Arsenic contamination in the Kanker district of central-east India: geology and health effects

This paper identifies newer areas of arsenic contamination in the District Kanker, which adjoins the District Rajnandgaon where high contamination has been reported earlier. A correlation with the mobile phase episodes of arsenic contamination has been identified, which further hinges on the complex geology of the area. Arsenic concentrations in both surface and groundwater, aquatic organisms (snail and water weeds) soil and vegetation of Kanker district and its adjoining area have been reported here. The region has been found to contain an elevated level of arsenic. All segments of the ecoysystem are contaminated with arsenic at varying degrees. The levels of arsenic vary constantly depending on the season and location. An analysis of groundwater from 89 locations in the Kanker district has shown high values of arsenic, iron and manganese (mean: 144, 914 and 371 μg L⁻¹, respectively). The surface water of the region shows elevated levels of arsenic, which is influenced by the geological mineralised zonation. The most prevalent species in the groundwater is As(III), whereas the surface water of the rivers shows a significant contamination with the As(V) species. The analysis shows a bio-concentration of the toxic metals arsenic, nickel, copper and chromium. Higher arsenic concentrations (groundwater concentrations greater than 50 μg L⁻¹) are associated with sedimentary deposits derived from volcanic rocks, hence mineral leaching appears to be the source of arsenic contamination. Higher levels of arsenic and manganese in the Kanker district have been found to cause impacts on the flora and fauna. A case study of episodic arsenical diarrhoea is presented.     

电解浮选用于活性污泥固液分离的研究

在装有Ti/RuO₂-IrO₂-TiO₂阳极、Ti阴极的电解浮选槽中进行了活性污泥固液分离的研究.考察了影响电解浮选性能的操作参数,这些参数包括水力停留时间、电流密度、进水SS浓度和进水pH值.研究表明,电解浮选是高效的固液分离单元,水力停留时间和电流密度是主要的影响因素.SS的去除率随着水力停留时间和电流密度的增加而增大;污泥负荷增加,SS的去除率下降;pH值影响电解产生微气泡的尺寸和污泥性质,但对SS的去除影响不大,实际应用中可以不调节pH值.进水SS约1 000mg/L时,当水力停留时间为20min,接触室电流密度为5 mA/cm²,分离区电流密度为2.5 mA/cm²,SS的去除率可达97%以上,此时的能耗为0.4～0.5(kW.h)/m³废水.电解浮选产生的浮渣含水率为95.9%,低于溶气气浮和二沉池的污泥含水率,对污泥减量化及其最终处置有较大的意义.     

基于微生物相互作用机理的完全耦合活性污泥模型研究

根据微生物生长机理,推导出微生物的耦合作用机理并在该机理的基础上改进了ASM3 Bio-P模型.假设活性污泥系统中有机物氧化过程、生物硝化过程、生物反硝化过程、生物除磷过程可同时存在,在ASM3 Bio-P模型上添加相关的开关函数,推导出完全耦合活性污泥模型(FCASM).基于计算机程序进行数值模拟,并将FCASM模拟结果与实测值以及ASM3 Bio-P模型模拟值进行对比.结果表明,完全耦合活性污泥模型对氨氮模拟的稳态出水值为1.90 g·m-3,ASM3 Bio-P模型模拟的氨氮稳态出水值为0 g·m-3,而实测的氨氮稳态出水值为1.50 g·m-3,完全耦合活性污泥模型的结果更接近真实值.     

煤燃烧过程中有机钙固氟效果研究

选择醋酸钙镁、醋酸钙2种有机钙为固氟剂,在固定床管式炉上对它们的固氟效果进行了初步研究,并分析了粒径、温度、钙硫比等对试验结果的影响.通过与传统固氟剂碳酸钙的固氟效果进行比较发现:在相同实验条件下,这2种有机钙具有良好的固氟效果,高温阶段效果更加明显,温度为1 000～1 100℃时,醋酸钙镁的固氟率是碳酸钙的1.68～1.74倍,醋酸钙的固氟率为碳酸钙的1.28～1.37倍.     

理化因素对锰细菌Arthrobacter chlorophenolicus MN1409氧化Mn2+的影响

Arthrobacter chlorophenolicus MN1409是1株分离自锰矿样品的高效锰氧化细菌。为了建立该菌株氧化Mn2+的适宜条件,研究了接种量、装液量、摇床转速、温度、pH值、Fe2+初始质量浓度和Mn2+初始质量浓度等理化因素对其锰氧化效率的影响。结果表明,接种量、装液量、转速和Mn2+初始质量浓度在一定范围内变化对锰氧化率影响不大;而温度、pH值和Fe2+初始质量浓度变化对锰氧化率有较大影响。当接种量为4%,装液量为60 mL,温度为25℃,摇床转速为100r/min,pH值为7,且有一定的Fe2+存在时,Arthrobacter chlorophenolicusMN1409对锰的氧化效率最高。     

Effects of cultivation strategies on the cultivation of Chlorella sp. HQ in photoreactors

Heterotrophic cultivation caused high level of ROS and high lipids accumulation. HMTC is the best culture strategy for improving the microalgal biomass. Chlorella sp. HQ had great nutrient removal capacity under five culture strategies. The effects of cultivation strategies (including autotrophic cultivation (AC), heterotrophic cultivation (HC), fed-batch cultivation (FC), heterotrophic+ autotrophic two-stage cultivation (HATC), and heterotrophic+ mixotrophic two-stage cultivation (HMTC)) on the growth and lipid accumulation of Chlorella sp. HQ and its total nitrogen (TN) and total phosphorus (TP) removal in secondary effluent were investigated in column photoreactors. The results showed that the TN and TP removal rates ranged between 93.72%–95.82% and 92.73%–100%, respectively, under the five different strategies. The microalgal growth potential evaluated by the maximal growth rate (R_max) was in the order of HMTC>HC>FC>AC>HATC. The values of biomass, total lipid yield, triacylglycerols (TAGs) yield, and total lipid content of the microalga cultivated in the last 5 d increased significantly, but the TAGs productivities of the five strategies were lower than those in the first 7 d. Compared with all the other cultivation strategies, the TAGs productivity and yield after 12 d of cultivation under the heterotrophic condition reached the highest values accompanying the highest level of intracellular reactive oxygen species (ROS), in which the TAGs yield reached 40.81 mg/L at the end of the cultivation period. The peaks in TAGs yield and ROS level suggested that HC was beneficial for lipids accumulation via regulating the cellular redox status and exerting ROS stress on microalgal cells. In summary, HMTC was the best cultivation strategy for improving the microalgal biomass and HC was the best strategy for microalgal TAGs accumulation to produce biodiesel.     

Recovery of Ni(II) from real electroplating wastewater using fixed-bed resin adsorption and subsequent electrodeposition

Resin adsorption and subsequent electrodeposition were used for nickel recovery. Treated wastewater can meet the Electroplating Pollutant Discharge Standard. The spent resin is completely regenerated by 3 BV of 4% HCl solution. 95.6% of nickel in concentrated eluent was recovered by electrodeposition. Effective recovery of high-value heavy metals from electroplating wastewater is of great significance, but recovering nickel ions from real electroplating wastewater as nickel sheet has not been reported. In this study, the pilot-scale fixed-bed resin adsorption was conducted to recover Ni(II) ions from real nickel plating wastewater, and then the concentrated Ni(II) ions in the regenerated solution were reduced to nickel sheet via electrodeposition. A commercial cation-exchange resin was selected and the optimal resin adsorption and regeneration conditions were investigated. The resin exhibited an adsorption capacity of 63 mg/g for Ni(II) ions, and the average amount of treated water was 84.6 bed volumes (BV) in the pilot-scale experiments. After the adsorption by two ion-exchange resin columns in series and one chelating resin column, the concentrations of Ni(II) in the treated wastewater were below 0.1 mg/L. After the regeneration of the spent resin using 3 BV of 4% (w/w) HCl solution, 1.5 BV of concentrated neutral nickel solution (>30 g/L) was obtained and used in the subsequent electrodeposition process. Using the aeration method, alkali and water required in resin activation process were greatly reduced to 2 BV and 3 BV, respectively. Under the optimal electrodeposition conditions, 95.6% of Ni(II) in desorption eluent could be recovered as the elemental nickel on the cathode. The total treatment cost for the resin adsorption and regeneration as well as the electrodeposition was calculated.     

Subcritical water oxidation of propham by H2O2 using response surface methodology (RSM)

This study was conducted to investigate the degradation of propham, which is a compound that pollutes water and seriously threatens human health, by subcritical water oxidation and using H₂O₂ as an oxidising agent. The maximum total organic carbon removal rate of propham was obtained as 73.65% at 40 min of treatment time and 60 mM of H₂O₂ concentration and 373 K of temperature. In addition, response surface method based on the Box-Behnken design was applied to design the degradation experiments of propham for determination of the combined effects of process variables, namely temperature, concentration of oxidising agent and treatment time. The proposed quadratic model of propham degradation, which was examined with the analysis of variance, was used for navigating the design space. The R² and adjusted R² values of the model were determined as 0.9921 and 0.9819 respectively. It was shown that propham was effectively degraded, thus could be removed from the water by using an environmentally friendly method.     

聚合氯化铝铁絮凝剂的性能研究

煤矸石是采煤过程之废料。本文利用煤矸石制备出了聚合氯化铝铁（ＰＡＦＣ）：一种新型无机高分子絮凝剂，探讨了Ｆｅ＾３＋的稳定性与溶液离子强度之间的关系，发现溶液的离子强度越大，则产生Ｆｅ（ＯＨ）３沉淀时的ＰＨ越高。研究了ＰＡＦＣ水解产物的ζ电位及絮凝效果随ＰＨ的变化情况，比较了ＰＡＦＣ、ＰＡＣ和ＰＦＳ的除浊性能，ＰＡＦＣ在ＰＨ为７．０－８．２范围内除浊效果最佳，ＰＡＦＣ的除浊效果优于ＰＡＣ。     

快速渗滤土地处理系统对城市生活污水中N、P去除的优化研究

为了探索城市生活污水中N、P去除，在实验室内采用混合土为介质，以均匀设计原理为指导，进行模拟人工快速渗滤系统对城市生活污水中N、P的去除。研究不同介质配比，淹水时间，湿干比3种因素组合对污水处理的最优运行模式。试验结果表明：通过选取混合土为介质及以上3个参数是可行的；通过回归统计得出最优模型。