COD浓度和进水流量比对一体化工艺脱氮除碳的影响

保持进水总流量不变,以一定流量比同时从缺氧区和厌氧区进水,探讨了不同进水流量比(R=Q_厌/Q_缺)和进水COD浓度对中心岛式一体化OCO工艺脱氮除碳的影响。研究结果表明,进水COD浓度和进水流量比Rs对COD的去除效果影响不大,出水COD浓度一直稳定在50 mg/L以下,去除率在92%以上;进水COD浓度和进水流量比Rs共同决定着系统TN的去除效果,进水COD浓度为100 mg/L、200 mg/L时,TN去除率随着进水流量比Rs的减小呈增加的趋势;当进水COD浓度为 300 mg/L时,TN去除率随着进水流量比Rs的减小呈先升高后降低的趋势,在进水流量比Rs为3∶1时TN去除率最高,达到87%。     

鄱阳湖枯水水位及流速时空分布模拟

大型通江湖泊鄱阳湖水文节律独特,水位和流速是其生态系统功能维持的关键因子。为探究其水位和流速时空特征,基于EFDC(Environmental Fluid Dynamics Code)模型,利用五河及湖口水文数据、气象数据及湖底高程作为输入条件,模拟出鄱阳湖的枯水水文统计年(2010-07-01~2011-06-30)水位和流速时空变化过程。模拟结果表明:(1)星子等4个站点拟合程度较好(r20.85),达到了复杂湖库水动力模拟的精度。(2)高水位期,湖区水位空间分布无明显差异,水深直接受湖底高程影响,自上游至下游呈逐级递增;低水位期,鄱阳湖水位在空间上出现明显差异,湖区外缘水位至入江水道逐级递减,水深分布空间差异不大,仅入江水道处水深明显高于其他水域。(3)流速也包括一系列时空变化特征,如高水位时期流速小于低水位时期;除大水面时期外,深水道流速大于主湖区;高水位时期上游流速略高于下游,但其他月份,北部入江水道流速均大于南部湖区等。(4)流速与水位关系密切,且不同水位对应流速大小及分布有所差异。鄱阳湖枯水水位和流速模拟分析可为大型湖库枯水水情管理提供科学参考和辅助决策支持。     

Remove cooking fume using catalytic combustion over Pt/La-Al2O3

Five monolithic catalysts with low noble metal content were prepared by irnmerge method （Pt/γ=Al2O3, Pt/La-Al2O3, Pt/YSZ-AI203, Pt＋Pd/La-Al2O3 and Pd/La-Al2O3） and their activity measurements were carried out in a conventional fixed-bed flow reactor. The results show that La-Al2O3 can promote activity of the prepared catalysts and can decrease the complete conversion temperature of cooking fume. The Pt/La-Al2O3 catalyst has the highest activity and can be applied in wide range of gas hourly space velocity （GHSV）. Some characterizations （XRD, TPR） were carried out with the objective to explain differences in catalytic behaviors. The prepared catalyst showed a great potential for application.     

速度场常数及其自动检测装置

通过对烟道“速度场常数”的研究,提出利用速度场常数监测烟道烟气平均流速的方法,同时研制出速度场常数自动检测装置。解决烟道烟气平均流速自动监测的技术难题。     

Carrousel氧化沟单个表曝机流态的模型试验和分析比较

对仅安装1个倒伞形表面曝气机(简称表曝机)的Carrousel氧化沟模型进行了水力学测定,通过颗粒动态分析仪(PDA)系统分析流出和流入表曝机一侧的液体流动速度、沉降速度,以及固体含量分布.结果表明,流出表曝机一侧,距表曝机较近的x轴位置流速较大;沉降速度沿y轴有个转折点,位于沟壁与挡板的中间;远离单个表曝机,固体含量逐渐增大.并将单个表曝机的测量结果与氧化沟内安装2个表曝机的流动试验进行比较,发现2个表曝机所产生的流场与单个表曝机产生的流场差别较大,且2个表曝机所产生的流场更稳定.      

袋式除尘用滤料集尘性能的冷态测定及分析

对袋式除尘常用的针刺毡、基布覆膜、梯度针刺毡三类滤料进行集尘状况下压力损失冷态实验测试。结果表明:清洁滤料压力损失由大到小分别为基布覆膜滤料、梯度针刺毡、常规针刺毡;清洁滤料的压力损失与过滤速度呈正比线性变化关系,集尘后与过滤时间、粉尘负荷呈正比二次方变化关系,并通过分析给出滤料在不同集尘负荷下阻力与过滤风速、粉尘负荷间的计算关系。     

Seismic monitoring and modelling of supercritical CO2 injection into a water-saturated sandstone: Interpretation of P-wave velocity data

This paper reports on an integrated laboratory and numerical simulation study of ultrasonic P-wave velocity response to supercritical CO₂ displacement of pore water in Tako sandstone. The analysis of dynamic velocity data recorded using an array of piezoelectric transducers mounted on a core sample showed that the P-wave velocities at different positions displayed a similar trend in time, i.e., an initial sharp fall followed by a more gradual decline. Considerable variations observed in the measured P-wave velocity reductions across the sandstone core could largely be attributed to the final state of saturation (e.g. uniform, patchy or in-between) attained by the two-phase fluids. Numerical simulation of the injection test using a simple 1D model was carried out to provide an estimation of the phase saturation changes underlying the measured P-wave velocity reductions. A second order polynomial correlation between the measured ultrasonic P-wave velocity reductions and the estimated CO₂ saturation was established. Comparison with the Gassmann velocities showed that the empirically established relationship marks a clear deviation from both the patchy and uniform saturation velocity curves.     

Determination of the maximum effective burning velocity of dust–air mixtures in constant volume combustion

The reactivity of a combustible dust cloud is traditionally characterized by the so-called K_St value, defined as the maximum rate of pressure rise measured in constant volume explosion vessels, multiplied with the cube root of the vessel volume. The present paper explores the use of an alternative parameter, called the maximum effective burning velocity (u_eff,max), which also is derived from pressure–time histories obtained in constant volume explosion experiments. The proposed parameter describes the reactivity of fuel–air mixtures as a function of the dispersion-induced turbulence intensity. Procedures for estimating u_eff,max from tests in both spherical and cylindrical explosion vessels are outlined, and examples of calculated values for various fuel–air mixtures in closed vessels of different sizes and shapes are presented. Tested fuels include a mixture of 7.5% methane in air, and suspensions of 500 g/m³ cornstarch in air and 500 g/m³ coal dust in air. Three different test vessels have been used: a 20-l spherical vessel and two cylindrical vessels, 7 and 22 l. The results show that the estimated maximum effective burning velocities are less apparatus dependent than the corresponding K_St values.     

低瓦斯综采放顶煤工作面通风除尘的研究

通过对低瓦斯综采放顶煤工作面的研究,选择了合理的通风方式和最优排风速和,即有利于工作面降温,保证了工作面安全生产.     

某金铜矿山含铜酸性废水处理研究

采用石灰调pH—铁屑置换—石灰沉淀处理工艺对废水进行试验，结果表明，采用该工艺处理含铜酸性矿山废水，不仅能使处理后的水满足排放标准，同时还能回收废水中的铜。