动态污水处理过程的多模型动态矩阵控制

针对活性污泥法污水处理系统的强耦合和动态变化特性,提出一种用于前置反硝化脱氮工艺的多模型动态矩阵(DMC)解耦控制方法;通过K-均值聚类分析法对外界入水中氨氮浓度进行聚类,获得以聚类中心为入水氨氮浓度的静态模型集合,分别设计线性DMC解耦控制器;再以当前时刻外界进水氨氮浓度和聚类中心为基本元素,构造切换函数,实现多模型切换。将该方法应用于活性污泥1号模型(ASM1)中,获得了较好的动态仿真效果。     

改进的TLI指数法及其在巢湖营养状态评价中的应用

对巢湖2000—2008年的监测数据运用SPSS做统计分析,得出叶绿素a与总氮、总磷和透明度的相关系数。通过得出的权重结果,分析出与26个湖泊的差异性,构建了改进的综合营养状态指数(TLI)评价方法,并提出评价的4个步骤。以巢湖为例,运用该方法对湖泊的营养状态进行评价,且对巢湖的富营养化程度做了年际和年内变化的综合评价,评价结果显示各营养物指标的相关关系在近30年有了较大变化,巢湖的富营养化现象已日益严重,已从轻度富营养化状态转变为中度富营养化状态。     

碱式硫酸铝溶液中SO42-的测定

建立了以铬黑T为指示剂,乙二胺四乙酸二钠反滴定过量BaCl₂的碱式硫酸铝溶液中SO₄^2-的测定方法。实验确定的操作条件为：待测试样稀释后ρ（SO_4^2-）为0.025 ~0.100 g/L,BaCl₂过量率为25%~100%,并且在加入BaCl₂前将试样煮沸,三乙醇胺加入量为0.10 L/L。该法回收率在98.90%~100.72%,相对标准偏差小于1%。测定方法准确,可靠,且操作简便、快速。     

多溴联苯醚降解和分析研究进展

介绍了多溴联苯醚(PBDEs)在环境中的分布情况,综述了近年来国内外对PBDEs测定方法以及化学催化降解、生物降解和热解等PBDEs降解技术的研究进展,并对PBDEs研究的未来发展方向进行了展望。     

不同来源废水COD、TOC与Cl-的关系

通过对含盐化工废水(A)、受潮汐影响的河流水(B)、城市生活污水处理厂排水(C)、采油废水(D)4种不同来源废水进行为期15 d的采样监测,测定了其COD、TOC和Cl-浓度,分析比较了3种废水指标之间的关系,其中COD分别使用重铬酸钾法、氯气校正法和碘化钾碱性高锰酸钾法3种方法进行测定.实验结果表明,4种废水Cl-浓...     

A hybrid method for quasi-three-dimensional slope stability analysis in a municipal solid waste landfill

Limited space for accommodating the ever increasing mounds of municipal solid waste (MSW) demands the capacity of MSW landfill be maximized by building landfills to greater heights with steeper slopes. This situation has raised concerns regarding the stability of high MSW landfills. A hybrid method for quasi-three-dimensional slope stability analysis based on the finite element stress analysis was applied in a case study at a MSW landfill in north-east Spain. Potential slides can be assumed to be located within the waste mass due to the lack of weak foundation soils and geosynthetic membranes at the landfill base. The only triggering factor of deep-seated slope failure is the higher leachate level and the relatively high and steep slope in the front. The valley-shaped geometry and layered construction procedure at the site make three-dimensional slope stability analyses necessary for this landfill. In the finite element stress analysis, variations of leachate level during construction and continuous settlement of the landfill were taken into account. The "equivalent" three-dimensional factor of safety (FoS) was computed from the individual result of the two-dimensional analysis for a series of evenly spaced cross sections within the potential sliding body. Results indicate that the hybrid method for quasi-three-dimensional slope stability analysis adopted in this paper is capable of locating roughly the spatial position of the potential sliding mass. This easy to manipulate method can serve as an engineering tool in the preliminary estimate of the FoS as well as the approximate position and extent of the potential sliding mass. The result that FoS obtained from three-dimensional analysis increases as much as 50% compared to that from two-dimensional analysis implies the significance of the three-dimensional effect for this study-case. Influences of shear parameters, time elapse after landfill closure, leachate level as well as unit weight of waste on FoS were also investigated in this paper. These sensitivity analyses serve as the guidelines of construction practices and operating procedures for the MSW landfill under study.     

ZnO/LixNi1-xO光催化降解甲基橙的研究

采用溶胶凝胶法制备LixNi1-xO和ZnO粉体,利用球磨法制备ZnO/LixNi1-xO复合粉体,以紫外光为光源,通过降解甲基橙,研究了锂掺杂及n-p复合对氧化镍的光催化性能影响。结果表明：当投放量为0.1 g/L,x≤0.075（摩尔分数）的锂掺杂氧化镍均比未掺杂氧化镍的光催化活性高。当锂掺杂摩尔分数为0.025,投放量为0.4 g/L时锂掺杂氧化镍的光催化活性最佳,甲基橙最高降解率达到93.1%。当ZnO/Li0.025Ni0.975O在质量比为1∶1,投放量为0.2 g/L时光催化活性最佳,甲基橙最高降解率达到98.1%。     

火电厂CO2捕集与封存技术探讨

火电厂CO2减排技术主要包括燃烧前处理、燃烧中减排及燃烧后捕集三类。介绍了IGCC、富氧燃烧、胺吸收法、生物法等CO2捕集与封存技术,分析其存在问题及应用前景。     

水下公路隧道纵向疏散通道加压送风系统研究

为研究水下公路隧道纵向疏散通道加压送风系统的关键设计参数,结合纵向疏散通道的特点,借鉴一般建筑加压送风系统的设计要求,提出了纵向疏散通道内加压送风量的计算方法,并通过数值模拟方法对纵向疏散通道加压送风系统进行了研究。结果表明,利用风速法计算得到的送风量比压差法计算得到的结果大20倍左右,并且压差法计算送风量时受疏散口缝隙宽度影响较大,工程适用性差。通过数值模拟可知,疏散通道内的送风风速达到1.5m/s时即能够满足人员安全疏散要求,这与风速法计算的结果一致。研究结果可供采用纵向疏散模式的隧道疏散通道加压送风系统设计参考。     

断裂构造对斜坡应力场影响的数值模拟及成灾机理研究

断裂构造及活动强度对斜坡体的应力场分布具有重要的影响。采用基于强度折减法的有限元法,分别以正断层和逆断层与斜坡体的组合关系为例,剖析了断裂构造对斜坡体应力场的影响及成灾机理,揭示了含有断层的斜坡体塑性区的贯通过程。研究表明,包含断层的斜坡体在应力分布特征及斜坡变形破坏机理方面与无断层的斜坡体有较大差别:含断层的斜坡体在坡面和断层面附近的最大主应力迹线与坡面或断层面相平行,在天然状态下,塑性区同时出现在坡脚和断层面后方,随着折减系数的增大,塑性区分别从坡脚和断层面后方向坡体深部和上部发展,直至断层面前后两个塑性区相贯通,坡体发生破坏,并且对坡体变形破坏的影响程度以逆断层最强,其次为正断层,断层不活动时较弱。