利用粉煤灰研制高效无机混凝剂聚硅酸铝

研究了以粉煤灰为原料制取高效无机混凝剂聚硅酸铝的工艺及生产条件。产品用于处理工业废水水样 ,并与传统混凝剂处理废水的效果进行了比较。结果表明 ,聚硅酸铝混凝剂用药量少 ,处理效果较好     

Effects of metal cations on sorption-desorption of p-nitrophenol onto wheat ash

The mutual e ects of metal cations (Cu2+, Pb2+, Zn2+, and Cd2+) and p-nitrophenol (NP) on their adsorption desorption behavior onto wheat ash were studied. Results suggested that Cu2+, Pb2+, and Zn2+ diminished the adsorption and increased the desorption of NP remarkably, while Cd2+ had no such e ect. In contrast, NP diminished the adsorption of Cu2+, Pb2+, and Zn2+ onto ash, however, this suppression e ect depended on the initial concentrations of metal cations. NP had no e ect on Cd2+ adsorption on ash. Fourier transform infrared (FT-IR) and X-ray absorption spectroscopic (XAS) studies suggested the following mechanisms responsible for the metal suppression e ect on NP adsorption: (1) large hydrated Cu2+, Pb2+, and Zn2+ shells occupied the surface of ash and prevent nonspecific adsorption of NP onto ash surface; (2) Cu2+, Pb2+, and Zn2+ may block the micropores of ash, resulting in decreased adsorption of NP; (3) complexation of Cu2+, Pb2+, and Zn2+ was likely via carboxyl, hydroxylic and phenolic groups of wheat ash and these same groups may also react with NP during adsorption. As a “soft acid”, Cd2+ is less e cient in the complexation of oxygencontaining acid groups than Cu2+, Pb2+, and Zn2+. Thus, Cd2+ had no e ect on the adsorption of NP on wheat ash.     

垃圾焚烧炉飞灰的低温玻璃固化初步研究

在研究我国城市生活垃圾焚烧炉飞灰的毒性特征和高温灼烧特性的基础上，试验了几种常用玻璃熔制助溶剂、烟气净化产物中的成分对飞灰的溶融温度和熔融减量的影响，以实现低温玻璃固化。实验发现受热温度越高、时间越长，飞灰减量越大；B2O3、硼砂、CaF2对飞灰助溶效果明显，而废玻璃、CaO、CaCl2能使悄灰溶融后形成的玻璃态物质地均匀、少孔。按一定比例同时加入硼砂、CaF2、废玻璃、CaO、CaCl2于飞灰中，混合物的熔融温度降到1000℃以下，大大低于飞灰自身的熔融温度（1200℃）。对该熔融物在空气中淬火形成的玻璃态物质按标准方法浸沥，选择测量了浸出液中铅、汞、镉、砷的浓度，初步发现低温玻璃态物质对重金属铅和镉具有较好的固化效果，而对汞有砷的固化效果尚不确定。     

Metal distribution characteristic of MSWI bottom ash in view of metal recovery

Bottom ash is the major by-product of municipal solid waste incineration(MSWI), and is often reused as an engineering material, such as road-base aggregate. However, some metals(especially aluminum) in bottom ash can react with water and generate gas that could cause expansion and failure of products containing the ash; these metals must be removed before the ash is utilized. The size distribution and the chemical speciation of metals in the bottom ash from two Chinese MSWI plants were examined in this study, and the recovery potential of metals from the ash was evaluated. The metal concentrations in these bottom ashes were lower than that generated in other developed countries. Specifically, the contents of Al,Fe, Cu and Zn were 18.9–29.2, 25.5–32.3, 0.7–1.0 and 1.6–2.5 g/kg, respectively. Moreover,44.9–57.0 wt.% of Al and 55.6–75.4 wt.% of Fe were distributed in bottom ash particles smaller than 5 mm. Similarly, 46.6–79.7 wt.% of Cu and 42.9–74.2 wt.% of Zn were concentrated in particles smaller than 3 mm. The Fe in the bottom ash mainly existed as hematite, and its chemical speciation was considered to limit the recovery efficiency of magnetic separation.     

关于医疗垃圾飞灰中二噁英在惰性气氛下的低温热脱附研究

以医疗垃圾焚烧炉布袋除尘器前管道内飞灰(BG)及布袋除尘器后飞灰(AG)为对象,研究不同温度及时间段下其在管式炉中的热脱附特性.结果表明,在低温氮气气氛下,热脱附作用较为明显,2种飞灰中的二噁英都有了不同程度的脱除,其中布袋前飞灰中二噁英的脱除率为82.9%～99.9%之间,毒性当量脱除率为77.3%～99.8%,布袋后飞灰中二噁英的脱除率为66.8%～99.8%之间,毒性当量脱除率为43.5%～99.6%.检测收集到的实验尾气,发现了二噁英的存在,且在300～350℃这个温度段生成量最多,且生成的有毒二噁英同系物中以OCDD为主.通过比较发现,当温度为400℃,加热时间为45 min时2种飞灰中的二噁英脱除效率最高.鉴于惰性气氛下的热脱附对处理飞灰中的二噁英具有较好的作用,可将其大规模应用于实际工程中.     

氨对垃圾焚烧飞灰浸出特性的影响及地球化学模拟

垃圾焚烧飞灰可能因为选择性非催化还原法(SNCR)脱硝过程中氨泄漏、垃圾携带的渗滤液受热挥发等原因而吸附氨.本研究中采用人为添加氨水,在pH为3.66～12.44范围内,研究氨对飞灰中溶解性有机碳(DOC)和重金属浸出的影响,并利用地球化学模拟软件Visual MINTEQ从金属化学形态分布上分析氨对飞灰浸出的影响机制.结果表明,DOC在pH>9和有高浓度氨(≥1 357 mg·L-1)存在时,其浸出量大幅增加,而在浸出液中氨的水平不高于537 mg·L-1时则受氨的影响很小;在pH<6时,飞灰中各金属主要以自由态的金属离子和金属-氯络离子形态大量溶出,且受氨的影响较小;而在pH为8～12的碱性环境中和氨浓度较高时(≥3 253 mg·L-1),氨与金属生成了可溶性的金属-氨配合物,能显著增加Cd、Cu、Ni、Zn的浸出,且在pH=9附近时浸出量达到最大值,但氨对Al和Pb的浸出影响甚微;在pH>12时,Cd、Cu、Ni、Zn主要以羟基金属离子形式存在.在氨浓度为3 253 mg·L-1时,通过利用Visual MINTEQ模拟浸出值与试验数据的对比,发现Al、Pb、Zn的浸出主要由溶解/沉淀模型控制,而Cd、Cu、Ni由溶解/沉淀模型和表面吸附反应模型同时控制,且Visual MINTEQ模型能较好地预测飞灰中Al、Cu、Pb、Zn的浸出特性.     

高碱性烟气脱硫灰中亚硫酸钙含量分析方法

针对烟气脱硫灰中的亚硫酸钙含量测定方法没有国家标准和行业标准,在参考不同标准中亚硫酸盐的测定方法基础上,对碘量法测定烟气脱硫灰中亚硫酸钙含量的方法进行实验研究。通过自制烟气脱硫灰模拟样的滴定,结果表明高碱性脱硫灰在滴定前应采用先加碘后加酸的顺序进行处理,并使用盐酸或磷酸作为酸化剂,而不宜使用硫酸酸化;采用磷酸(1+1)作酸化剂,控制溶液pH值在2.49¹.40之间,可以准确测定高碱性烟气脱硫灰中亚硫酸钙含量,重复性好,同时可有效避免Fe3+干扰。     

采用巯基捕收剂稳定化处理垃圾焚烧飞灰中的重金属

研究了3种巯基捕收剂,二乙基二硫代氨基甲酸钠（乙硫氮）、乙基黄原酸钾（乙基黄药）和二丁基二硫代磷酰铵（丁铵黑药）,对垃圾焚烧飞灰中重金属的稳定化效果。3种巯基捕收剂的用量均为62.5μmol?g-1飞灰。扫描电镜观察发现,飞灰经稳定化处理后,巯基捕收剂均匀地覆盖于飞灰晶体表面,使矿物晶体棱角变得模糊。利用酸浸提程序（TCLP法）和水浸提程序（水平振荡法）评价飞灰中重金属Cu、Pb、Cd、Cr和Zn的浸出毒性。在0.1mol?L-1醋酸浸提条件下,与Na2S相比,巯基捕收剂对Cu和Pb的稳定化效果较好,其中乙硫氮对Cu的稳定化比率接近100%,丁铵黑药对Pb的稳定化比率达到69.2%;在水浸提条件下,乙硫氮、乙基黄药和丁铵黑药对5种重金属的稳定化比率分别为72.6%、73.5%和76.8%,显著高于Na2S处理（52.4%）。三种巯基捕收剂对5种重金属亲和力的强弱顺序大致为Cu＞Pb＞Cr＞Cd＞Zn,并且超过60%的巯基捕收剂与酸可浸提重金属离子发生了螯合沉淀反应。重金属-巯基捕收剂絮凝物在中性和碱性条件下（pH>6）比较稳定,在酸性条件下（pH<6）可发生部分溶解。为获得较好的重金属稳定化效果,维持稳定化飞灰的高酸缓冲容量十分重要。     

粉煤灰对混合染料的吸附性能研究

以燃煤废弃物粉煤灰作为吸附剂,对活性红23和分散蓝56混合染料溶液进行吸附性能研究.实验结果表明:粉煤灰优先吸附离子型的活性染料,混合溶液中对活性红23的吸附能够在30 min达到平衡,而对分散蓝56的吸附则需要150 min才能够达到平衡,吸附动力学符合准二级吸附模型.在弱酸性环境中粉煤灰对分散染料的脱色高于碱性环境...     

垃圾焚烧飞灰中二噁英削减技术研究

二噁英(PCDD/Fs)是多氯代二苯并二噁英和多氯代二苯并呋喃的总称,因具有生物蓄积性、高毒性、难降解等特点而备受关注。垃圾焚烧是二噁英的重要来源,而其中超过50%的二噁英以飞灰形式排出。文章综述了热分解法、光降解法、机械化学法、生物降解法等飞灰二噁英毒性削减技术的国内外研究进展,并在此基础上对飞灰二噁英削减技术研究和管理提出了建议。