甲胺磷农药废水生化处理高效菌选育的研究

从用甲胺磷农药废水长期驯化的活污泥中，筛选得到两株降解甲胺磷农药废水中有机磷的高效菌，经鉴定一株为蜡样芽孢杆菌（Ｂａｃｉｌｌｕｓｃｅｒｅｕｓ）。另一株为嗜中温假单胞菌（Ｐｓｅｕｄｏｍｏｎａｓｍｅｓｏｐｈｉｌｉｃａ）。确定了上述高效菌的最适生长条件和降解有机磷的能力，混合高效菌的有机磷去除率达９９．７％。     

An experimental investigation into micro ball end-milling of silicon

Silicon is a representative operational material for semiconductor and micro-electronics. In certain MEMS applications, it is required to fabricate three dimensional channels and complex pattern on silicon substrate. Such features are typically fabricated by photolithography and chemical etching. These processes have low productivity and have certain other limitations. Therefore, a viable switch-over from non-traditional fabrication processes to traditional machining is highly desired for improved productivity in high-mix low-volume production. However, machining of silicon by traditional process is extremely difficult due to its high brittleness. Even very small forces produced during machining can cause brittle fracture on silicon surface resulting in deteriorated surface quality. The fundamental principle in machining of a brittle material such as silicon is to achieve material removal through plastic deformation rather than crack propagation. This paper presents the experimental results of ductile-mode machining of silicon by micro ball end-milling. The workpiece surface was inclined to the rotational axes of the cutter to improve the surface finish. It was established experimentally that 15-μm deep, fracture-free slots can be machined on silicon wafer by micro ball end-milling if the feed rate is below a certain threshold. The influence of several machining parameters on the roughness of machined-surface was also investigated. Cubic boron nitride (CBN) is presented as much economical alternative tool-material to single-crystal diamond for machining silicon in ductile-mode.