不同类型填料的三维电极/Fenton试剂法处理苯酚废水

采用不同类型填料对三维电极/Fenton试剂法处理苯酚模拟废水进行研究.结果表明.不同类型活性炭填料对苯酚去除率有很大影响,粒炭不适合做粒子电极,采用5.0 mm柱炭处理效果较好;采用石英砂与活性炭混合填料的处理效果比单一活性炭填料好,但苯酚去除率提高不明显;电解槽反应器中按比例投加涂膜活性炭和活性炭混合填料能明显提高苯酚去除率;当涂膜活性炭与活性炭体积比为1,2时,苯酚去除率最高,达96.8%.     

Enhanced stability of hydrogen peroxide in the presence of subsurface solids

The stabilization of hydrogen peroxide was investigated as a basis for enhancing its downgradient transport and contact with contaminants during catalyzed H(2)O(2) propagations (CHP) in situ chemical oxidation (ISCO). Stabilization of hydrogen peroxide was investigated in slurries containing four characterized subsurface solids using phytate, citrate, and malonate as stabilizing agents after screening ten potential stabilizers. The extent of hydrogen peroxide stabilization and the most effective stabilizer were solid-specific; however, phytate was usually the most effective stabilizer, increasing the hydrogen peroxide half-life to as much as 50 times. The degree of stabilization was nearly as effective at 10 mM concentrations as at 250 mM or 1 M concentrations. The effect of stabilization on relative rates of hydroxyl radical activity varied between the subsurface solids, but citrate and malonate generally had a greater positive effect than phytate. The effect of phytate, citrate, and malonate on the relative rates of superoxide generation was minimal to somewhat negative, depending on the solid. The results of this research demonstrate that the stabilizers phytate, citrate, and malonate can significantly increase the half-life of hydrogen peroxide in the presence of subsurface solids during CHP reactions while maintaining a significant portion of the reactive oxygen species activity. Use of these stabilizers in the field will likely improve the delivery of hydrogen peroxide and downgradient treatment during CHP ISCO.     

HACH氨氮水质自动监测分析仪进口试剂国产化配方研究

分析HACH氨氮自动监测分析仪所用进口试剂配方中氧化剂、显色剂、催化剂、掩蔽剂、缓冲液的组分、试剂用量、反应机理、吸收光谱、酸碱度、发色时间和温度、显色产物的稳定性、灵敏度、干扰及消除,以及存放条件的差异,自行研发国产配方,并将该国产配方试剂与进口试剂做试验比对,结果 2种试剂的效能无显著差异。     

岛津TNP-4110在线分析仪的日常维护

从数据比对、硬件维护两个方面探讨岛津TNP-4110在线仪的日常维护问题。通过分析各种干扰因素来查找造成数据比对差异的原因并提出相应解决措施。在仪器日常维护上设立不同周期保养计划、共享设备维护经验,结合实践制定了合适的检修流程图。     

Fenton试剂氧化法处理染料结晶废母液

采用Fenton试剂氧化法处理分散橙、分散紫和分散蓝3种染料结晶废母液。研究了H₂O₂加入量、n（H₂O₂）#x02236;n（Fe²⁺）和废母液pH对COD去除率或TOC去除率的影响。对TOC去除反应分段进行了动力学方程拟合,并探讨了反应机理。实验得到的分散橙、分散紫和分散蓝的废母液处理工艺条件：H₂O₂加入量分别为264.4,352.9,441.2mmol/L;n（H₂O₂）#x02236;n（Fe²⁺）分别为20,10,20;废母液pH=3。3种废母液在0~20min和20~120min两个阶段的反应与二级动力学拟合方程的相关性最好。3种废母液经Fenton试剂氧化处理后,部分有机物降解为小分子有机酸,部分有机物完全矿化。     

絮凝#x02014;微波辐射#x02014;Fenton试剂氧化法深度处理焦化废水

用絮凝#x02014;微波辐射#x02014;Fenton试剂氧化法深度处理焦化废水,研究了微波辐射时间、微波功率、FeSO₄加入量、H₂O₂加入量和废水pH对废水处理效果的影响。实验结果表明：在聚合氯化铝加入量为350mg/L、聚丙烯酰胺加入量为12mg/L、废水pH=5、FeSO₄加入量为250mg/L、H₂O₂总加入量为1400mg/L、H₂O₂分3次投加、微波功率为400W、微波辐射时间为60min的条件下,处理后出水的浊度、色度和COD去除率分别为98.59%,97.62%,86.21%。处理后出水澄清透明,COD为50.34mg/L,满足GB50050#x02014;2007《工业循环冷却水处理设计规范》的要求。     

微电解-Fenton联合工艺预处理煤层气井压裂废水

利用Fenton强化微电解工艺对煤层气井压裂废水展开预处理研究,以COD去除率和可生化性(B/C)为考察指标,单独工艺正交实验结果表明pH为3、反应时间为90 min、铁碳体积比为1.5∶1和pH为4、反应时间为80 min、H2O2投加量为4 mL/L分别是微电解与Fenton反应的最优条件,各可获得48.1%和44.9%的COD去除率。在最优条件下进行微电解-Fenton联合运行实验,连续61 h内COD去除率均稳定在65%以上,B/C由0.158上升到0.3以上,有利于后续生化处理的运行。     

Fenton试剂降解PAM催化剂的研究

采用Fenton试剂氧化降解含油废水中的聚丙烯酰胺,研究了H2O2用量、催化剂种类及用量对降解聚丙烯酰胺效果的影响。结果表明,H2O2用量为聚丙烯酰胺的20%为宜;CuCl2具有和FeSO4、Fe(NO3)3、FeCl3相近的催化效果,并且可以作为一种在较高pH值条件下应用的催化剂;在优选条件下该氧化体系可以使聚丙烯酰胺黏度大大降低。     

混凝-Fenton试剂氧化工艺处理机械厂洗涤废水

对某厂机械洗涤废水,采用混凝-Fenton试剂进行处理。结果表明,用聚铝（w（PAC）=5%）对废水进行絮凝沉淀,PAC最佳投加量为1.5 mL/L（废水）,絮凝后的COD去除率为29.6%;芬顿试剂最佳操作条件为：n（H2O2）∶n（Fe2＋）=5∶1,m（H2O2）∶m（COD）=2.5∶1,废水pH=5,温度为30℃,反应时间为2 h,经氧化后,COD的去除率为78.5%;经过混凝沉淀-芬顿氧化处理,COD的总去除率为84.9%,去除效果良好。     

US/Fenton试剂协同处理焦化废水的研究

采用US (超声波)协同Fenton试剂氧化法处理焦化废水,考察了H2O2投加量、Fe2 投加量、废水的pH、反应时间和超声波功率对处理效果的影响,确定了最佳工艺条件.结果表明,在H2O2投加量7.0 g/L;Fe2 投加量500 mg/L;pH=3.0; 反应时间 40 min; 超声波功率 600 W 的条件下,COD、NH3-N、CN-和色度的去除率分别达95.8%、71.3%、69.5%和75.2%,出水COD降至41.0 mg/L.在相同条件下,US/Fenton试剂协同法的处理效率比单独Fenton试剂氧化法的处理效率提高了约20%,且反应时间显著缩短.