决策树模型在水环境监测网络中选取代表性样点的应用

地表水体中的硝酸盐污染已经成为全球关注的热点环境问题之一。现今,国内外均建立了相关的监测网络对地表水体的水质实施长期监测,但是却导致大量的监测数据累积,给后续的科学研究工作带来了不便,尤其是在庞大的监测网络中如何选取有代表性样点的研究点则成为急需解决的问题之一。以比利时弗拉芒地区地表水的长期监测物理化学指标为例,利用决策树模型评估地表水样点的硝酸盐污染来源专家分类的有效性,为点位优化提供理论依据。原有监测点位的污染源专家分类和模型输出的可匹配率为80%,优化后监测点位从原有47个点降低到30个点,提高了监测工作效率。     

北方泥炭地泥炭土矿化速率、温度敏感性及其影响因素研究

北方泥炭地是全球重要的碳汇,也是全球变暖最为敏感的区域之一.然而,由于泥炭地表层和亚表层泥炭土碳排放过程对全球变暖的响应过程及机制仍存在一定争议,目前对全球变暖背景下泥炭地碳排放的认识仍存在一定不足.本研究于2019年8月在大兴安岭满归泥炭地采集表层(0～10 cm)和亚表层(15～30 cm)泥炭土进行室内增温模拟有氧培养,测定其矿化速率、有机质性质和水解酶活性.结果表明,表层泥炭土矿化速率在5、15、25℃下培养时((142.8±66.9)～(545.3±30.6)、(575.0±62.1)～(1843.0±547.4)、(888.4±123.9)～(3646.7±167.9)μg·g^-1·d^-1)均高于亚表层((113.0±41.5)～(367.1±64.1)、(357.4±52.3)～(1122.1±218.8)、(697.1±38.1)～(2336.4±150.6)μg·g^-1·d^-1),但表层和亚表层矿化作用的温度敏感性不具有显著差异;培养过程中,表层与亚表层泥炭土β-1,4-N-乙酰葡...     

塔克拉玛干沙漠和青藏高原地区沙尘气溶胶光学特性及其加热率的时空分布特征

沙尘不同的垂直分布对大气的加热作用不同,通过卫星观测结合数值模拟,可以更清楚地了解沙尘辐射加热作用,有利于理解沙尘对该地区大气热结构的影响机制.因此,本研究利用CALIPSO气溶胶产品和SBDART模式,分析了2007—2020年塔克拉玛干沙漠和青藏高原沙尘气溶胶及其短波加热率的时空分布特征.结果表明,塔克拉玛干沙漠和青藏高原的年平均沙尘气溶胶光学厚度（DAOD,532 nm）分别为0.300～0.350和0.086～0.108,平均值分别为0.328和0.097.塔克拉玛干沙漠季节平均DAOD的最大、最小值分别出现在春季和冬季,而青藏高原的最大、最小值分别出现在夏季和秋季.塔克拉玛干沙漠和青藏高原的沙尘消光系数（σD）最大值分别出现在春季和夏季.2007—2020年,两地的σD在春季均呈增加趋势,而在秋季则呈减小趋势.春季和夏季的短波沙尘加热率（SW DHR）均大于其它两个季节,其中春季最大,塔克拉玛干沙漠上空冬季最弱,青藏高原上空秋季最弱.春夏季,青藏高原北坡存在较强沙尘加热层,其顶部高于5 km,其强度及高值区从春季到冬季逐渐减小.从年变化来看,春季短波加热率呈加强趋势,秋季呈减...     

Utilization of cement kiln dust (CKD) in cement mortar and concrete—an overview

Solid waste management is one of the major environmental concerns around the world. Cement kiln dust (KKD), also known as by-pass dust, is a by-product of cement manufacturing. The environmental concerns related to Portland cement production, emission and disposal of CKD is becoming progressively significant. CKD is fine-grained, particulate material chiefly composed of oxidized, anhydrous, micron-sized particles collected from electrostatic precipitators during the high temperature production of clinker. Cement kiln dust so generated is partly reused in cement plant and landfilled. The beneficial uses of CKD are in highway uses, soil stabilization, use in cement mortar/concrete, CLSM, etc.Studies have shown that CKD could be used in making paste/mortar/concrete. This paper presents an overview of some of the research published on the use of CKD in cement paste/mortar/concrete. Effect of CKD on the cement paste/mortar/concrete properties like compressive strength, tensile strength properties (splitting tensile strength, flexural strength and toughness), durability (Freeze–thaw), hydration, setting time, sorptivity, electrical conductivity are presented. Use of CKD in making controlled low-strength materials (CLSM), asphalt concrete, as soil stabilizer, and leachate analysis are also discussed in this paper.     

Satellite and Ground Based Monitoring of Aerosol Plumes

Plumes of atmospheric aerosol have been studied using a rangeof satellite and ground-based techniques. The Sea-viewing WideField-of-view Sensor (SeaWiFS) has been used to observe plumesof sulphate aerosol and Saharan dust around the coast of theUnited Kingdom. Aerosol Optical Thickness (AOT) was retrievedfrom SeaWiFS for two events; a plume of Saharan dusttransported over the United Kingdom from Western Africa and aperiod of elevated sulphate experienced over the Easternregion of the UK. Patterns of AOT are discussed and related tothe synoptic and mesoscale weather conditions. Furtherobservation of the sulphate aerosol event was undertaken usingthe Advanced Very High Resolution Radiometer instrument(AVHRR). Atmospheric back trajectories and weather conditionswere studied in order to identify the meteorologicalconditions which led to this event. Co-located ground-basedmeasurements of PM₁₀ and PM_2.5 were obtained for 4sites within the UK and PM_2.5/10 ratios were calculatedin order to identify any unusually high or low ratios(indicating the dominant size fraction within the plume)during either of these events. Calculated percentiles ofPM_2.5/10 ratios during the 2 events examined show thatthese events were notable within the record, but were in noway unique or unusual in the context of a 3 yr monitoringrecord. Visibility measurements for both episodes have beenexamined and show that visibility degradation occurred duringboth the sulphate aerosol and Saharan dust episodes.     

氰化物测定机理的研究

研究了酒石酸-硝酸锌法提取易释放氰化物，磷酸-EDTA提取总氰的机理；对异烟酸-吡唑啉酮光度法测定氰化物的条件作了探讨。     

大气污染与平流层气溶胶

本文简述了大气污染与气溶胶的关系，论述了平流层气溶胶对地球辐射收支的影响，从而说明平流层气溶胶的光学性质的变化将影响全球大气环境，在此基础上，计算了不同背景平流层气溶胶的光学常数和光学特性参数。并使用模式光学常数计算了３种火山模工气溶胶的光学特性参数。同时，考察了这些特性参数对光学常数的敏感性。结果表明，后向散射系数对光学常数的变化最敏感，对于某些波长，它的相对变化可比光学常数的相对变化大一个数量     

Radiation Effects on Blends of Poly(ε-Caprolactone) and Diatomites

Poly(-caprolactone) (PCL) was blended with diatomaceous earth (diatomite) and irradiated with -rays to introduce cross-linking between PCL molecules or both components. The unwashed diatomite containing a little of a volatile component showed high efficiency of introduction of cross-linking, whereas that with no volatile component showed low efficiency of introduction of cross-linking. Elongational viscosity, melt viscosity, and modulus of PCL/diatomite blend irradiated at various doses were significantly improved. Enzymatic degradation of the PCL/diatomite blend became faster than that of the PCL, though that of the blend irradiated became slower.     

Influences of Magnesium <Emphasis Type="Italic">tri-</Emphasis>Silicate on the Physical,Mechanical, and Degradable Properties of Ultraviolet (UV) Radiation Cured Plain Board Surface

A series of formulations were prepared with different percentages of oligomer, epoxy diacrylate (EA-1020 ), monomer, 1,6 Hexane diol diacrylate,(HDDA) and different percentages of filler (Magnesium tri-silicate, Mg₂Si₃O₈). Irgacure 369 [2-Benzyl-2-dimethyl-amine-1 (4-morpholinophenyl) butanone-1] was used in the formulations as photoinitiator. Ultraviolet (UV) cured thin polymer films were prepared from these formulating solutions on clean glass plates. Pendulum hardness (PH), gel content and macro scratch hardness (MSH) of the UV cured films were studied. One percent Mg₂Si₃O₈ containing formulation showed the premium properties. The substrates (plain board) were coated by these formulating solutions and cured under the same UV lamp at different intensities of radiation. Various properties of the coated surface such as PH, gloss, adhesion, abrasion and MSH were investigated. The base coat containing 1% Mg₂Si₃O₈ and top coat containing 48% HDDA produced the best performance among all the formulations inspected. The degradable properties in different weathering conditions on PH, gloss, adhesion, abrasion and MSH were measured. The surface cured with the optimized formulation (E) again yielded the minimum loss of the properties.     

提高节理面c和φ对岩坡开挖变形的影响

为了反映岩质边坡在节理面注浆后的变形效应,首先,通过室内试验,分析注浆前后岩体变形和破坏的全过程,以探讨其抗剪性能(粘结力c和内摩擦角φ)的变化;然后,基于理想弹塑性本构模型的Mohr-Cou-lomb准则,运用拉格朗日元数值方法(FLAC3D),对岩坡注浆前后变形效应(水平位移、垂直位移、剪应变增量)进行模拟。结果表明:注浆加固后,岩体的位移场变得均匀和连续,节理面处的较大位移受到抑制,边坡的整体性得到提高,有利于边坡的稳定性。