增大,金属回收率降低;金属回收率η与实际操作速度（ua）和颗粒终端沉降速度（ut）的比值φ（ua/ut）存在一定线性关系,分析模拟了η与φ之间的相关性方程,外推试验的结果证明了相关性方程的可靠性;在合适的操作条件下,各粒级范围内金属的回收率分别为95.02%、90.07%、87.5%和92.68%。     

微量金属元素及其配合物对厨余垃圾甲烷发酵的影响

生物可利用的微量金属元素不仅能够保证污染物以最大的速率转化,而且还可以使某些特殊的转化得以发生,并提高微生物对有毒污染物质的耐受能力。在研究厨余垃圾总固体浓度(total solid, TS)、接种量和C/N比对厨余垃圾厌氧发酵影响的基础上,重点探讨微量金属元素钴及其配合物丝氨酸对厨余垃圾厌氧发酵甲烷产量及关键酶含量的影响。结果表明,当TS为0.5%、接种污泥量为100 mL/L和C/N比为20∶1时,厨余垃圾厌氧发酵的甲烷产率较高,为367 mL/g COD;添加2 μmol/L的微量金属元素钴-配合物丝氨酸时,甲烷产率则提高到432 mL/g COD,相应地,辅酶M的含量由空白实验的41.21 μmol/g VSS提高到54.64 μmol/g VSS,辅酶F₄₂₀的含量由0.31 μmol/g VSS提高到0.48 μmol/g VSS。     

浅谈新疆风电场水土保持措施配置——以新疆华电小草湖风电场二场一期工程为例

风能作为一种清洁无污染的可再生能源,已经被广泛运用到电力事业的发展中来。近年来,新疆的风力发电发展迅速,风电场建设过程中不可避免地会对土壤及植被造成一定的破坏,人为地加剧了水土流失。概述了风电项目水土流失特点,以新疆华电小草湖风电场工程为例,结合项目区具体特点,分区设置防治措施。通过工程措施、植物措施与临时措施的有机结合,有效地防止水土流失。