絮凝法分离谷氨酸菌体的研究

采用絮凝法对味精发酵生产过程中发酵液中的菌体进行研究，得到无机凝聚剂与高分子絮凝剂复合配比使用是发酵液去除菌体的有效办法。对复合用药除菌后的谷氨酸发酵液和原谷氨酸发酵液进行谷氨酸回收的比较，谷氨酸的回收率提高了8．8％。     

移动床生物膜反应器充氧能力的试验研究

对移动床生物膜反应器的充氧能力进行了试验研究，结果表明：反应器充氧能力在添加填料比无填料时大；在悬浮载体能够均匀流化的填充率范围内，反应器充氧能力随着填充率的增大而增大；当填充率大于可以均匀流化的最大填充率时，反应器的充氧能力略有下降。     

Numerical Simulation of Synoptic Condition on a Severe Sand Dust Storm

By using observational data and MM5, an observational analysisand numerical study was conducted on the synoptic condition of a severe dust storm that was caused by a Mongolian cyclone whichoccurred from 6 to 8 April 2001. Results illustrated thatthe cyclogenesis was due to the isentropic potential vorticity (IPV) advection in the upper troposphere and the terrain modifiedbaroclinicity in the mid-lower troposphere. The Altai-Sayan complex of mountains blocked the lower level cold air and made the isentropic surface sharply steep. When the air slid down along the isentropic surface the increasing of baroclinicity anddecreasing of stability blew up the vertical vorticity development.The formation of the dust storm was a result of a cyclonic cold front passing across the area. The occurrence of this dust stormwas closely related to the strong surface wind, which was accompanied by a cold front passing, rather than the cyclogenesis, itself. Hence, the reason for the pre-front dust storm formulation was the formation of heating convection. Reasons behind the formation of a black storm (visibilitylower than 50 m), which occurred in the mid-north part ofInner Mongolia, lay in several aspects. Firstly, in thisarea the surface wind was strong, a direct result of thedownward transport in mid-lower troposphere. Secondly,the cold front passed over the effected area near sunsetso the air obtained much more surface heating to form adeeper mixed layer (ML). Thirdly, cooperation between thelower level wind and the terrain made the atmosphere inthis area and acquired the maximum advective contributionnecessary to form a deep post-front ML. The sensitivityexperiment revealed that surface heat flux was important to the frontal lifting. In addition, the forcing of surface heating wasalso seen as the primary forcing mechanism of frontogenesis. Meanwhile, removal of the surface heat flux made the atmosphericstratification became stable and the pre-storm ML very shallow,which weakened the strength of the dust storm.     

SEDIMENT OXYGEN DEMAND IN THE ARROYO COLORADO RIVER1

ABSTRACT: The lower reaches of the Arroyo Colorado have historically failed to meet their use under subsection 303(b) of the U.S. Clean Water Act due to fecal coliform bacteria and low dissolved oxygen (DO). Fish kills, especially at the tidal confluence at the Port of Harlingen, Texas, have been reported. Oxygen demand from sediment (SOD) for a river typically has two states‐diffusion limited SOD (SOD) and potential SOD (pSOD), expressed when sediment is resuspended through increased flow or other disturbances. The objective of this research was to measure SOD in the Arroyo Colorado River in situ, estimate pSOD ex situ, and evaluate the relationship between SOD and the depositional environment. We measured SOD and pSOD in the Arroyo Colorado River at up to eight sites over three sampling events. We identified the sample sites based on a modified Rosgen geomorphic index for streambed stabilization. Sites with high sediment deposition potential had high SOD. The average values of SOD between sites were 0.62 g/m²/day (standard deviation 0.38 g/m²/day) and ranged from 0.13 to 1.2 g/m²/day. Potential SOD values ranged from as low as 19.2 to as high as 2,779 g/m³ sediment/ day. Potential SOD can serve as an indicator of the possible impact of SOD from resuspended sediment in stream systems.     

国内采油废水处理现状

从水污染的定义出发，依次介绍了采油废水的组成及特点、处理采油废水的难点及传统物化方法和生物法处理采油废水的现状。     

提高化学需氧量质控合格率的研究

大庆油田化工总厂废水中化学需氧量（COD）的测定采用库仑法。为了提高质控合格率，从人员素质、仪器设备、电级内液等9个方面分析寻找导致误差的主要影响因素并制定对策。同时对影响电极内液及消解的因素进行正交实验确定最佳条件。结果使库仑法质控合格率由90％提高到95％，测定38次标样全部合格。     

螺旋升流反应器氧传递性能的试验研究

本文主要针对螺旋升流反应器技术特性，对工艺的好氧反应器进行了氧传递性能的试验研究，考察了反应器水深、曝气量等对螺旋升流反应器氧转移过程的影响；并对试验数据进行回归，得到了氧传质总系数与螺旋升流反应器内表现气速的数学关系。试验结果表明，螺旋升流反应器具有良好的氧传递特性，是一种新型的高效、节能的污水处理反应技术。     

典型装饰织物在不同氧浓度下热分析研究

人民生活水平的提高使人民对室内环境的舒适程度提出了更高要求 ,室内装饰织物的用量迅速增加 ,室内装饰织物在燃烧时会释放出大量有毒物质和热量 ,对人及环境构成了巨大危害。因此 ,研究装饰织物的燃烧特性非常重要。笔者利用热重 -差热 (TG -DTA)分析仪对纯棉、棉麻和腈纶这几种典型的装饰织物在不同的氧气浓度 (10 % ,15 % ,2 1% )和升温速率 (10K/min ,30K/min)条件下进行了热重分析 (TG)和差热分析 (DTA)实验 ,研究了它们的燃烧特性 ,并着重进行了不同氧浓度下的对比研究 ,发现试样的燃烧分为两个阶段。建立了以一级反应模型为主的动力学方程 ,并得出了各阶段的动力学参数、表观活化能和频率因子。     

TraK装置测定废水中的BOD_5

在对废水中的BOD5进行常规分析时,采用化学稀释法操作繁琐,对稀释倍数估计易发生错误。而利用TraK装置测试样品时,无须进行稀释和化学分析。用该装置对标准样品BOD5的测定结果表明:准确度相对误差为-3.3%～4.3%,精密度的相对误差为-3.5%～5.6%。该仪器测试性能可靠,数据准确度、精密度合格。与化学法对照分析表明,相对误差都在容许范围内,即在可接受范围内。     

饮用水源水库铁锰垂直分布规律及原因

经对水温分层型季节性缺氧水库铁、锰污染的研究表明,Fe、Mn分布随着季节变化、水库水温分层而变化,呈现明显的垂直分布规律:高浓度Fe、Mn主要出现在水温分层期水库中、下层,与库底缺氧、pH值下降、基岩溶蚀、沉积物高浓度Fe、Mn释放造成的二次污染等密切相关,从而为自来水厂实施优化分层取水和污染控制提供了依据.