典型危险废物的工程力学特性

掌握填埋废物的工程力学特性是确保危险废物填埋堆体稳定性的重要前提条件,因此,针对6种典型危险废物的工程力学特性开展了调查研究.研究结果表明,污泥类危险废物的含水率和有机质含量远高于非污泥类危险废物,而前者的比重则显著低于后者.污泥类危险废物的渗透系数相对较小,比污染土壤和飞灰炉渣混合物的渗透系数小1个数量级,比滤池填料的渗透系数小2个数量级.不同危险废物的无侧限抗压强度排序为:飞灰炉渣混合物(314.3 kPa)和滤池填料(278.9 kPa)＞污染土壤(124.9 kPa)＞杭州氧气厂污泥(68.6 kPa)、锌铬污泥(71.4 kPa)、油泥(58.4 kPa).不同危险废物的粘聚力排序为:飞灰炉渣混合物(40.8 kPa)、滤池填料(31.1 kPa)＞污染土壤(20.9 kPa)＞杭州氧气厂污泥(1.94kPa)、锌铬污泥(3.10 kPa)、油泥(1.81 kPa).此外,不同危险废物的内摩擦角差异相对较小,其变化范围在18.8°～35.0°之间.综合分析可知,飞灰炉渣混合物和滤池填料的工程力学特性较好,而污泥类危险废物的工程力学特性则较差.     

叠式空气隙膜蒸馏组件膜污染实验研究

采用一种具有旋流结构的多层层叠式空气隙膜蒸馏膜组件,以20 g/L氯化钠盐水为热工质,考察在70℃条件下膜污染情况,实验结果表明,一个周期的连续运行和间歇性操作膜表面在高温下较快进入膜污染,8个周期后膜通量下降为初始通量的42%。膜表面有大量黄色附着物,电镜SEM分析显示,膜表面被不均匀堆积的颗粒状污染物及长方体结晶物覆盖,能谱EDS分析,污染物有极少量NaCl结晶的Na、Cl元素,还有O、C、Mg、Cu和Fe等元素。污染膜经5%盐酸溶液清洗后无机垢沉淀被去除,表观效果较好。     

不同纳米修复剂对污染土壤中胡萝卜吸收、转运Cd的影响

通过盆栽实验研究不同纳米修复剂(羟基磷灰石HAP、赤泥RM、Fe3O4、胡敏酸-Fe3O4)对2种不同污染土壤Cd吸收、转运的影响。结果表明,上述纳米修复剂均可显著增加胡萝卜植株生物量,显著提高植株Cd胁迫的耐受指数;不同土壤施用不同纳米修复剂均显著降低胡萝卜植株Cd的含量,并且随着修复剂施加浓度的增加而显著降低;与对照相比,植株茎叶Cd含量最大降低达78.8%,根中Cd的含量最大降低67.8%;添加不同修复剂能不同程度地降低了土壤中Cd的转运系数和富集系数,这可能与施用不同纳米修复剂促进了土壤中非残留态Cd向残留态Cd的转化有关,总体而言,不同纳米型修复剂对降低Cd的有效性顺序为:RM～HAP>胡敏酸-Fe3O4>Fe3O4。     

臭氧微气泡深度处理染料废水生化出水

采用臭氧氧化法对某厂染料废水生化出水进行深度处理,考察了废水初始pH值和臭氧气泡大小对废水处理效果的影响,研究了臭氧微气泡对气液传质的影响。结果表明,在pH 2.5~11范围内,废水初始pH值越大,处理效果越好;加载微孔膜片后,臭氧气泡粒径变小,增大了臭氧的传质比表面积,延长了臭氧气泡在反应柱内的停留时间,强化了传质效果,处理废水的臭氧利用率可增大10%~30%,强化了臭氧氧化作用。加载5 μm孔径的膜片相比无膜片的情况,COD去除率提高了近30%,TOC去除率提高了16%。     

分散填料曝气塔多相流态分析与传氧性能表征

针对分散填料曝气塔中多相流的流态与传氧过程,实验了布气方式以及海绵和陶粒2种填料对于体系的气含率εg、流态以及气-液传质性能的影响。在表观气速U范围(0.01～0.18 m/s)内观察到81孔布气板(Φ1 mm)体系出现3个明显相区,孔数过少(25孔),或者孔间距较小(225孔)均没有明显过渡区,在湍流区(U>0.118 m/s)3种布气板的气含率没有明显差别。海绵填料体积分数εs<25%时体系的气含率没有明显变化,35%时气含率下降且过渡区提前出现。在非均相区,海绵填料明显提高了体系的传质系数KLa。陶粒填料降低了气含率,固含率对εg的影响差别不明显,同时降低了多相流体系的KLa,且随着固含率的增加KLa降低。对比多种操作条件,单位体积空气传氧能力KLa/εg无明显差别,但在81孔布气板的过渡区KLa/εg出现一个明显的极小区间,说明过渡区传氧效率较低。在特定的实验操作条件下,KLa/εg较为稳定,这为深入理解两种气泡群体的共存体系在传氧性能方面各自的权重,提供了重要的量化参考。     

Pilot scale application of a method for the analysis of perfluorinated compounds in surface soils

A growing number of studies now indicate that perfluorinated compounds (PFCs) are globally distributed in the environment. Their widespread distribution and presence in remote locations has led to questions about the importance of atmospheric and oceanic transport. Describing their distribution in surface soils is also an essential but neglected element in developing a comprehensive understanding of their occurrence in the environment. Soils are the critical link between global atmospheric and hydrologic processes where both local and distant contaminants can accumulate and be released into aquatic and terrestrial communities. Because PFC concentrations in soils will influence ground and surface water, wildlife, and crops, methods to accurately measure PFCs in soil are clearly needed. To help answer this need, we developed a method for the analysis of nine perfluorinated carboxylic acids and four perfluorinated sulfonic acids in soil. Samples from six nations (n = 10 per nation) were analyzed by LC-MS/MS to demonstrate the method performance parameters and to make preliminary observations about the occurrence of the PFCs in soils in different parts of the world. The resulting method shows acceptable performance characteristics for the target compounds in most soils while documenting the widespread occurrence of PFCs in surface soils.     

Relevant parameters for assessing the environmental impact of some pyridinium, ammonium and pyrrolidinium based ionic liquids

Several physico-chemical properties relevant to determine the environmental impact of ionic liquids - aqueous solubility, octanol/water partition coefficient, chromatographically derived lipophilicity and infinite dilution diffusion coefficients in water - were measured in ionic liquids based on pyridinium, ammonium and pyrrolidinium cations with bis(trifluoromethylsulfonyl)imide anions. The influence of the presence of hydroxyl or ester groups in the physico-chemical properties of these liquids was checked. It appeared that the presence of functional oxygenated moieties reduces the lipophilicity of ionic liquids and so decreases the risk of bioaccumulation in environment.     

High-molecular weight sulfur-containing aromatics refractory to weathering as determined by Fourier transform ion cyclotron resonance mass spectrometry

Biomarkers and low-molecular weight polyaromatic compounds have been extensively studied for their fate in the environment. They are used for oil spill source identification and monitoring of weathering and degradation processes. However, in some cases, the absence or presence of very low concentration of such components restricts the access of information to spill source. Here we followed the resistance of high-molecular weight sulfur-containing aromatics to the simulated weathering condition of North Sea crude oil by ultra high-resolution Fourier transform ion cyclotron resonance mass spectrometry. The sulfur aromatics in North Sea crude having double bond equivalents (DBE) from 6 to 14 with a mass range 188-674 Da were less influenced even after 6 months artificial weathering. Moreover, the ratio of dibenzothiophenes (DBE 9)/naphthenodibenzothiophenes (DBE 10) was 1.30 and 1.36 in crude oil and 6 months weathered sample, respectively reflecting its weathering stability. It also showed some differences within other oils. Hence, this ratio can be used as a marker of the studied crude and accordingly may be applied for spilled oil source identification in such instances where the light components have already been lost due to environmental influences.     

我国环境技术转移模式与运行保障机制的研究

全面阐述了我国环境技术成果转化推广机制建设取得的积极进展,以及当前存在的困难和问题;基于环境技术转移体制机制的内涵,提出了环境技术转化转移机制建设应遵循的四项原则;论述了环境技术转化转移模式选择和六项保障环境技术转化转移能动健康运行的保障机制性措施。     

规模化畜禽养殖产污系数研究

随着畜禽养殖逐渐走向规模化,畜禽养殖污染已成为农村污染的重要来源。以规模化畜禽养殖产生的废水和固体废弃物为监测对象,对规模化畜禽养殖产污系数进行研究,给出单位畜禽从出生到出栏的产污系数计算方法。以四川省内江市为实例,计算了不同季节、不同规模的规模化养猪场产污系数,并与第一次污染源普查数据进行比较。