Pollutant emission characteristics of rice husk combustion in a vortexing fluidized bed incinerator

Rice husk with high volatile content was burned in a pilot scale vortexing fluidized bed incinerator. The fluidized bed incinerator was constructed of 6 mm stainless steel with 0.45 m in diameter and 5 m in height. The emission characteristics of CO, NO, and SO2 were studied. The effects of operating parameters, such as primary air flow rate, secondary air flow rate, and excess air ratio on the pollutant emissions were also investigated. The results show that a large proportion of combustion occurs at the bed surface and the freeboard zone. The SO2 concentration in the flue gas decreases with increasing excess air ratio, while the NOx concentration shows reverse trend. The flow rate of secondary air has a significant impact on the CO emission. For a fixed primary air flowrate, CO emission decreases with the secondary air flowrate. For a fixed excess air ratio, CO emission decreases with the ratio of secondary to primary air flow. The minimum CO emission of 72 ppm is attained at the operating condition of 40% excess air ratio and 0.6 partition air ratio. The NOx and SO2 concentrations in the flue gas at this condition are 159 and 36 ppm, which conform to the EPA regulation of Taiwan.     

流化床污泥干燥器床料的颗粒度对流化情况的影响

以上海白龙港污水处理厂流化床污泥干燥系统为研究对象,针对流化床污泥干燥器流化情况的好坏分析,在确定其它变量（流化风量、给料分配器转速、料层压差、运行负荷等）不变的情况下,对床料颗粒度的工艺参数进行研究实验,总结颗粒度的工艺参数对流化情况的运行变化规律,从而提高了流化床污泥干燥系统的稳定性、连续性和高效性。     

添加H2O2加速低合金钢海水腐蚀的主要影响因素研究

采用极化曲线、旋转圆盘电极试验和失重（质量损失）法研究了低合金钢在添加了H。o：的海水中腐蚀加速的主要影响因素。结果发现低合金钢在添加H2O2的海水中腐蚀加速主要受到了H2O2浓度、温度、搅拌速度和H2O2添加周期的影响。研究表明,搅拌速度不变、H2O2添加周期相同的条件下,在H2O2浓度为0．8mol／L的70℃海水中,低合金铜的腐蚀加速最显著;在试验的转速范围内,加速作用随搅拌速度增大变得更为显著;H2O2加入后350min内加速作用较明显。     

FeⅡ(EDTA)络合协同RDB去除NO废气效能及过程分析

为进一步提高一氧化氮(NO)的去除效率,在新型生物转鼓反应器(rotating drum biofilter,RDB)中,以FeⅡ(EDTA)络合协同RDB生物转鼓的耦合技术强化难水溶性NO的气液传质速率,提高生物还原效能为目标进行了研究.结果表明,适量FeⅡ(EDTA)被添加到RDB底部营养液后,能迅速吸收气相中的NO并生成FeⅡ(EDTA)-NO络合物,进而可通过反硝化实现同步脱氮和络合剂再生.在转速0.5 r.min-1、空床停留时间(EBRT)57.7 s、温度30℃、pH 7～8的实验条件下,RDB的净化效能随络合剂的投加而显著改善;FeⅡ(EDTA)质量浓度从0增至500 mg.L-1后,NO去除率从61.1%提高到97.6%,去除负荷从16.2 g.(m3.h)-1上升到26.7 g.(m3.h)-1.分析了FeⅡ(EDTA)络合协同净化NO的反应过程,建立了NO净化效率与FeⅡ(EDTA)添加浓度的关联方程,可较好地拟合实验数据.     

铁山港海草生态区水体自净能力与水、生、化之间的关系

利用2008年1月～11月间对铁山港湾海草生态区进行的4个季节全面调查所获取的数据资料,首次探讨了该生态区水体自净能力与水动力特征及生物、化学因子之间的关系。结果表明:研究海区之所以具有较强的水体自净能力,其一与该海区具有强潮型的往复流水动力特征有关,在水体自净过程中起主导控制作用;其二与海区具有适宜的水温、快速的复氧能力、富足的溶解氧(DO)水平、最适合好氧微生物繁殖生长的环境条件有关,明显偏低的总有机碳(TOC)含量和丰富的总氮(TN)储量是有机物获得快速降解、营养盐获得快速再生、化学净化能力较强的重要体现;其三与生物链作用所体现的生化过程影响有关,DO含量与生物因子多呈显著以上负相关的季节变化特征以及三种形态N与生物因子在不同季节显示的相关性以事实佐证了这一点;而富足的TN储量、显著偏低的溶解无机氮(DIN)含量与繁盛的浮游动植物生物量及丰富的生物多样性同时出现的特征,正是研究海区具有较强生物净化能力的综合体现。与化学净化能力相比,生物净化能力显示出更强的优势,具有海草生态区的水体自净特点。     

内循环活性炭生物流化床处理农药生产废水的试验研究

采用内循环活性炭生物流化床反应器处理某农药厂生产废水,通过试验研究了该反应器在室温条件下处理农药生产废水的性能.结果表明:当进水pH值控制在7.0～7.5、水力停留时间为6h、曝气量控制在使活性炭处于流化状态时,CODcr的去除率为50％,总氮的去除率为32.33％,同时可生化性明显提高,生物毒性有所降低.     

序批式移动床生物膜反应器富集反硝化聚磷菌及其在单污泥系统中的应用

本文介绍了在单污泥系统中选择和富集反硝化聚磷菌的国内外研究进展,对不同研究者提出的选择和富集反硝化聚磷菌的方法进行了分析和评价,并提出将反硝化聚磷菌与移动床生物膜反应器工艺结合起来,在序批式移动床生物膜反应器悬浮填料上选择和富集反硝化聚磷菌,进一步认识了反硝化聚磷菌的生化特征,使其成为反应器中优势菌群,以及该工艺今后的研究重点。     

基于CFD的内构件强化内循环流化床流场结构分析

针对流化床内部流体结构的复杂性和缺乏有效放大设计理论的问题,以漏斗型导流内构件强化的内循环流化床的气液运动为研究对象,利用欧拉-欧拉双流体模型构建了能描述其复杂流动的CFD数学模型,通过宏观流场、气含率分布、液体速度分布解析内构件对气液混合传质的作用原理.数值模拟结果表明:双流体模型能较好地揭示流化床内气液流场结构,流...     

Turbosorp湍流吸收循环流化床烟气脱硫技术在改造工程中的应用

循环流化床半干法烟气脱硫技术是目前世界上主流脱硫工艺技术之一,主要适用于大中型燃煤电厂的烟气脱硫,在国内外拥有大量成功运行的工程案例。本文章基于本公司实践论述Turbosorp湍流吸收循环流化床脱硫技术的技术特点、关键工艺控制要点以及在机组改造工程中的技术优势,为同类型机组改造工程中的方案选择提供参考。     

Enhanced struvite recovery from wastewater using a novel cone-inserted fluidized bed reactor

The feasibility of struvite recovery at low （12.5 mg/L） and high （120 mg[L） phosphorus concentrations was studied by constructing a novel fluidized bed reactor with cones （FBRwc） and without cones （FBRwoc）. The crystallization process was continuously operated for 133 days under different hydraulic retention times （HRT = 1-10 hr）, pH （7.5-10）, and molar ratios of Mg/P （0.75-1.75）, N/P （1-10） and Ca/Mg （0-2）. The optimum operating conditions of HRT, pH, Mg/P and N/P molar ratios were found to be 2 hr, 9, 1.25, and 7.5, respectively. Under these optimum conditions, the phosphorus precipitation efficiencies of FBRwc were 93% for low and 98% for high phosphorus influent; however, the efficiencies were 78% and 81% for FBRwoc, respectively. Due to crystal losses at each junction （17%-31%）, the crystal recovery efficiency of FBRwoc was relatively low （47%-65%） for both influent concentrations. However, the losses were minimal in FBRwc, which showed 75% and 92% crystal recovery for low and high phosphorus concentrations, respectively. At low calcium concentration, crystal chemical analysis showed the product to be pure struvite （〉 99%）. The scanning electron microscope and X-ray diffraction results further confirmed that the crystal recovered from FBRwc contained pure struvite, which could be considered a high quality fertilizer. Except HRT, all parameters （pH, Mg/P, N/P and Ca/Mg） were found to be influencing factors for FBRwc performance. Overall, inserting cones in each part of the reactor played a significant role in enhancing struvite recovery from a wide range of phosphorus-containing wastewater.