多环芳烃的零阶价分子连接性指数与正-辛醇/水分配系数

本文建立了准确预测多环芳烃(PAHs)及其烷基衍生物的正-辛醇/水分配系数(Kow)模型。模型表明PAHs的分配性质可用零阶价分子连接性指数(~°x~v)描述,~°x~v数值与PAHs的logKow成正比。应用本模型可以预测大范围PAHs的logKow值。     

活性污泥二次污染问题的探讨(Ⅱ)

讨论了城市污水经过A／O工艺处理时活性污泥的二次污染问题。将原水、处理后的出水及活性污泥用甲苯萃取，萃取相经过真空浓缩后，采用GC／MS测定了样品中的有机化合物，结果表明，在A／O工艺处理城市污水过程中，活性污泥的吸附作用是主要的，降解作用是次要的；A／O工艺所排放的活性污泥仍然是一种危险的污染物。     

Particle emissions of a railway line determined by detailed single particle analysis

The goal of this study was to identify and quantify particles emitted from railway traffic. For that purpose PM10 samples were collected near a busy railway line using a wind direction and speed controlled sampling equipment consisting of five devices. Measurements taken perpendicular to the railway lines at 10, 36 and 120 m distance enable an identification and separation of particles caused by the railway traffic from background particles. Morphology and chemistry of more than 11,000 particles were analysed by computer controlled scanning electron microscopy (CCSEM). Based on chemical composition five particle classes are defined and assigned to their sources. The mass of the individual particles is determined by multiplying their volumes, calculated based on their morphology with a density assigned specifically to each particle class. The density of the particle classes is derived from their chemical composition. To estimate the PM10 contributions of the railway lines, the mass of PM10 at 120 m (background, not influenced by the railway lines) is subtracted from the mass of PM10 at 10 m. The emissions of the railway lines are dominated by ‘iron’ particles, which contribute 2.9 μg m⁻³ or 67% to the railway related PM10. In addition, ‘aluminium’ and ‘calcium’ particles contribute also to the railway related PM10 (1.0 μg m⁻³ or 23% for the ‘aluminium’ and 0.4 μg m⁻³ or 10% for the ‘calcium’ particles). These particles are assigned to abrasion of the gravel bed and re-suspension of mineral dust.Long-term gravimetric results of the contribution of iron to the mass of railway related PM10 from a study performed earlier at the same site are in good agreement with the data presented in this study.     

Criteria for the evaluation of dioxins in the environment

In FRG and other countries unequivocal criteria for the limitation of dioxins (PCDD's/PCDF's) in food like vegetables and fruits are lacking. These have to be directly associated with the limitation of dioxins in the soil and the deposition of particulate matter as the two main pathways for plant contamination. Based on recent investigations in the vicinity of cable-waste incinerators in Northrhine-Westphalia with comparatively high contents of dioxins in garden plants and soils and other sources of dioxins, considerations are given for the establishment of the criteria urgently needed.     

Determination of dibenzo-p-dioxin (DBD) and dibenzofuran (DBF) in paper pulp mill defoamer additives and in paper pulp samples

An analytical procedure has been developed for quantitatively measuring dibenzo-p-dioxin (DBD) and dibenzofuran (DBF) present at part-per-billion levels in paper mill defoamers and paper pulp using gas chromatography coupled with either low resolution mass spectrometry (GC-LRMS) or high resolution mass spectrometry (GC-HRMS).     

二步法腈纶生产废水的处理试验

本试验采用混凝 -A/O系统组合工艺处理二步法腈纶废水 ,该系统处理效果良好 ,出水水质符合排放标准 ,可直接排入水体。A/O系统试验装置总容积 80L ,水力停留时间 5 8— 70h ,缺氧池与好氧池的容积比为 1∶3 ,回流比 ( 2—3 )∶1,COD和BOD总去除率分别约为 84%和 98%。     

含重金属水处理污泥的固化和浸出毒性研究

工业危险固体废物在进行安全填埋前需要进行固化稳定处理。针对电镀厂和皮革厂含重金属的水处理污泥 ,用不同比例的水泥、粉煤灰进行固化稳定处理。考虑酸雨环境 ,浸出实验采用TCLP标准。电镀厂污泥单独固化时 ,其浸出液中铜离子浓度由 78 0mg/L下降到 1 5mg/L ;镍离子浓度由 2 2 4 5mg/L下降到 2 2 2mg/L ,高于危险废物允许进入填埋区 15mg/L的控制限值。电镀厂污泥与皮革厂污泥混合后固化 ,浸出液毒性明显降低。铜离子的浸出浓度降低到1 98mg/L ,镍离子降低到 4 10mg/L ,总铬降低到 0 4 0mg/L ,各项指标均低于国家危险废物允许进入填埋区的控制限值 ,可安全填埋。     

碳氮磷比例失调城市污水的同步脱氮除磷

为解决现行同步脱氮除磷工艺处理南方地区碳、氮、磷比例失调城市污水中,因C/N、C/P偏低,碳源不足而降低脱氮除磷效率的难题,试验以碳源偏低的广州市城市污水为研究对象,采用厌氧/好氧交替运行的SBR系统,通过对厌氧、好氧时段的合理调控,在无需额外添加碳源的条件下,有机物、氨氮、总氮和总磷的平均去除率分别可达90%、72%、41%和99%,不仅能使有机物和氮的出水指标达到国家排放标准,而且总磷出水浓度能达0.5 mg/L以下。通过进一步分析同步高效脱氮除磷的影响因素和控制条件,得出合理污泥龄的控制是实现同步脱氮除磷的关键,厌氧/好氧交替运行的方式不仅强化了磷的释放和吸收,而且降低了碳源偏低和硝酸盐对同步脱氮除磷影响的结论。     

光助Ce-Fe/Al2O3催化H2O2降解阳离子红GTL模拟废水

利用Ce-Fe/Al₂O₃为催化剂的非均相光Fenton体系降解阳离子红GTL模拟废水，考察了H₂O₂浓度、催化剂用量、初始pH值及不同工艺过程对降解效果的影响，通过紫外-可见漫反射光谱、红外光谱、XPS手段研究铁在反应中的价态变化。结果表明，在11 W低压汞灯照射下，非均相光Fenton体系能够有效地降解结构稳定的阳离子红GTL，在pH 6，反应温度20℃，时间90 min，Ce-Fe/Al₂O₃ 2 g/L，H₂O₂浓度340 mg/L，含50 mg/L阳离子红GTL模拟废水TOC去除率为92.40%；光Fenton反应中Fe(Ⅲ)转化为Fe(Ⅱ)。