Effectiveness of HVAC Duct Cleaning Procedures in Improving Indoor Air Quality

Indoor air quality has become one of the most seriousenvironmental concerns as an average person spends about 22 hrindoors on a daily basis. The study reported in this article, wasconducted to determine the effectiveness of three commercialHVAC (Heating Ventilation Air Conditioning) duct cleaning processes in reducing the level of airborne particulate matterand viable bioaerosols. The three HVAC sanitation processeswere: (1) Contact method (use of conventional vacuum cleaning ofinterior duct surfaces); (2) Air sweep method (use of compressedair to dislodging dirt and debris); (3) Rotary brush method(insertion of a rotary brush into the ductwork to agitate anddislodge the debris). Effectiveness of these sanitationprocesses was evaluated in terms of airborne particulate andviable bioaerosol concentrations in residential homes. Eightidentical homes were selected in the same neighborhood. Twohomes were cleaned using each procedure and two were used ascontrols. It was found that both particle count readings andbioaerosol concentrations were higher when cleaning was beingperformed than before or after cleaning, which suggests thatdirt, debris and other pollutants may become airborne as aresult of disturbances caused by the cleaning processes.Particle count readings at 0.3 micron size were found to haveincreased due to cigarette smoking. Particle counts at 1.0micron size were reduced due to HVAC duct cleaning. Post-levelbioaerosol concentrations, taken two days after cleaning, werefound to be lower than the pre-level concentrations suggestingthat the cleaning procedures were effective to some extent.Homes cleaned with the Air Sweep procedure showed the highestdegree of reduction in bioaerosol concentration among the threeprocedures investigated.     

示波极谱法测定大气总悬浮微粒中微量锌

在乙二胺 (en)介质中 (p H1 1 .5～ 1 2 .3 ) ,Zn(en) 2 +3在单扫描示波极谱仪上于 -1 .42 V(vs.SCE)处产生一灵敏的络合物吸附波 ,锌含量在 0 .0 0 6～ 0 .3 5 μg/ml范围内 ,浓度与峰电流呈线性关系。检测限为 0 .0 0 3 μg/ml。加标回收率为92 %～ 1 0 3 % ,相对标准偏差小于 4.1 %。该方法准确、简便、选择性好 ,可用于 TSP中微量锌的测定。     

四城市空气粗、细颗粒物元素质量谱及富集特征

以武汉市 X荧光光谱分析数据为例 ,介绍了粗、细颗粒物中元素的质量谱及富集特征。并且 ,比较了广州、武汉、兰州、重庆四城市的污染元素及可能污染元素的某些富集特征     

图们市大气颗粒物中重金属含量及分布特征

采集了图们市2006年秋、冬两季的TSP和PM10样品,采用湿法消解-原子吸收分光光度法测定了其中的铅、镉、饲、锌、铬、铁、锰7种重金属.结果表明,图们市大气颗粒物中重金属含量由高到低的顺序是Fe>Cr>Zn>Pb>Mn>Cu>Cd.多数重金属元素含量冬季高于秋季,在一天之内早晨的重金属浓度也往往高于晚上争中午,说明大气颗粒物的来源包括天然源和人为源.     

发展我国大气颗粒物标准样品的国际经验和建议

介绍了国内外大气颗粒物标准样品体系构成及制备技术,分析了我国大气颗粒物标准样品存在的种类和目标组分单一、研制技术薄弱等问题。在借鉴国外发展经验和考虑我国需求和研究能力的基础上,提出了拓宽大气颗粒物标准样品基质和污染物种类、完善标准样品体系、加强合作与科研投入、逐步攻克研制技术难点等对策和建议。     

北京市建筑施工裸地的空间分布及扬尘效应

北京市作为中国典型的快速城市化大城市之一,大规模的城市建设使得城市内部存在大量的建筑施工裸地,工地扬尘效应造成了严重的大气颗粒物污染。以北京市平原区为研究区,首先利用高分辨率卫星数据反演了建筑施工裸地的空间分布格局,在此基础上,结合建筑施工裸地的扬尘排放因子,在空间上定量分析建筑施工裸地的扬尘效应。结果显示,2012年全市平原区建筑施工裸地总面积为140.77 km2,主要分布在城市核心区向外拓展的城乡过渡带。建筑施工裸地的扬尘效应分析中发现北京市平原区建筑施工裸地中TSP、PM10和PM2.5的排放量分别是31.53、16.66、9.16万吨,并且这些污染物的排放量在城市发展新区与功能拓展区中较高,生态涵养发展区较小。以北京市的建筑施工裸地为例,示范了以遥感为技术手段结合污染排放因子的城市内部典型面源污染的监测和污染排放定量化,为今后面源污染的快速准确监测开辟了新的研究思路。     

直接进样-热脱附-GC-MS快速测定大气细颗粒物中有机示踪物

建立了直接进样-热脱附-GC-MS快速测定细颗粒物中甾烷类和藿烷类有机示踪物的方法。经实验条件优化,13种目标化合物的线性回归方程的相关系数均在0.990以上,空白加标回收率为81.4%~102.3%,实际样品加标回收率为79.1%~112.9%,相对标准偏差小于13.2%。当采样体积为24 m~3时,各目标化合物的检出限为0.008~0.084 ng/m~3,方法灵敏度高。利用该方法测定了北京城区采暖季和非采暖季PM2.5实际样品,结果表明:各目标物均有检出,且采暖季的甾烷类和藿烷类化合物的总量均明显高于非采暖季。该方法无需复杂的前处理和有机溶剂,操作简便快捷,在颗粒物中非极性化合物的快速检测方面具有很大的应用价值。     

杭州市空气颗粒物污染特征及变化规律研究

根据2006—2010年杭州市空气颗粒物的监测数据及2002、2006、2008年空气颗粒物来源解析结果,对杭州市空气颗粒物浓度、化学组分与污染来源等特征的变化规律进行分析,以期为空气颗粒物污染控制提供决策依据。结果表明,近年来杭州市PM10浓度有所下降,但一类功能区PM10仍超出《环境空气质量标准》(GB 3095—1996)的要求(≤0.04mg/m3),杭州市空气颗粒物污染以细颗粒物为主,空气颗粒物的二次转化、机动车尾气尘等产生的二次粒子污染相对严重;煤烟尘对杭州市PM10的贡献率下降明显,城市扬尘、二次粒子和机动车尾气尘对PM10的贡献率有所增加,是杭州市PM10的主要来源。     

PM2.5及其工业源头控制技术

PM2.5对人体健康和空气质量有巨大的危害,环保部已修订相关法规和文件,将PM2.5纳入我国环境空气质量监测范围,采取有效手段控制PM2.5是我国一项重要的环保目标,在工业企业中采用最先进的表面过滤技术可从源头控制工业PM2.5的排放。     

A Sampler for Measuring Deposited Fine Sediments in Streams1

Turner, Andy W., Jeff J. Hillis, and Charles F. Rabeni, 2012. A Sampler for Measuring Deposited Fine Sediments in Streams. Journal of the American Water Resources Association (JAWRA) 48(2): 366‐378. DOI: 10.1111/j.1752‐1688.2011.00618.x Abstract: Improvements and standardization of methodologies to quickly and accurately quantify deposited sediment in streams will allow advances in our understanding of biological effects of sedimentation. Most methods used to evaluate streambed conditions as part of biological monitoring or assessment programs are selected for ease of use, but can be subjective, inappropriate, and often of unknown accuracy. We developed a portable, light‐weight device to quantify deposited unconsolidated sediment (particles <2 mm) in wadeable streams. This deposited sediment sampler is a hand‐held unit that circumscribes an area of the streambed and through suction creates a force that suspends unconsolidated materials into a collector. Laboratory evaluations determined the efficiency (percent of available deposited sediment recovered) of the sampler to collect different sizes and concentrations of deposited sediment under differing streambed conditions, which allowed appropriate correction factors to be applied to each of four categories of streambed particle size. Field trials comparing our sampler to other methods commonly used by many state and federal agencies showed high comparability. The sampler can be constructed in just a few hours from inexpensive, easily obtained materials.