平板玻璃行业环境影响评价中工程分析要点浅析

在对平板玻璃行业环境影响评价中的工程组成、一般特征和环境影响特征进行全面分析的基础上,详细分析了建设项目的工艺过程、物料平衡、水平衡及硫平衡等,计算污染物的产生量,制订相应的防治措施,并从行业准入条件及清洁生产角度分析了项目建设的可行性,为环境影响预测和评价提供所需基础数据,为项目的环境管理提供建议指标和科学数据。     

腈纶生产叉车作业区的作业条件危险性分析

运用作业条件危险性分析法对腈纶生产叉车作业区域危险性进行分析,根据分析结果,采取相应安全对策,降低作业区域危险程度,并进一步给出建议,以确保叉车作业安全。     

废弃液晶屏玻璃基板的行星式球磨工艺研究

以废弃液晶屏玻璃基板为原料,研究了球磨方式和球磨时间在球磨过程中对粉料粒径分布的影响。通过对废弃液晶屏玻璃基板的行星式球磨工艺的研究,探讨了球磨方式、球磨时间等因素对球磨效果的影响,以建立玻璃粉体细化的合理球磨方式和工艺参数。     

钢铁窑炉烟尘PM_(2.5)控制技术与装备

简述了国家863课题"钢铁窑炉烟尘PM_(2.5)控制技术与装备"的目的、意义和研究成果,介绍了细颗粒物预荷电技术、基于海岛纤维的表面超细过滤材料、预荷电袋滤器、"一阀多喷"清灰等技术的最新进展,通过示范工程的成功运行,验证了成果的先进性和实用性。研究成果将为工业窑炉烟尘细颗粒物深度净化提供技术和装备支撑,适用于新建除尘项目和除尘项目改造。     

“二级厌氧-微氧-好氧”组合工艺处理模拟碳纤维生产废水

对模拟碳纤维生产废水进行“厌氧-好氧”静态小试,根据COD的去除效果确定该碳纤维废水的可生化性。采用“二级厌氧-微氧-好氧”组合工艺进行动态中试,考察废水的处理效果及系统的抗冲击性能。试验结果表明：该工艺对碳纤维生产废水的处理效果较好;系统具有厌氧池出水pH增大的特点,且抗冲击能力较强;在厌氧池水温为28~38 ℃、好氧池水温不低于15 ℃、废水流量为100 L/h、进水COD为660 mg/L、进水ρ（氨氮）为4.9 mg/L的条件下,出水COD稳定在50 mg/L以下,ρ（氨氮）稳定在5 mg/L以下,能够满足GB 8978-1996《污水综合排放标准》的要求。     

填料型A2/O工艺污水处理及反硝化除磷效能

填料型A~2/O工艺是在A~2/O工艺的基础上通过向厌氧池、缺氧池、好氧池中投加醛化纤维式组合填料,将传统活性污泥法与生物膜法相结合组成一套脱氮除磷的新系统,文章对填料型A~2/O工艺与传统A~2/O工艺处理生活污水的效果进行了对比研究,以及对该复合式工艺在不同硝化液回流比下反硝化除磷能力进行了分析.研究结果表明,相同条件下,填料型A~2/O工艺对生活污水的处理效果要优于传统A~2/O工艺,分别使COD和氨氮的去除率达到92.5%和93.1%.试验通过增加硝化液回流比的措施使得反硝化聚磷菌在填料上富集程度增大,当硝化液回流比为300%时,缺氧池的NO-3-N浓度为3.03 mg·L~(-1),吸磷量最大为26.28 mg·L~(-1),胞内聚合物PHB代谢活性最好,利用率最高为1.32 g·g~(-1)·L~(-1).体现了填料型A~2/O工艺具有显著的反硝化除磷效果.     

Advanced treatment of wet-spun acrylic fiber manufacturing wastewater using three-dimensional electrochemical oxidation

A three-dimensional electrochemical oxidation(3D-EC) reactor with introduction of activated carbon(AC) as particle micro-electrodes was applied for the advanced treatment of secondary wastewater effluent of a wet-spun acrylic fiber manufacturing plant. Under the optimized conditions(current density of 500 A/m~2, circulation rate of 5 mL/min, AC dosage of 50 g, and chloride concentration of 1.0 g/L), the average removal efficiencies of chemical oxygen demand(COD_(cr)), NH3–N, total organic carbon(TOC), and ultraviolet absorption at 254 nm(UV_(254)) of the 3D-EC reactor were 64.5%, 60.8%, 46.4%, and 64.8%, respectively; while the corresponding effluent concentrations of COD_(cr), NH_3–N, TOC, and UV_(254) were 76.6, 20.1, and42.5 mg/L, and 0.08 Abs/cm, respectively. The effluent concentration of COD_(cr) was less than 100 mg/L, which showed that the treated wastewater satisfied the demand of the integrated wastewater discharge standard(GB 8978-1996). The 3D-EC process remarkably improved the treatment efficiencies with synergistic effects for COD_(cr), NH_3–N, TOC, and UV_(254) during the stable stage of 44.5%, 38.8%, 27.2%, and 10.9%, respectively, as compared with the sum of the efficiencies of a two-dimensional electrochemical oxidation(2D-EC) reactor and an AC adsorption process, which was ascribed to the numerous micro-electrodes of AC in the 3D-EC reactor. Gas chromatography mass spectrometry(GC–MS) analysis revealed that electrochemical treatment did not generate more toxic organics, and it was proved that the increase in acute biotoxicity was caused primarily by the production of free chlorine.     

An investigation of double-glass-covered trapezoidal salt-gradient solar pond coupled with reflector

In the present study, a trapezoidal salt-gradient solar pond (TSGSP) has been investigated experimentally. The top surface of solar pond has been covered with double-glass cover in order to reduce the evaporative and convective losses from the top. This results in increase of temperature even in the top zone of the solar pond and leads to more volume utilization for heat storage in the pond. A reflector made of aluminium sheet has been used to enhance the solar intensity on the solar pond during sunny hours. A procedure, to determine optimum tilt angle of reflector in order to utilize maximum amount of solar energy at noon, has been proposed. The use of reflector enhanced the average solar intensity on the top surface of solar pond by 22%. The maximum average temperature of trapezoidal solar pond with glass cover and reflector has been observed to be 70.5°C. The thermal efficiencies of LCZ, NCZ and UCZ for the trapezoidal solar pond with double-glass cover and reflector have been estimated to be 32.73%, 23.22% and 5.30%, respectively. In addition to experimental investigation, the sunny area ratio of TSGSP has been theoretically computed and compared with the cuboid solar pond having same top surface area and depth in order to see the effect of pond shape on sunny area ratio. The average yearly sunny area ratio of trapezoidal solar pond has been determined to be 11% higher than that of cuboid one.     

三维电极处理腈纶聚合废水的条件优化研究

采用填充粒状活性炭的三维电极处理腈纶聚合废水,考察实验条件对污染物去除效果的影响以及废水处理前后可生化性的变化.阳极为Ti/SnO₂-Sb₂O₃网状极板,阴极为网状钛电极,分别考察了停留时间、 电解电压、 pH值、 曝气量对废水中污染物去除效果的影响.结果表明,电解电压和pH值对废水有机物的去除率影响较大,在最优实验条件：电解电压为15V,pH值为3,曝气量400 mL/min的条件下电解120 min,腈纶聚合废水的COD、 TOC和丙烯腈的去除率分别为32.59%、 22.17%和89.70%,并且经过电解处理,废水BOD₅/COD值从0.02上升至0.42,可生化性显著提高,为生物处理提供了条件.     

超滤法处理回用印钞厂擦版液的研究

根据擦版液的特性,选择了适合处理擦版液的单皮层内压式中空纤维超滤膜,对超滤过程中的操作压力、料液温度、料液流速和固含量等工艺参数以及清洗药品和方法进行了研究。结果表明,当进口压力为0.17MPa,膜面流速在2,7m/s左右,循环液温度在40℃左右时,透水速度可达到50—60L(m.h)。操作过程中,只用透过液作简单清洗即可使透水速度得到较好的恢复。只有当透水速度衰减严重时,才在70℃条件下进行化学清洗,而且可以使透水速度得到较为彻底的恢复。化学清洗周期至少在1星期以上。