全国土壤侵蚀量估算及其在吸附态氮磷流失量匡算中的应用

应用土壤流失方程(USLE),根据我国土壤水力侵蚀分类分级标准,建立了大尺度区域土壤侵蚀量的估算模型;基于GIS技术平台,利用土壤普查数据,构建了全国表层土壤氮磷含量数据库,完成了2000年全国境内水土流失影响下吸附态氮磷的流失量估算.经数据合理性分析验证后得出以下结论:(1)全国因水土流失引发的吸附态氮素和磷素的流失总量分别达到104.22×104t和34.65×104t;(2)长江、珠江和黄河三大流域的吸附态氮、磷流失量之和分别占全国总量的83%和89%,单位面积(1km2)吸附态氮、磷的流失量分别介于6.0×10-4～0.53t和2.1×10-4～0.13t之间;(3)吸附态氮的重点流失区主要分布在长江中上游水土易蚀区、黄河中游沟壑区、西辽河上游区、珠江流域红水河、西江等上游区以及怒江、澜沧江下游区.     

The 'who' and 'what' of training far disaster relief

This paper defines the various levels within government, the voluntary agencies and the community which might benefit from training and makes suggestions as to where the emphasis should be placed. It points out that training programmes should be designed to meet the expressed needs of a particular group of trainees as well as be related to the current or potential disaster situation.     

COALBED METHANE PRODUCT WATER CHEMISTRY IN THREE WYOMING WATERSHEDS1

ABSTRACT: The Powder River Basin in Wyoming has become one of the most active areas of coalbed methane (CBM) development in the western United States. Extraction of methane from coalbeds requires pumping of aquifer water, which is called product water. Two to ten extraction wells are manifolded into one discharge point and product water is released into nearby unlined holding ponds. The objective of this study was to evaluate the chemistry, salinity, and sodicity of CBM product water at discharge points and associated holding ponds as a function of watershed. The product water samples from the discharge points and associated holding ponds were collected from the Cheyenne River (CHR), Belle Fourche River (BFR), and Little Powder River (LPR) watersheds during the summers of 1999 and 2000. These samples were analyzed for pH, electrical conductivity (EC), total dissolved solids (TDS), alkalinity, sodium (Na), calcium (Ca), magnesium (Mg), potassium (K), sulfate (SO₄^2‐), and chloride (C^1‐). From the chemical data, practical sodium adsorption ratio (SARp) and true sodium adsorption ratio (SARt) were calculated for the CBM discharge water and pond water. The pH, EC, TDS, alkalinity, Na, Ca, Mg, K, SARp, and SARt of CBM discharge water increased significantly moving north from the CHR watershed to the LPR watershed. CBM discharge water in associated holding ponds showed significant increases in EC, TDS, alkalinity, Na, K, SARp, and SARt moving north from the CHR to the LPR watershed. Within watersheds, the only significant change was an increase in pH from 7.21 to 8.26 between discharge points and holding ponds in the LPR watershed. However, the LPR and BFR exhibited larger changes in mean chemistry values in pH, salinity (EC, TDS), and sodicity (SAR) between CBM product water discharges and associated holding ponds than the CHR watershed. For instance, the mean EC and TDS of CBM product water in LPR increased from 1.93 to 2.09 dS/m, and froml,232 to 1,336 mg/L, respectively, between discharge and pond waters. The CHR exhibited no change in EC, TDS, Na, or SAR between discharge water and pond water. Also, while not statistically significant, mean alkalinity of CBM product water in BFR and LPR watersheds decreased from 9.81 to 8.01 meq/L and from 19.87 to 18.14 meq/L, respectively, between discharge and pond waters. The results of this study suggest that release of CBM product water onto the rangelands of BFR and LPR watersheds may precipitate calcium carbonate (CaCO₃) in soils, which in turn may decrease infiltration and increase runoff and erosion. Thus, use of CBM product water for irrigation in LPR and BFR watersheds may require careful planning based on water pH, EC, alkalinity, Na, and SAR, as well as local soil physical and chemical properties.     

NATURAL EROSION RATES AND THEIR PREDICTION IN THE IDAHO BATHOLITH1

ABSTRACT: Natural rates of surface erosion on forested granitic soils in central Idaho were measured in 40 m² bordered erosion plots over a period of four years. In addition, we measured a variety of site variables, soil properties, and summer rainstorm intensities in order to relate erosion rates to site attributes. Median winter erosion rates are approximately twice summer period rates, however mean summer rates are nearly twice winter rates because of infrequent high erosion caused by summer rainstorms. Regression equation models and regression tree models were constructed to explore relationships between erosion and factors that control erosion rates. Ground cover is the single factor that has the greatest influence on erosion rates during both summer and winter periods. Rainstorm intensity (erosivity index) strongly influences summer erosion rates, even on soils with high ground cover percentages. Few summer storms were of sufficient duration and intensity to cause rilling on the plots, and the data set was too small to elucidate differences in rill vs. interrill erosion. The regression tree models are relatively less biased than the regression equations developed, and explained 70 and 84 percent of the variability in summer and winter erosion rates, respectively.     

非点源污染模型中土壤侵蚀因子研究进展

非点源污染模型是进行非点源污染模拟研究的重要手段，而土壤侵蚀模型是非点源污染模型的基础，土壤侵蚀因子的研究是土壤侵蚀模型的重要基础。本文对国内外主要土壤侵蚀因子研究的成果进行了概述，并指出在今后相当一段时期内，土壤侵蚀因子的研究仍是土壤侵蚀模型研究的重要工作。     

头屯河流域水土流失现状及治理对策

介绍头屯河流域气候、植被、水土资源状况,分析了流域水土流失的现状,提出了水土流失治理对策,总结了水土流失治理措施并提出一些建议。     

EFFECTIVENESS OF POLYACRYLAMIDE (PAM) IN IMPROVING RUNOFF WATER QUALITY FROM CONSTRUCTION SITES1

ABSTRACT: Erosion from construction sites significantly affects water quality in receiving streams. A rainfall simulator was used to evaluate the effectiveness of different methods for controlling erosion from construction sites. Erosion control methods investigated included dry and liquid applications of polyacrylamide (PAM), hydroseed, and straw mulch. Fertilizer was also applied to each plot to examine the effectiveness of the methods in reducing nutrient losses in runoff. Runoff samples were analyzed for total suspended solids (TSS), nitrate, total Kjeldahl nitrogen (TKN), ammonium, total phosphorus (TP), and orthophosphate. Among all treatments investigated, straw mulch was the most effective treatment for controlling TSS and nutrient losses during short term and long term simulations. The low liquid PAM (half the recommended PAM) treatment resulted in the highest reduction in runoff, TSS bound nitrogen, and total nitrogen (TN) concentrations and loadings. The study results indicate that a high application rate (twice the recommended rate) of PAM could actually increase runoff and TSS losses. At a low application rate, both liquid and dry PAM were effective in reducing TSS and nutrient losses in runoff. However, application of the liquid form of PAM to construction sites is more practical and perhaps more economical than applying the PAM in the dry form.     

EFFECTS OF WATERSHED REPRESENTATION ON RUNOFF AND SEDIMENT YIELD MODELING1

ABSTRACT: This paper evaluates the effects of watershed geometric representation (i.e., plane and channel representation) on runoff and sediment yield simulations in a semiarid rangeland watershed. A process based, spatially distributed runoff erosion model (KINEROS2) was used to explore four spatial representations of a 4.4 ha experimental watershed. The most complex representation included all 96 channel elements identifiable in the field. The least complex representation contained only five channel elements. It was concluded that oversimplified watershed representations greatly influence runoff and sediment yield simulations by inducing excessive infiltration on hillslopes and distorting runoff patterns and sediment fluxes. Runoff and sediment yield decrease systematically with decreasing complexity in watershed representation. However, less complex representations had less impact on runoff and sediment‐yield simulations for small rainfall events. This study concludes that the selection of the appropriate level of watershed representation can have important theoretical and practical implications on runoff and sediment yield modeling in semiarid environments.