Desert Water Harvesting to Benefit Wildlife: A Simple, Cheap, And Durable Sub-Surface Water Harvester for Remote Locations

A sub-surface desert water harvester was constructed in the sagebrush steppe habitat of south-central Idaho, U.S.A. The desert water harvester utilizes a buried micro-catchment and three buried storage tanks to augment water for wildlife during the dry season. In this region, mean annual precipitation (MAP) ranges between about 150–250 mm (6″–10″), 70% of which falls during the cold season, November to May. Mid-summer through early autumn, June through October, is the dry portion of the year. During this period, the sub-surface water harvester provides supplemental water for wildlife for 30–90 days, depending upon the precipitation that year. The desert water harvester is constructed with commonly available, “over the counter” materials. The micro-catchment is made of a square-shaped, 20 mL. “PERMALON” polyethylene pond liner (approximately 22.9 m × 22.9 m = 523 m²) buried at a depth of about 60 cm. A PVC pipe connects the harvester with two storage tanks and a drinking trough. The total capacity of the water harvester is about 4777 L (1262 U.S. gallons) which includes three underground storage tanks, a trough and pipes. The drinking trough is refined with an access ramp for birds and small animals. The technology is simple, cheap, and durable and can be adapted to other uses, e.g. drip irrigation, short-term water for small livestock, poultry farming etc. The desert water harvester can be used to concentrate and collect water from precipitation and run-off in semi-arid and arid regions. Water harvested in such a relatively small area will not impact the ground water table but it should help to grow small areas of crops or vegetables to aid villagers in self-sufficiency.     

CTL-12型化学需氧量速测仪与标准法测定CODCr之比较

使用CTL—12型化学需氧量速测仪分析废水化学需氧量，简便、快速，且方法可行，完全能满足环境监测技术要求。     

Economic development and environmental protection: an ecological economics perspective

This paper argues on both theoretical and empirical grounds that, beyond a certain point, there is an unavoidable conflictbetween economic development (generally taken to mean 'materialeconomic growth') and environmental protection. Think for a moment of natural forests, grasslands, marine estuaries, salt marshes, and coral reefs; and of arable soils, aquifers, mineraldeposits, petroleum, and coal. These are all forms of 'natural capital' that represent highly-ordered self-producing ecosystemsor rich accumulations of energy/matter with high use potential (low entropy). Now contemplate despoiled landscapes, eroding farmlands, depleted fisheries, anthropogenic greenhouse gases,acid rain, poisonous mine tailings and toxic synthetic compounds.These all represent disordered systems or degraded forms of energy and matter with little use potential (high entropy). The main thing connecting these two states is human economic activity. Ecological economics interprets the environment-economyrelationship in terms of the second law of thermodynamics. The second law sees economic activity as a dissipative process. Fromthis perspective, the production of economic goods andservices invariably requires the consumption of available energy and matter. To grow and develop, the economynecessarily 'feeds' on sources of high-quality energy/matter first produced by nature. This tends to disorder and homogenizethe ecosphere, The ascendance of humankind has consistently been accompanied by an accelerating rate of ecological degradation, particularly biodiversity loss, the simplificationof natural systems and pollution. In short, contemporary political rhetoric to the contrary, the prevailing growth-oriented global development paradigm is fundamentally incompatible with long-term ecological and social sustainability. Unsustainability is not a technical nor economic problem as usually conceived, but rather a state of systemic incompatibilitybetween a economy that is a fully-contained, growing, dependent sub-system of a non-growing ecosphere. Potential solutions fly inthe face of contemporary development trends and cultural values.     

Trace Metal Concentration in Roadside Surface Soil and Tree Back: A Measurement of Local Atmospheric Pollution in Abuja, Nigeria

Cadmium, copper, lead, nickel and zinc concentrations were analysed by atomic absorption spectrophotometry in surface soil and tree bark from different districts of Abuja, Nigeria, in order to determine the atmospheric trace metal input in the area.Elevated concentrations of some of the studied metals were observed in the soil and tree bark samples from the commercial/high traffic areas of the city compared to backgroundvalues. In soil samples, the average concentration of the metals were 0.6±0.4, 18.0±4.0, 281±39, 16±4 and66±23 g g^-1 dry weight for Cd, Cu, Pb, Ni and Zn, respectively, whilst the average concentrations in tree bark were 0.3±0.2, 12±4, 133±32, 13±3 and 61±10 g g^-1 dry weight for Cd, Cu, Pb, Ni and Zn, respectively. The trend in trace metal levels suggested that automobile emissions are a major source of these metals as the highest concentrations of Pb and Zn were recorded in the commercial areas of the city known for their high traffic densities. The levels of metal in the study area were relativelylow compared to levels found in some larger and older cities in various countries worldwide.     

Monitoring of Butter and Ghee (Clarified Butter Fat) for Pesticidal Contamination from Cotton Belt of Haryana, India

Butter (45) and ghee (55) samples were collected from rural and urban areas of cotton growing belt of Haryana and analysed for detecting the residues of organochlorine, synthetic pyrethroid and organophosphate insecticides. The estimation was carried out by using multi residue analytical technique employing GC-ECD and GC-NPD systems equipped with capillary columns. Butter samples were comparatively more contaminated (97%) than ghee (94%), showing more contamination with organochlorine insecticides from urban samples. About 11% samples of butter showed endosulfan residues above MRL value and 2% samples had residues of synthetic pyrethroids and organophosphates each above their respective MRL values. In ghee, residues of HCH & DDT both and of endosulfan exceeded the MRL values in 5 and 20% samples, respectively. Among organophosphates, only chlorpyriphos was detected with 9% samples showing its residue above MRL value. Irrespective of contamination levels, residues above the MRL values were more in ghee. More extensive study covering other agricultural regions/zones of Haryana has been suggested to know the overall scenario of contamination of milk products.     

Air Pollution and Heat Exposure Study in the Workplace in a Glass Manufacturing Unit in India

Air pollution in the workplace environment due to industrial operation have been found to cause serious occupational health hazard. Similarly, heat stress is still most neglected occupational hazard in the tropical and subtropical countries like India. The hot climate augments the heat exposure close to sources like furnaces. In this study an attempt is made to assess air pollution and heat exposure levels to workers in the workplace environment in glass manufacturing unit located in the State of Gujarat, India. Samples for workplace air quality were collected for SPM, SO₂, NO₂ and CO₂ at eight locations. Results of workplace air quality showed 8-hourly average concentrations of SPM: 165–9118 μg/m³, SO₂: 6–9 μg/m³ and NO₂: 5–42 μg/m³, which were below the threshold limit values of workplace environment. The level of CO₂ in workplace air of the plant was found to be in the range 827–2886 μg/m³, which was below TLV but much higher than the normal concentration for CO₂ in the air (585 mg/m³). Indoor heat exposure was studied near the furnace and at various locations in an industrial complex for glass manufacturing. The heat exposure parameters including the air temperature, the wet bulb temperature, and the globe parameters were measured. The Wet Bulb Globe Temperature (WBGT), an indicator of heat, exceeded ACGIH TLVs limits most of the time at all the locations in workplace areas. The recommended duration of work and rest have also been estimated.     

A modular approach to Integrated Assessment modeling

In this paper, we present a new approach to model coupling that probably forms the methodological basis of a new generation of Integrated Assessment models. This approach respects the knowledge and expertise that is embodied in existing models and encourages their gradual evolution. Modularity is the guiding principle. Our approach is distinguished by the way modules are coupled which is based on an interplay of a job control module, a numerical coupling module, and a couple of stand-alone functional modules. The numerical coupling module - the core component - serves to treat the feedbacks between the functional modules. A first implemented example that couples an economic and a climate module by means of a two-phase meta-optimization is presented here. The algorithm and mathematical structure behind are discussed as well as important features such as convergence behavior and reliability.     

Aerosol Scavenging: Model Application and Sensitivity Analysis in the Indian Context

Sulfate aerosols have been found to bethe major contributors to precipitation acidity. Thus,in view of the long-term ecological repercussions theyhave on aquatic ecosystems and their acidity-potential,the present analysis focuses on a case study applicationof the layer-averaged aerosol-scavenging model (Okita et al., 1996) for predicting values of the wet scavengingcoefficient and sulfate concentrations in precipitationsamples on the basis of the information available forsome selected Indian cities. Through sensitivityanalysis (Pandey et al., 1997) the scavengingcoefficient has been found to be very strongly dependenton precipitation intensity. Comparison of modelpredictions has been done with the measured values forDelhi, Mumbai, Calcutta and Chennai in India.     

Prediction of Leachate Level in Kimpo Metropolitan Landfill Site by Total Water Balance

Kimpo metropolitan landfill has received various kinds of wastessince January 1992. The leachate level was measured to be 10.3 m in May 1995 and the level increased to 12.2 m in August 1996. Therefore, to prove the reason for the increasing leachate level, we calibrated hydraulic conductivity of each waste andintermediate layer using the HELP (Hydrologic Evaluation ofLandfill Performance) model. The leachate generation data measured from February 1993 to October 1995 was used in the model calibration. As a result of a model calibration, we obtained anaverage infiltration ratio and used this in analysis of the total water balance to predict elevation of leachate level. Main causes of the elevation of the leachate level were the high water content of the waste and the degradation of the leachate-drainage system caused by the subsidence of a naturalbarrier layer.     

Monitoring of Seasonal Vegetables for Pesticide Residues

Market samples (60) of six seasonal vegetables were monitoredduring 1996–1997 to determine the magnitude of pesticidalcontamination. The estimation of insecticide residuesrepresenting four major chemical groups i.e. organochlorine,organophosphorous, synthetic pyrethroid and carbamate, was doneby adopting a multiresidue analytical technique employingGC-ECD and GC-NPD systems with capillary columns. The testedsamples showed 100% contamination with low but measurableamounts of residues. Among the four chemical groups, theorganophosphates were dominant followed by organochlorines,synthetic pyrethroids and carbamates. About 23% of the samplesshowed contamination with organophosphorous compounds abovetheir respective MRL values. More extensive studies coveringdifferent regions of Haryana state are suggested to get a clearidea of the magnitude of vegetable contamination with pesticideresidues.