土壤有机质含量测定方法的改进研究

通过研究改进了土壤有机质含量的测定方法。首先称取适量土壤置于长管消解系统中进行消解,然后采用全自动电位滴定仪进行滴定,直接获得土壤的有机质含量。使用该方法测定的土壤标准样品的有机质含量均在保证值以内,同时对实际样品进行精密度测试,得到相对标准偏差为1．03％。该方法降低了土壤有机质含量检测的实验成本,减少了环境污染,同时提高了实验数据的准确度与精密度,值得推广。     

Chloride Released from Three Permeable Pavement Surfaces after Winter Salt Application

Few studies exist on how chloride from chloride‐based deicers is transported in infiltration‐based stormwater control measures. In 2009, the U.S. Environmental Protection Agency (USEPA) constructed a 0.4 ha parking lot in Edison, New Jersey, that was surfaced with permeable interlocking concrete pavers (PICP), pervious concrete (PC), and porous asphalt (PA). Each surface type has four equally sized, lined sections that direct all infiltrate to separate 5.7 m³ collection tanks. The USEPA acute criterion for aquatic life (860 mg/l) was exceeded in events immediately following a snow event. Concentrations of the infiltrate exceeded the detection limit (5 mg/l) year round but did not exceed the USEPA chronic toxicity (230 mg/l) after April. The chloride concentration decreased with cumulative rainfall since previous snow event, and a power regression described this relationship. In the power regression, the coefficient (b) described the initial concentration following a snow event, and the exponent (m) described the rate in which chloride was flushed through the system with infiltrating water. PC had the largest coefficient (5,664) and largest absolute exponent (?0.92), followed closely by PICP (b = 4,943 and m = ?0.87), and distantly by PA (b = 2,907 and m = ?0.67). The differences in release rate were proportional to the measured surface infiltration rates of 4,000; 2,400; and 200 cm/h for PC, PICP, and PA, respectively. These results will assist those who manage or regulate stormwater where receiving waters are chloride impaired.     

用碳化法从制碱废渣一次盐泥中制取轻质氧化镁的研究

本研究是用制碱废渣一次盐泥作原料，采用二氧化碳碳化法制取轻质氧化镁。同时分析了提取轻质氧化镁后的残渣用于制造水泥或其它胶凝材料的原料的可行性。     

SnAgCu焊料中Sn元素在模拟土壤溶液中的浸出行为

研究了Sn-3.5Ag-0.75Cu无铅焊料及其与Cu基板的钎焊接头在模拟土壤的NaCl,NaCl-Na2SO4和NaCl-Na2SO4-Na2CO3溶液中Sn元素的浸出行为.结果表明:焊料在NaCl-Na2SO4-Na2CO3溶液中Sn的浸出相对严重;而接头在NaCl溶液中Sn的浸出量最多.在Sn浸出量多的焊料和接头表面形成厚而疏松的腐蚀产物,XRD分析表明其产物主要由SnO,SnO2和Sn4(OH)6Cl2组成.动电位极化测试分析表明接头中Cu基板与焊料合金之间的电偶腐蚀是焊料合金与接头在同种溶液中Sn元素浸出差异的主要原因.     

Sewage sludge disintegration by high-pressure homogenization: A sludge disintegration model

High-pressure homogenization (HPH) technology was applied as a pretreatment to disintegrate sewage sludge. The effects of homogenization pressure, homogenization cycle number, and total solid content on sludge disintegration were investigated. The sludge disintegration degree (DDCOD), protein concentration, and polysaccharide concentration increased with the increase of homogenization pressure and homogenization cycle number, and decreased with the increase of sludge total solid (TS) content. The maximum DDCOD of 43.94% was achieved at 80 MPa with four homogenization cycles for a 9.58 g/L TS sludge sample. A HPH sludge disintegration model of DD_COD= kN^aP^b was established by multivariable linear regression to quantify the effects of homogenization parameters. The homogenization cycle exponent a and homogenization pressure exponent b were 0.4763 and 0.7324 respectively, showing that the effect of homogenization pressure (P) was more significant than that of homogenization cycle number (N). The value of the rate constant k decreased with the increase of sludge total solid content. The specific energy consumption increased with the increment of sludge disintegration efficiency. Lower specific energy consumption was required for higher total solid content sludge.     

地下空间在节能减排中的应用及展望

在能源短缺和环境污染的双重压力下,我国出台多项措施加大节能减排力度。总结概括了地下空间的几种类型,认为盐岩洞穴、废弃矿洞、废弃油井、枯竭油气层等地下空间经过技术改造,可以埋存CO2、固体垃圾、废弃核原料,储存油气,地热利用等,能创造可观的社会价值和环境保护效益,可作为节能减排的一种有效措施。以山东地区为例,调研分析了山东多处地下空间利用现状,给出了地下空间的三种发展方向。     

几种表面防护体系耐盐雾性能研究

目的通过对比试验室加速腐蚀试验结果,获得耐盐雾腐蚀性能最佳的表面防护体系。方法选用2024铝合金的几种不同表面防护体系,进行盐雾腐蚀试验。通过宏观腐蚀形貌和涂层失光率变化来分析判定表面防护体系耐腐蚀性能,获得抗腐蚀性能优异的表面防护体系。结果综合内外部防护体系宏观腐蚀形貌和失光率情况来看,阿洛丁氧化和所配套的三套涂层系统的盐雾适应性较差。结论内部防护体系推荐采用铬酸阳极化+10P4-X底漆防护体系;外部防护体系推荐采用铬酸阳极化+10P20-X底漆+ECL面漆防护体系。     

成都市典型非道路工程机械排气烟度分析

采用不透光烟度计采集了成都市典型工程机械(挖掘机、装载机、叉车和压路机)排气烟度,研究了机械功率对其活动水平(燃油消耗量和年均工作时间)的影响,同时也研究了机械发动机构造和机械排放标准对其排气烟度的影响;同时,采用氮硫测定仪分析了机械油品硫含量,研究了硫含量对其排气烟度的影响.试验结果表明:机械功率越大的工程机械,燃油消耗量和年均工作时间数越高.成都典型工程机械排气烟度排放水平最低的为装载机,最高的为压路机;同时,超高排放装载机与叉车的占比较高.工程机械排气烟度受机械发动机排量、机械发动机构造、机械发动机排放标准和机械用油的综合影响,通过对工程机械装配电控发动机、提高原机排放标准和使用低硫燃油均能直观反映出机械排气烟度不同程度的改善.此外,油品中硫含量越高,机械排气烟度越大.     

闽江口秋茄红树林凋落物产量及分解动态

于2017年以闽江口粗芦岛秋茄(Kandelia obovata)红树林为研究对象,分别采用凋落物收集框和分解袋法,研究秋茄凋落物产量及其碳(C)、氮(N)、磷(P)含量月动态及凋落叶分解过程中C、N、P含量与水解酶活性.结果表明:①秋茄凋落物年产量为618.79 g·m~(-2)·a~(-1),其中,叶占61.2%,果、枝和花分别占23.7%、10.5%和4.6%.②凋落叶总氮(TN)含量8月显著高于其他月份(p0.05),而TP含量在1—3月显著高于其他月份;C/N在8月显著低于其他月份(p0.05),而C/P及N/P在9月显著升高(p0.05).③在凋落叶分解过程中,C、N、P含量及其化学计量比随时间存在明显差异(p0.01),并且地上组TC、TN、C/N和C/P明显不同于地下组(p0.05).④在分解过程中,4种水解酶随时间存在明显差异(p0.01).⑤凋落叶酸性磷酸酶活性与土壤温度、电导率和凋落叶TP含量存在显著相关关系(p0.01).这些结果说明,秋茄凋落物产量及元素含量随季节变化存在明显差异;沉积作用对凋落叶分解过程中元素含量有显著影响,水解酶活性主要受凋落叶元素含量和土壤环境因子的控制.     

基于多源遥感数据的锡尔河中下游农田土壤水分反演

机器学习结合多源遥感数据反演土壤水分含量（SMC）是目前SMC研究的热点,因较少考虑温度、蒸散等重要SMC影响因子,反演结果存在一定的不确定性。利用Sentinel-1影像、MODIS产品和SRTM数据,提取雷达后向散射系数等32个SMC影响因子,经相关分析选择27个显著的SMC影响因子（P<0.05）作为反演因子,并设计三组因子组合。这三组因子组合分别与随机森林、支持向量回归、BP神经网络三种机器学习方法结合,发现基于随机森林结合所有因子的方案,其SMC反演精度最高,该组合均方根误差RMSE为0.039 m³/m³,将该方案被用于反演2017年生长季锡尔河流域中下游平原区农田SMC。结果表明：从上部至下部SMC总体呈逐渐增加的态势,但存在显著时空差异,春季和秋季SMC较高而夏季较低。SMC差异主要由土壤质地、热量条件和地表植被状况差异引起。春季平原区下部农田SMC要高于上部,SMC的主控因子是土壤质地和地表植被状况;在夏季,土壤水分的主控因子是热量条件,农田灌溉弥补了热量条件差异对土壤水分的影响,导致空间上平原上部和下部土壤SMC空间差异不显著;秋季SMC的主控因子植被状况抵消地表温度和土壤质地差异对SMC的影响,使得秋季SMC空间差异不显著。本文采用的研究方法在一定程度上克服了因考虑SMC影响因子不足而获取更高SMC精度的限制。