MBBR处理制药废水的试验研究

采用二级移动床生物膜反应器(MBBR)处理呋喃铵盐制药废水。在填充比为40%,总水力停留时间为32h时,COD的去除率为88.6%,TN的去除率为25.7%,第二级反应器对NH3-N的去除率为56.2%。     

超重力技术治理火炸药行业氮氧化物的初步研究

火炸药行业排放氮氧化物(NOX)具有浓度高、排放点不集中和间歇排放的特点,采用超重力技术对尾气中高浓度的NOX进行湿法吸收.以清水为吸收剂,研究了进气量、液气比和超重力因子等因素对NOX吸收率的影响.结果表明,单级NOX吸收率可达64.69%(β＝90).超重力旋转填料床具有占地面积小、投资低和操作方便等优点,适宜于火炸药行业吸收NOX.     

低COD浓度废水启动EGSB反应器

以厌氧活性污泥和好氧活性污泥接种于2个膨胀颗粒污泥床(EGSB)反应器中,进水流量为10 mL/min,回流量为180 mL/min,进水COD浓度在180 mg/L左右,有机负荷率(OLR)为1.728 kg COD/m3·d左右,污泥负荷率(SLR)为0.19 kg COD/kg MLSS·d左右,出水COD浓度维持在40mg/L左右,COD去除率达80%以上.控制温度在32～35 ℃,pH在6.8～7.2,反应器内氧化还原电位在-340 mV以下,水力停留时间(HRT)4.2 h,上升流速4.86 m/h以及加入80 mg/L絮凝剂(硫酸铝钾),缩短了启动时间,促进了颗粒污泥的形成.分别经过60 d和120 d运行,反应器启动成功.结果表明,上升流速、絮凝剂和污泥类型对颗粒污泥的形成有影响;接种好氧活性污泥在低浓度COD下,合理控制负荷速率能成功启动EGSB反应器.     

MBBR与A/O法对污水中有机物及氮处理效果的研究

实验在不同水力停留时间（HRT）、进水COD浓度和不同COD容积负荷条件下考察了移动床生物膜反应器（MBBR）和活性污泥A/O工艺对污水中有机物及氮的处理效果。结果表明,MBBR工艺去除有机物和脱氮效果均优于A/O工艺。在进水COD和NH₃－N浓度分别为1000和25 mg/L,HRT为8 h时,MBBR的COD和TN去除率分别为92％和94％,而A/O工艺分别为78％和82％。造成这种结果的原因是MBBR的生物活性高,并且在生物膜内发生了同时硝化反硝化。MBBR脱氮能力受COD冲击明显小于A/O,但在较低进水COD浓度下,两者TN去除率均较低。     

青藏高原生活污水处理及回用的工艺研究

在高寒缺氧的青藏高原如何对生活污水进行有效的处理,目前仍无好的解决方案。实验采用的生态大棚系统可在青藏高原的恶劣环境下提供适宜的人工小环境,保证生物处理正常运行所必需的热平衡、O2-CO2的循环平衡和水循环的平衡。采用的好氧生物-土地处理工艺不仅能保证污水处理达到国家一级排放标准,同时还解决了长期以来高原蔬菜种植的难题。     

广西合浦海草床面临的威胁与保护对策

2003年7月对广西合浦海草床进行了现场调查,并对海草床周围利益相关者进行抽样问卷调查.结果表明当地社会经济发展和居民生活对海草所在的海域依赖程度比较高;合浦海草床目前所面临的威胁主要以人为破坏因素为主:挖沙虫、挖螺、耙螺,围网捕渔、电鱼虾,插桩养蚝,底拖网作业等;海草床退化的因果链分析结果表明,为增加经济收入是产生这些人为破坏因素的主要原因.最后综合分析了该区域海草保护与管理所面临的主要问题,并提出了相应的保护对策.     

Emissions of SO2, NO and N2O in a circulating fluidized bed combustor during co-firing coal and biomass

This paper presents the experimental investigations of the emissions of SO2, NO and N2O in a bench scale circulating fluidized bed combustor for coal combustion and co-firing coal and biomass. The thermal capacity of the combustor is 30 kW. The setup is electrically heated during startup. The influence of the excess air, the degree of the air staging, the biomass share and the feeding position of the fuels on the emissions of SO2, NO and N2O were studied. The results showed that an increase in the biomass shares resulted in an increase of the CO concentration in the flue gas, probably due to the high volatile content of the biomass. In co-firing, the emission of SO2 increased with increasing biomass share slightly, however, non-linear increase relationship between SO2 emission and fuel sulfur content was observed. Air staging significantly decreased the NO emission without raising the SO2 level. Although the change of the fuel feeding position from riser to downer resulted in a decrease in the NO emission level, no obvious change was observed for the SO2 level. Taking the coal feeding position R as a reference, the relative NO emission could significantly decrease during co-firing coal and biomass when feeding fuel at position D and keeping the first stage stoichiometry greater than 0.95. The possible mechanisms of the sulfur and nitrogen chemistry at these conditions were discussed and the ways of simultaneous reduction of SO2, NO and N2O were proposed.     

Anaerobic tapered fluidized bed reactor for starch wastewater treatment and modeling using multilayer perceptron neural network

Anaerobic treatability of synthetic sago wastewater was investigated in a laboratory anaerobic tapered fluidized bed reactor(ATFBR) with a mesoporous granular activated carbon(GAC)as a support material.The experimental protocol was defined to examine the effect of the maximum organic loading rate(OLR),hydraulic retention time(HRT),the efficiency of the reactor and to report on its steady- state performance.The reactor was subjected to a steady-state operation over a range of OLR up to 85.44 kg COD/(m~3.d).The COD removal efficiency was found to be 92% in the reactor while the biogas produced in the digester reached 25.38 m~3/(m~3·d) of the reactor. With the increase of OLR from 83.7 kg COD/(m~3.d),the COD removal efficiency decreased.Also an artificial neural network(ANN) model using multilayer perceptron(MLP)has been developed for a system of two input variable and five output dependent variables. For the training of the input-output data,the experimental values obtained have been used.The output parameters predicted have been found to be much closer to the corresponding experimental ones and the model was validated for 30% of the untrained data.The mean square error(MSE)was found to be only 0.0146.     

液-固流化床回收印刷线路板中金属的研究

根据废弃印刷线路板中材料密度不同,采用水介质流化床对印刷线路板粉末中的金属进行回收,对0.25～0.177、0.177～0.104、0.104～0.074和-0.074 mm 4个粒级范围内的物料进行分选试验。试验结果表明,在上述4个粒级范围内,随介质流速的增大,金属回收率降低;金属回收率η与实际操作速度（ua）和颗粒终端沉降速度（ut）的比值φ（ua/ut）存在一定线性关系,分析模拟了η与φ之间的相关性方程,外推试验的结果证明了相关性方程的可靠性;在合适的操作条件下,各粒级范围内金属的回收率分别为95.02%、90.07%、87.5%和92.68%。     

循环流化床锅炉掺烧高炉煤气的应用

介绍了高炉煤气的主要燃烧特性,分析了高炉煤气在循环流化床锅炉中掺烧时对炉膛换热、过热蒸汽温度、锅炉负荷、热效率、分离装置以及环境的影响,并提出了消除不良影响的相应措施。