Calculation of Entrainment in Density Jumps

The density jump in a two-layer channel flow of miscible fluids, in which one of the layers is infinitely deep and at rest, is analyzed using the momentum flux and mass flux conservation equations. The analysis yields simple equations relating the heights upstream and downstream of the jump with the upstream Froude number and the rate of entrainment into the moving layer, as well as a relation between the maximum possible entrainment and the upstream Froude number. The analysis also shows that when the flow down-stream of the jump is controlled by an obstruction or a contraction, the entrainment rate into the jump depends solely on the dimensionless obstruction height contraction ratio and the upstream Froude number.     

污水排海工程的扩散器水力设计与模型试验研究

通过SZ36-1油田二期终端污水排海工程扩散器的水力设计，比较了扩散器的水力设计的两种计算方法，对水力计算中有关参数及局部阻力系数进行了选用，并通过模型试验进行了验证。表明所用计算方法及其结果是可信的，阻力系数的选取是合适的。     

EVALUATION OF STORMSEWER CONTROL ALGORITHMS USING A TRANSIENT MIXED FLOW MODEL1

ABSTRACT: a hydraulic transient model that is capable of simultaneously modeling open channel and pressurized flows is used to study active control of a deep tunnel stormwater collection system. The simultaneous occurrence of open channel flow and pressurized flow is termed mixed flow. This paper demonstrates the application of a mixed flow hydraulic model to the development of an active control scheme. It is shown that dynamic conditions can exist in a storm sewer system even under moderate inflow conditions and that these conditions, particularly at the time of full system pressurization, can influence the operation of the dynamic control, so that accurate hydraulic modeling is essential to proper control formulation.     

ALTERNATIVE APPROACH TO THE FORMULATION OF BASIN HYDRAULIC GEOMETRY EQUATIONS1

ABSTRACT: Along a drainage network, there is a systematic variation of average flow parameters (width, depth, and velocity) at flows having the same flow duration. Hydraulic geometry equations mathematically express this interdependent relationship of stream-flow characteristics for a basin for annual flow durations varying from 10 to 90 percent. However, the equations proposed so far have had rather poor predictive performance for low flows. An independent investigation of the variation of discharge with drainage area and annual flow duration demonstrates a consistent relationship between these parameters. The relationship for the high to median-flow range differs, however, from that for the median— to low-flow range. The proposed equations provide a better predictive performance for low flows than previous formulations and a versatile means of estimating flow parameters for streams throughout a basin. The improved basin hydraulic geometry equations have a wide range of applications in areas such as stream habitat assessment, water quality modeling, channel design, and stream restoration projects.     

MODELING PERCOLATION LOSSES FROM A PONDED FIELD UNDER VARIABLE WATER-TABLE CONDITIONS1

ABSTRACT: A numerical simulation model was developed to predict the vertical and lateral percolation losses from a ponded agricultural field. The two-dimensional steady-state unsaturated/ saturated flow equation was solved using the finite-difference technique. A constant ponding depth was maintained at the soil surface with different water table conditions in an application of the model for rice fields bordered by bunds. Field experiments were conducted for two different water table depths to collect data on the spatial distribution of volumetric soil-moisture content for model verification. The measured soil-moisture content values were found to be in close agreement with those predicted by the model. The sensitivity analysis of the model with selected hydrologic conditions shows that the model is most sensitive to the values of saturated hydraulic conductivity, but relatively less sensitive to water table depth, ponding depth, and evaporation rate from the soil surface. It implies that, in a ponded rice field condition, the lateral and vertical percolation losses are mostly governed by the hydraulic conductivity of the soil. The vertical percolation losses were almost equal to the saturated hydraulic conductivity values and, in most cases, these losses increased with deeper water table depths. The lateral percolation losses also increased with deeper water table depths; however, these losses were relatively small in comparison to the vertical percolation losses. The vertical and lateral percolation losses increased with the increase in ponding depths. The lateral percolation losses through the bund decreased when the evaporation losses increased from the soil surface. The results of this study indicate that the percolation losses from a ponded field may be predicted accurately for a wide range of soil and hydrological conditions when the values of hydraulic conductivity, evaporation rate, depth of ponding, and water table depth are accurately known.     

对水工构筑物设计的几点看法

探讨了水工构筑物设计中的地下水位确定、伸缩缝设置、总体布置及设计与施工配合等问题。设计在满足国家有关政策、规范要求的同时,要做到技术先进、安全适用、经济合理。     

水力喷淋式凉水塔在初冷循环冷却水系统中的应用

介绍了喷淋式凉水塔结构、工作原理及冷却效果的影响因素.与机械通风式凉水塔的冷却效果比较表明,该凉水塔具有冷却效率高、运行成本低、操作简单等优点,值得推广应用.     

水雾灭火系统的设计

以自备发电机房的灭火设计为例,介绍了水雾灭火系统的实现方法和设备选型步骤,提出提高水雾灭火系统的实现方法和设备选型步骤,提出提高水雾灭火系统的性能和灭火效率,有赖于火灾科学基础研究的积累和突破。     

絮凝DAF中试工艺处理密云水库低温低浊水的影响因素

系统研究以硫酸铝和聚铝为絮凝剂时絮凝-DAF工艺中的水力学参数对除浊率的影响 .结果表明聚铝表现出了更优越的参数值 .在凝聚段 ,聚铝需要的高速混合时间为 15s,而硫酸铝则为 30s以上 ,2者对混合强度的要求为G=300～1000s^-1.聚铝的絮凝反应时间为 5.0min以上 ,硫酸铝为 7.5min以上 ,而且搅拌强度范围平均G值 =40～140s^-1;确定合适的总平均GT值≥2×10⁴.当应用聚铝为絮凝剂时 ,可以采用两级或三级等速搅拌 .对于仿MJ型的释放器 ,在实验的范围内释气压力为 2.5～3.3kg/cm² 时 ,5.0 %～8.3%的回流比较合适 .气浮接触区的水力条件和停留时间对絮凝气浮的除浊效果有较大的影响 .