ABR-MBR工艺处理生活污水实现短程硝化

采用ABR-MBR耦合工艺对MBR反应器中实现短程硝化的运行控制条件进行了研究,并为后续研究系统的反硝化除磷性能打下基础.ABR-MBR耦合工艺在不同条件下的运行研究结果表明,在ABR反应器的水力停留时间(hydraulic retention time,HRT)6 h,污泥回流比100%,硝化液回流比300%,温度30℃±2℃的条件下,通过控制好氧区溶解氧浓度(DO从0.5~1.0 mg·L~(-1)降为0.3~0.7 mg·L~(-1))以及改变MBR反应器有效容积以控制其HRT,最终在MBR反应器HRT从3 h逐步延长至5 h时短程硝化遭到破坏,亚硝酸盐积累率(nitrite accumulation rate,NAR)从60%急剧下降至15%.短程硝化影响因素的分析表明:pH值、游离氨(free ammonia,FA)和游离亚硝酸(free nitrous acid,FNA)对本试验实现短程硝化无显著影响,维持低DO浓度(0.3~0.7 mg·L~(-1))并逐步缩短HRT是本试验实现短程硝化的关键控制因素,温度和污泥停留时间(sludge retention time,SRT)可作为辅助因素与之共同调控.短程硝化期间,系统获得了高效且稳定的COD和NH_4~+-N去除效果,平均出水浓度分别低于50 mg·L~(-1)和2 mg·L~(-1),去除率均在90%以上,TN平均去除率高达72%.     

上向流厌氧滤池(UAF)处理城市生活污水的运行效能

采用上向流厌氧滤池(UAF)处理实际生活污水,研究中温条件下水力停留时间(hydraulic retention time,HRT)对系统运行效果及优势产甲烷菌群的影响.结果表明,在35℃,HRT为24 h条件下,系统启动28 d后化学需氧量(chemical oxygen demand,COD)去除率可达75%以上. HRT由24 h降至2. 5 h的过程中,COD去除率呈现先上升后下降的趋势,在HRT为5h时最高,平均去除率为81. 71%,最高可达87. 18%,当降至2. 5 h后,COD去除率降至75. 12%.甲烷产率(每消耗单位质量底物产生的甲烷的量,以CH4/CODre计)及甲烷体积分数随HRT的降低而增高,HRT为2. 5h时为0. 30 L·g-1,甲烷体积分数维持在73%左右,经能耗核算后可得系统产能可满足蠕动泵能耗需求.对系统内主要的产甲烷菌进行定量分析表明,乙酸营养型产甲烷菌Methanosarcinales丰度最高,为优势菌群,随着HRT的逐渐降低,乙酸营养型和氢营养型产甲烷菌的丰度都有大幅度提高.     

反应堆压力容器主螺栓水压试验拉伸量调整力学分析评价

目的针对某核电站反应堆压力容器主螺栓残余拉伸量与设计要求(1.63±0.03) mm有出入,个别测试数据不在设计要求范围内的情况,对出厂水压试验工况拉伸量验收值进行调整。方法考虑上述拉伸量偏差对螺栓载荷的影响,从应力、疲劳和密封角度展开系统分析,对螺栓、螺纹、连接法兰及反应堆压力容器密封性能分别进行详细的力学评价。结果根据评价结果,对出厂水压试验工况拉伸量验收值进行两次调整,最终确定为(1.68±0.03) mm。结论该机组反应堆压力容器出厂水压试验各项指标满足要求,针对上述拉伸量调整的力学评价合理性得到有效验证。     

水力负荷对生物沉淀池污染物净化性能的影响特性

本研究将生物转盘和平流式沉淀池设计理念相结合,开发出对水中致浊物质、有机组分、氨氮和总磷具有同步去除性能的一体式生物净化-沉淀池,考察了进水水力负荷对其污染物净化性能的影响规律.结果表明,在特定转盘转速和水质条件下,浊度、有机组分和氨氮的平均去除率随水力负荷的增大均呈先相对稳定后下降趋势,浊度和有机组分与氨氮平均去除率分别在0.036 g·(m~2·d)~(-1)与0.064 g·(m~2·d)~(-1)时达到最大.与浊度、有机组分和氨氮不同,水力负荷对总磷的去除效果影响较大,进水水力负荷在0.064 m~3·(m~2·d)~(-1)时,总磷平均去除率最差,适当减小或增大水力负荷,均有助于除磷过程的进行.进一步研究发现,硝化和除磷过程对水相中的有限碳源及溶解氧存在竞争关系.沿水流方向,盘片表面的微生物具有良好的种群配合和沿程分布特点,保证了在不利水力负荷条件下,工艺仍具有一定的去污效果,在微污染水体的强化净化处理中具有一定的应用前景.     

水力冲孔技术在大倾角薄煤层中的应用

针对矿井现有防突措施的不足,介绍了水力冲孔技术的设备、工艺流程及现场试验情况.研究表明,在大倾角薄煤层应用水力冲孔技术,可有效地消除激发突出的应力,大幅度地释放煤体中的瓦斯,能明显提高瓦斯的抽采效果,很好地起到了综合防突的作用,且石门揭煤周期缩短为2个月.     

液压振动台时域建模与仿真

基于Matlab/Simulink建立了液压振动台系统时域仿真模型,模型包括信号给定、油泵、溢流阀、蓄能器、伺服阀、控制器、液压缸、位移测量等模块。针对大流量动圈伺服阀,按物理规律和常见因素建模,特别考虑了瞬间油液回流情况。仿真算例结果表明,仿真获得的振动位移、速度、加速度响应波形及其他相关波形与实际振动台波形有良好的相似性。建模时考虑了尽可能多的因素,仿真获得了真实的波形特征,可为振动台系统设计提供较好参考。     

滨海生态景观河道对污水处理厂出水净化效果研究

为了探讨天津滨海泰达生态景观河道对污水处理厂出水深度净化的效果,2009年对该河道水体进行监测分析,结果表明该河道对氮、磷营养盐具有良好的可持续净化能力,河道出水达到景观环境用水的再生水水质标准,出水TN、NH3-N、TP和PO43-平均浓度分别为1.49mg/L、0.75mg/L、0.16mg/L和0.01mg/L,相应去除率分别达到93.38%、41.13%、88.09%和98.16%;沿程水体COD和TDS变化规律不明显,去除效果不理想;河道中端与出水端水体水质相近,建议在今后相似工程中可以适当提高河道式湿地的水力负荷。     

Hydraulic characteristics of an anaerobic baffled reactor as onsite wastewater treatment system

The feasibility of using anaerobic baffled reactor(ABR)as onsite wastewater treatment system was discussed.The ABR consisted of one sedimentation chamber and three up-flow chambers in series was experimented under different peak flow factors(PFF of 1 to 6),superficial gas velocities(between 0.6 and 3.1 cm/hr)and hydraulic retention times(HRT)(24,36 and 48 hr).Residence time distribution(RTD)analyses were carried out to investigate the hydraulic characteristics of the ABR.It was found that the PFF resulted in hydraulic dead space.The dead space did not exceed 13% at PFF of 1,2 and 4 while there was 2-fold increase(26%)at PFF of 6.Superficial gas velocities did not result in more(biological)dead space.The mixing pattern of ABR tended to be a completelymixed reactor when PFF increased.Superficial gas velocities did not affect mixing pattern.The effects of PFF on mixing pattern could be minimized by higher HRT(48 hr).The tank-in-series(TIS)model(N=4)was suitable to describe the hydraulic behaviour of the studied system.The HRT of 48 hr was able to maintain the mixing pattern under different flow patterns,introducing satisfactory hydraulic efficiency.Chemical oxygen demand(COD)and total suspended solids(TSS)removals under all flow patterns were achieved more than 85% and 90%,respectively.The standard deviation of effluent COD and TSS concentration did not exceed 15 mg/L.     

Effects of operational factors on soluble microbial products in a carrier anaerobic baffled reactor treating dilute wastewater

The effects of feed strength,hydraulic residence time(HRT),and operational temperatures on soluble microbial product(SMP) production were investigated,to gain insights into the production mechanism.A carrier anaerobic batfled reactor (CABR) treating dilute wastewater was operated under a wide range of operational conditions,namely,feed strengths of 300-600 mg/L,HRTs of 9-18 h,and temperatures of 10-28℃.Generally, SMP production increased with increasing feed strength and decreasing temperature.At high temperature (28℃),SMP production increased with decreasing HRT. As the temperature Was decreased to 18 and 10℃.the SMP production was at its peak for 12 h HRT Therefore,temperature could be an important determinant of SMP production along with HRT. A higher SMP to soluble chemical oxygen demand (SCOD) ratio Was found at high temperature and long HRT because of complete volatile fatty acid degradation.SMP accounted for 50%-75% of the SCOD in the last chamber of the CABR.As a secondary metabolite.some SMP could be consumed at lower feed strength.     

Hydraulic model for multi-sources reclaimed water pipe network based on EPANET and its applications in Beijing, China

Water shortage is one of the major water related problems for many cities in the world. The planning for utilization of reclaimed water has been or would be drafted in these cities. For using the reclaimed water soundly, Beijing planned to build a large scale reclaimed water pipe networks with multi-sources. In order to support the plan, the integrated hydraulic model of planning pipe network was developed based on EPANET supported by geographic information system (GIS). The complicated pipe network was divided into four weak conjunction subzones according to the distribution of reclaimed water plants and the elevation. It could provide a better solution for the problem of overhigh pressure in several regions of the network. Through the scenarios analysis in different subzones, some of the initial diameter of pipes in the network was adjusted. At last the pipe network planning scheme of reclaimed water was proposed. The proposed planning scheme could reach the balances between reclaimed water requirements and reclaimed water supplies, and provided a scientific basis for the reclaimed water utilization in Beijing. Now the scheme had been adopted by Beijing municipal government.