全文获取类型
收费全文 | 2809篇 |
免费 | 323篇 |
国内免费 | 2061篇 |
专业分类
安全科学 | 160篇 |
废物处理 | 212篇 |
环保管理 | 348篇 |
综合类 | 3092篇 |
基础理论 | 332篇 |
污染及防治 | 986篇 |
评价与监测 | 46篇 |
社会与环境 | 15篇 |
灾害及防治 | 2篇 |
出版年
2023年 | 23篇 |
2022年 | 97篇 |
2021年 | 113篇 |
2020年 | 111篇 |
2019年 | 128篇 |
2018年 | 132篇 |
2017年 | 127篇 |
2016年 | 196篇 |
2015年 | 250篇 |
2014年 | 312篇 |
2013年 | 320篇 |
2012年 | 404篇 |
2011年 | 335篇 |
2010年 | 284篇 |
2009年 | 297篇 |
2008年 | 262篇 |
2007年 | 285篇 |
2006年 | 330篇 |
2005年 | 219篇 |
2004年 | 179篇 |
2003年 | 158篇 |
2002年 | 98篇 |
2001年 | 80篇 |
2000年 | 83篇 |
1999年 | 75篇 |
1998年 | 62篇 |
1997年 | 54篇 |
1996年 | 39篇 |
1995年 | 33篇 |
1994年 | 25篇 |
1993年 | 23篇 |
1992年 | 24篇 |
1991年 | 18篇 |
1990年 | 8篇 |
1989年 | 1篇 |
1987年 | 2篇 |
1986年 | 1篇 |
1984年 | 1篇 |
1979年 | 2篇 |
1978年 | 1篇 |
1970年 | 1篇 |
排序方式: 共有5193条查询结果,搜索用时 15 毫秒
991.
林可霉素生产废水的厌氧生物处理工艺 总被引:17,自引:2,他引:15
采用单相中温升流式厌氧污泥床(UASB)反应器厌氧生物工艺处理含有有毒难降解有机物的林可霉素生产废水.当进水COD 8000~14000 mg/L,HRT约10h时,COD容积负荷可达20~35kg/(m3·d),COD去除率为50%~55%.适时调整并维持较高的表面水力负荷[0.2~0.4 m3/(m2·h)]、较高的进水有机基质浓度(COD为2000~3000mg/L)和污泥COD负荷[0.2~0.5 kg/(kg·d)],并适当延长启动驯化时间可培养出沉降性好、污泥活性较高的颗粒污泥.废水厌氧生物降解动力学符合Monod方程,动力学常数Vmax=1.3 d-1,Ks=8133mg/L.废水中不可生物降解物质占总COD的比例约为30%,这是废水COD去除率偏低的重要因素. 相似文献
992.
内循环式厌氧反应器启动过程中颗粒污泥的特性 总被引:29,自引:0,他引:29
研究了IC反应器的快速启动方法和启动过程中颗粒污泥性质.结果表明,由于反应器成功滞留了大量活性高、沉降性能好的颗粒污泥,反应器初次启动可在20d内完成,二次启动15d内完成,反应器负荷可达12~15kg·(m3·d)-1,COD去除率85%以上;IC反应器启动结束后,其颗粒污泥的性质发生显著变化,平均粒径由0.88mm增大到1.25mm,平均沉降速度由接种污泥的35.4m·h-1增加到105.17m·h-1,最大比产甲烷活性382.98 ml·(g·d)-1]几乎为初期的4倍,产甲烷优势菌由Methanothrix转变为产甲烷球菌和短杆菌. 相似文献
993.
994.
995.
996.
997.
本文通过农田试验 ,得出氧化塘底泥可以改良土壤结构、增加有机质含量、微生物数量、提高作物产量的结论。因此 ,底泥可以作为一种有机肥应用于农业。 相似文献
998.
Acidic bioleaching of heavy metals from sewage sludge 总被引:2,自引:0,他引:2
The overall objective of this study was to evaluate the use of controlled bio-acidification prior to land application as a
decontamination process to remove heavy metals from sludge. The sulfur-oxidizing bacteria were naturally available in the
sludge samples and were activated by providing sulfur and aeration at 28°C–30°C. Activation resulted in bio-acidification
to pH 2 within 5–11 days. Successive inoculation of fresh sludges with 5% acidified samples reduced the acidification time
to 2–3 days in most samples. Bio-acidification resulted in dissolving significant quantities of heavy metals from all sludge
types tested. The maximum solubilization results were: 86%–97% for Ni; 48%–98% for Pb; 26%–71% for Cr; 18%–91% for Zn; 16%–90%
for Cu; 7%–60% for Cd. Limited metal solubilization results were observed in the various control samples that accompanied
the bio-acidified samples. The leaching results in the control samples were limited to 2%–19% for Ni, 0%–7% for Pb, 0%–5%
for Cr, 0.3%–4% for Zn, 0.2%–4% for Cu and 0%–3% for Cd. The results confirmed that Ni and Pb were the easiest metals to dissolve
from the various sludge types. On the other hand, the lowest solubilization results were observed for Cu and Cd, and moderate
solubilization results were achieved for Cr. The bio-acidification process resulted in moderate gains in terms of improving
the suitability of tested sludges for land application.
Received: April 19, 1999 / Accepted: November 4, 1999 相似文献
1000.
针对目前国内外垃圾渗沥液处理中存在的问题,采用电化学氧化与上流式厌氧污泥床(UASB)相结合,研究建立了对香港垃圾渗沥液的二步法处理工艺.本文着重探讨了电化学间接氧化去除渗沥液中氨氮的反应机制及主要影响因素,并通过实验找出了最佳的操作条件:入水初始 pH值为9.0;流速为0.01-0.10cm/s;CI加入量2000mg/L;电流密度 32.3mA/cm2.在此条件下,经过 6h电解后,UASB反应器出水中NH-N和COD的去除率分别达到100%和87%.对该电化学氧化过程的运行成本进行了评估. 相似文献