废弃电器电子产品POPs/PTS减排环境管理实践研究

全球环境基金(GEF)"通过环境无害化管理减少电器电子产品的生命周期内持久性有机污染物和持久性有毒化学品(POPs/PTS)的排放全额示范项目"湖北省作为项目示范省之一.三家废弃电器电子产品拆解企业,分别开展了废弃电器电子产品拆解技术示范、湿法废弃印刷电路板处置BAT/BEP技术示范、利用再生铅连续熔炼炉协同处置阴极射线管含铅锥玻璃项目技术示范.电子废弃物全自动化分类与拆解生产线,为电子废弃物绿色循环与资源化提供了示范模式.     

Integrating channel design and assessment methods based on sediment transport capacity in gravel bed streams

Natural channel design (NCD) and analytical channel design (ACD) are two competing approaches to stable channel design that share fundamental similarities in accounting for sediment transport processes with designs based on hybrid fluvial geomorphology and hydraulic engineering methods. In this paper, we highlight the linkage between ACD's capacity/supply ratio (CSR) and NCD's sediment capacity models (FLOWSED/POWERSED), illustrating how ACD and NCD have reached a point of convergent evolution within the stream restoration toolbox. We modified an existing CSR analytical spreadsheet tool which enabled us to predict relative channel stability using both conventional bed load transport equations and regional sediment regression curves. The stable channel design solutions based on measured data most closely matched the Parker (ACD) and/or Pagosa good/fair (NCD) relationships, which also showed the greatest CSR sensitivity in response to channel alterations. We found that CSR differences among the transport relationships became more extreme the further the design width deviated from the supply reach, suggesting that a stable upstream supply reach may serve as the best design analog. With this paper, we take a step toward resolving lingering controversy in the field of stream restoration, advancing the science and practice by reconciling key differences between ACD and NCD in the context of reach scale morphodynamics.     

生活垃圾堆肥工艺条件及其反应动力学研究

为了改善堆肥微环境 ,提高生活垃圾堆肥速率 ,研究堆肥工艺条件及其反应动力学是非常必要的。通过控制堆肥工艺条件 ,如初始温度、含水率、C/N比及堆料颗粒大小 ,研究生活垃圾堆肥过程中生物、化学及物理因素的变化。试验结果表明 ,生活垃圾堆肥反应符合一级反应动力学 ;合理控制堆肥初始反应条件 ,能明显提高堆肥效率。     

医疗焚烧废渣的固定化试验研究

医疗垃圾属于国家规定的危险废物,焚烧后的残渣同样存在最后稳定化的问题,国外处理方法主要是填埋和基础回填,本文通过对两种胶凝材料(普硅水泥和复合矿渣水泥)对医疗废渣的固定化效果研究,探讨医疗废渣再利用的可行性和影响因素。     

利用CGE模型评价水价改革的影响力——以北京市为例

为保证水价改革公平，将水价影响控制在可承受范围内，需要有工具能评估水价改革的影响。以北京市为例，建立了CGE模型用以评价各部门水价水平高低。通过改进CGE模型的收入方程，以评价水价改革对价格水平、生产、用水量和水费收入的影响。评价结果表明：从1996到2005年，各部门水价水平大幅增加，但极不平均；水价改革对价格水平的影响极低；对某些部门的生产有程度很低的不利影响。但可提高净产值。促进个别部门发展。     

An integrated method for the rapid dewatering and solidification/stabilization of dredged contaminated sediment with a high water content

• An integrated method, called PHDVPSS, was proposed for treating DCS. • The PHDVPSS method showed superior performance compared to conventional method. • Using the method, water content (%) of DCS decreased from 300 to<150 in 3 days. • The 56-day UCS from this method is 12‒17 times higher than conventional method. • Relative to PC, GGBS-MgO binder yielded greater reduction in the leachability. To more efficiently treat the dredged contaminated sediment (DCS) with a high water content, this study proposes an integrated method (called PHDVPSS) that uses the solidifying/stabilizing (S/S) agents and prefabricated horizontal drain (PHD) assisted by vacuum pressure (VP). Using this method, dewatering and solidification/stabilization can be carried out simultaneously such that the treatment time can be significantly shortened and the treatment efficacy can be significantly improved. A series of model tests was conducted to investigate the effectiveness of the proposed method. Experimental results indicated that the proposed PHDVPSS method showed superior performance compared to the conventional S/S method that uses Portland cement (PC) directly without prior dewatering. The 56-day unconfined compressive strength of DCS treated by the proposed method with GGBS-MgO as the binder is 12‒17 times higher than that by the conventional S/S method. DCS treated by the PHDVPSS method exhibited continuous decrease in leaching concentration of Zn with increasing curing age. The reduction of Zn leachability is more obvious when using GGBS-MgO as the binder than when using PC, because GGBS-MgO increased the residual fraction and decreased the acid soluble fraction of Zn. The microstructure analysis reveals the formation of hydrotalcite in GGBS-MgO binder, which resulted in higher mechanical strength and higher Zn stabilization efficiency.     

The performance of nitrate-reducing Fe(II) oxidation processes under variable initial Fe/N ratios: The fate of nitrogen and iron species

•Bacterially-mediated coupled N and Fe processes examined in incubation experiments. •NO₃⁻ reduction was considerably inhibited as initial Fe/N ratio increased. •The maximum production of N₂ occurred at an initial Fe/N molar ratio of 6. •Fe minerals produced at Fe/N ratios of 1–2 were mainly easily reducible oxides. The Fe/N ratio is an important control on nitrate-reducing Fe(II) oxidation processes that occur both in the aquatic environment and in wastewater treatment systems. The response of nitrate reduction, Fe oxidation, and mineral production to different initial Fe/N molar ratios in the presence of Paracoccus denitrificans was investigated in 132 h incubation experiments. A decrease in the nitrate reduction rate at 12 h occurred as the Fe/N ratio increased. Accumulated nitrite concentration at Fe/N ratios of 2–10 peaked at 12–84 h, and then decreased continuously to less than 0.1 mmol/L at the end of incubation. N₂O emission was promoted by high Fe/N ratios. Maximum production of N₂ occurred at a Fe/N ratio of 6, in parallel with the highest mole proportion of N₂ resulting from the reduction of nitrate (81.2%). XRD analysis and sequential extraction demonstrated that the main Fe minerals obtained from Fe(II) oxidation were easily reducible oxides such as ferrihydrite (at Fe/N ratios of 1–2), and easily reducible oxides and reducible oxides (at Fe/N ratios of 3–10). The results suggest that Fe/N ratio potentially plays a critical role in regulating N₂, N₂O emissions and Fe mineral formation in nitrate-reducing Fe(II) oxidation processes.     

Optimization of the O3/H2O2 process with response surface methodology for pretreatment of mother liquor of gas field wastewater

• Real ML-GFW with high salinity and high organics was degraded by O₃/H₂O₂ process. • Successful optimization of operation conditions was attained using RSM based on CCD. • Single-factor experiments in advance ensured optimal experimental conditions. • The satisfactory removal efficiency of TOC was achieved in spite of high salinity. • The initial pH plays the most significant role in the degradation of ML-GFW. The present study reports the use of the O₃/H₂O₂ process in the pretreatment of the mother liquor of gas field wastewater (ML-GFW), obtained from the multi-effect distillation treatment of the gas field wastewater. The range of optimal operation conditions was obtained by single-factor experiments. Response surface methodology (RSM) based on the central composite design (CCD) was used for the optimization procedure. A regression model with Total organic carbon (TOC) removal efficiency as the response value was established (R² = 0.9865). The three key factors were arranged according to their significance as: pH>H₂O₂ dosage>ozone flow rate. The model predicted that the best operation conditions could be obtained at a pH of 10.9, an ozone flow rate of 0.8 L/min, and H₂O₂ dosage of 6.2 mL. The dosing ratio of ozone was calculated to be 9.84 mg O₃/mg TOC. The maximum removal efficiency predicted was 75.9%, while the measured value was 72.3%. The relative deviation was found to be in an acceptable range. The ozone utilization and free radical quenching experiments showed that the addition of H₂O₂ promoted the decomposition of ozone to produce hydroxyl radicals (·OH). This also improved the ozone utilization efficiency. Gas chromatography-mass spectrometry (GC-MS) analysis showed that most of the organic matters in ML-GFW were degraded, while some residuals needed further treatment. This study provided the data and the necessary technical supports for further research on the treatment of ML-GFW.     

两级CSTR亚硝化启动及稳定运行试验研究

采用两级CSTR反应器对实际生活污水亚硝化的启动过程及稳定运行主要影响因素进行了研究.通过向生活污水里投加(NH₄)₂SO₄来提高进水氨氮浓度,并逐渐调整两级反应器的曝气强度至DO浓度分别为(1.5±0.12),(0.35±0.1) mg/L,历经45d即实现了亚硝化的启动,亚硝化率保持在90.3%以上,氨氧化率保持在91.2%以上.低氨氮生活污水运行时,通过第一级反应器中三组DO/ALR的效果对比,表明DO/ALR在1.2~2.0 mg O₂/(gN·d)时亚硝化效果最好.降低氨氮浓度以及增大HRT两种情况下导致ALR改变时,维持上述DO/ALR范围依然可以保证亚硝化的稳定.     

硫铁填料和微电流强化再生水脱氮除磷的研究

为提高再生水质量,在不同C/N和HRT条件下,对比分析硫铁复合填料和微电流作用强化再生水深度脱氮除磷效果.结果表明,硫铁复合填料和微电流作用均能够强化氮、磷的深度去除效果,且二者结合能够使反硝化系统pH值稳定在7.2~8.5之间.系统中TN主要靠异养反硝化、氢自养反硝化和硫自养反硝化作用去除,94.04%的TP是以生成磷酸铁沉淀的形式去除.分别从填料上取生物膜,进行Miseq高通量测序,构建细菌16S rRNA基因克隆文库.结果发现,在仅有海绵铁作用系统中,同时具有异养反硝化和氢自养反硝化功能的细菌所占比例达到29.47%;硫铁复合填料和硫铁微电流作用系统中,具有硫自养反硝化功能的Thiobacillus(硫杆菌属)所占比例分别达到60.47%和40.62%.因此,硫铁复合填料和微电流作用用于强化再生水深度脱氮除磷具有明显的优势.