Risk-Based Prioritization of Air Pollution Monitoring Using Fuzzy Synthetic Evaluation Technique

Air pollution monitoring programs aim to monitor pollutants and their probable adverse effects at various locations over concerned area. Either sensitivity of receptors/location or concentration of pollutants is used for prioritizing the monitoring locations. The exposure-based approach prioritizes the monitoring locations based on population density and/or location sensitivity. The hazard-based approach prioritizes the monitoring locations using intensity (concentrations) of air pollutants at various locations. Exposure and hazard-based approaches focus on frequency (probability of occurrence) and potential hazard (consequence of damage), respectively. Adverse effects should be measured only if receptors are exposed to these air pollutants. The existing methods of monitoring location prioritization do not consider both factors (hazard and exposure) at a time. Towards this, a risk-based approach has been proposed which combines both factors: exposure frequency (probability of occurrence/exposure) and potential hazard (consequence).This paper discusses the use of fuzzy synthetic evaluation technique in risk computation and prioritization of air pollution monitoring locations. To demonstrate the application, common air pollutants like CO, NO_x, PM₁₀ and SO_x are used as hazard parameters. Fuzzy evaluation matrices for hazard parameters are established for different locations in the area. Similarly, fuzzy evaluation matrices for exposure parameters: population density, location and population sensitivity are also developed. Subsequently, fuzzy risk is determined at these locations using fuzzy compositional rules. Finally, these locations are prioritized based on defuzzified risk (crisp value of risk, defined as risk score) and the five most important monitoring locations are identified (out of 35 potential locations). These locations differ from the existing monitoring locations.     

Air Pollution and Heat Exposure Study in the Workplace in a Glass Manufacturing Unit in India

Air pollution in the workplace environment due to industrial operation have been found to cause serious occupational health hazard. Similarly, heat stress is still most neglected occupational hazard in the tropical and subtropical countries like India. The hot climate augments the heat exposure close to sources like furnaces. In this study an attempt is made to assess air pollution and heat exposure levels to workers in the workplace environment in glass manufacturing unit located in the State of Gujarat, India. Samples for workplace air quality were collected for SPM, SO₂, NO₂ and CO₂ at eight locations. Results of workplace air quality showed 8-hourly average concentrations of SPM: 165–9118 μg/m³, SO₂: 6–9 μg/m³ and NO₂: 5–42 μg/m³, which were below the threshold limit values of workplace environment. The level of CO₂ in workplace air of the plant was found to be in the range 827–2886 μg/m³, which was below TLV but much higher than the normal concentration for CO₂ in the air (585 mg/m³). Indoor heat exposure was studied near the furnace and at various locations in an industrial complex for glass manufacturing. The heat exposure parameters including the air temperature, the wet bulb temperature, and the globe parameters were measured. The Wet Bulb Globe Temperature (WBGT), an indicator of heat, exceeded ACGIH TLVs limits most of the time at all the locations in workplace areas. The recommended duration of work and rest have also been estimated.     

焦作市区大气污染状况与防治措施

根据“九五”期间焦作市区的大气污染监测资料，对市区大气污染状况进行了分析和评价，并对其成因进行了分析，提出了一些具体的防治措施。     

Preliminary air pollution monitoring in San Miguel, Buenos Aires

Passive diffusion samplers were employed in San Miguel(Buenos Aires Metropolitan Area) for a preliminary airpollution monitoring. The highest loads were observedin downtown, compared with an urban background site.Total suspended particulate matter (TSPM) varied from0.257 to 0.033 mg cm^-2 month^-1; dust was examinedfor particle nature and size distribution. A similartrend was observed for nitrogen dioxide (NO₂) andTSPM spatial distribution, suggesting that traffic isthe major pollution source. Sulphur dioxide (SO₂)values were low and rather homogeneous. Levels for theinvestigated pollutants are below EPA's guide linevalues. Geographic (flat area, near to Rio de LaPlata) and climatologic factors (rainfalls andvariable wind directions) contribute to disperse pollutants.     

Exposure Assessment to Mercury Vapor in Chloralkali Industry

The aim of the study was to develop a sampling method aimed at individual sampling of mercury vapor and subsequent individualexposure assessment of the worker. Hopcalite available fromInowrocawskie Zakady Chemiczne (in Poland) was founduseful for mercury vapor sampling in active and passive individual samplers. However the sampling rate determined forpassive sampler in steady-state laboratory chamber cannot be usedunder fluctuating conditions of mercury vapor concentration andair movement typical for field measurement. In order to check comparativeness of passive and active sampling methods, sampleswere taken in the same time and individual samplers fixed toworker's clothes were used. Mercury vapor concentration wasmeasured at two chloralkali industries in Poland and the resultswere presented. Excessive exposure in both industries wasconfirmed by finding elevated mercury concentration in urinesamples from the workers.     

Ambient Air Quality Monitoring Network Design for Assessing Human Health Impacts from Exposures to Airborne Contaminants

Existing methods of establishing ambientair quality monitoring networks typically evaluateonly parameters related to ambient concentrations ofthe contaminant(s) of interest such as emissionsource characteristics, atmospheric transport anddispersion, secondary reactions, depositioncharacteristics, and local topography. However,adverse health risks from exposures to airbornecontaminants are a function of the contaminant andthe anatomic and physiologic characteristics of theexposed population. Thus, ambient air qualitymonitoring networks designed for the protection ofpublic health or for epidemiological studiesevaluating adverse health impacts from exposures toambient air contaminants should account for bothcontaminant characteristics and human healthparameters. A methodology has been establishedwhich optimizes ambient air quality monitoringnetworks for assessments of adverse human healthimpacts from exposures to airborne contaminants byincorporating human health risk assessmenttechniques. The use of risk assessment techniquesas the basis for designing ambient air qualitymonitoring networks will help to target limitedfinancial and human resources to evaluate humanhealth risks from exposures to airbornecontaminants.     

A study on the orbit of air temperature movement

In this paper, we describe an air temperature movement by mapping its time series to the polar coordinates: the value of the time series is plotted on the radial coordinate and the time on the angular coordinate. In this way, both the yearly and daily air temperature movements from five different locations of China are used to demonstrate that, in an intuitionistic view, air temperature movement is neither random nor chaotic, but has its own orbit. We then propose an elliptic orbit model for the air temperature movement. Our proposed model provides quite good results when it is applied to the evaluation of yearly air temperature movements in eight locations in various parts of the world, and the evaluation of daily air temperature movements in five locations in Hunan Province of China on December 17, 2005. Results show that our approach provides a concise and helpful model for air temperature analysis.     

塔里木油田环境空气质量状况及评价

根据塔里木油田１９９３－１９９６年环境空气监测数据，对其环境空气质量状况进行了分析和评价。     

潜水含水层水位观测孔水位伪变化的观测与分析

结合CIRP试验场包气带的介质结构及渗透性特征，在S9孔进行了短期的孔中水位、孔口气压和温度测量，测量结果表明，观测孔水位波动与大气压变化有关，水位波动具有伪变化。水位伪变化对于试验场潜水位的监测有一定影响，因此，应对带有伪变化的水位观测结果进行必要的修正，以反映潜水位的真实动态。