不同Fe(Ⅲ)对活性污泥异化铁还原及除磷影响研究

以SBBR反应器活性污泥作为铁还原菌菌种来源,采用兼性厌氧/严格厌氧恒温培养试验,投加不同Fe(Ⅲ)考察各条件下的异化铁还原能力同时比较对磷的去除效果.结果表明:2种条件下Fe(Ⅲ)还原能力具有较好的一致性,依次为:Fe(OH)3＞氧化铁皮＞青矿＞红矿,其中严格厌氧条件下较好.同时,除磷效果与其呈正相关,富集培养至7d,Fe(OH)3及氧化铁皮体系出水磷浓度均达到2mg/L以下,之后继续降低,最终达到0.5mg/L以下.结合异化铁还原除磷机理,可以证明,不同Fe(Ⅲ)表面吸附作用对TP的去除贡献较小,其主要作用为铁还原菌驱动下的化学沉淀去除.     

Simultaneous preconcentration of cadmium and lead in water samples with silica gel and determination by flame atomic absorption spectrometry

A new method that utilizes pretreated silica gel as an adsorbent has been developed for simultaneous preconcentration of trace Cd(II) and Pb(II) prior to the measurement by flame atomic absorption spectrometry. The effects of pH, the shaking time, the elution condition and the coexisting ions on the separation/preconcentration conditions of analytes were investigated. Under optimized conditions, the static adsorption capacity of Cd(II) and Pb(II) were 45.5 and 27.1mg/g, the relative standard deviations were 3.2% and 1.7% (for n = 11), and the limits of detection obtained were 4.25 and 0.60 ng/mL, respectively. The method was validated by analyzing the certified reference materials GBW 07304a (stream sediment) and successfully applied to the analysis of various treated wastewater samples with satisfactory results.     

Numerical simulation of alga growth and control in Dalian Bay

WAHMO model was used to simulate the distribution of pollutants in Dalian Bay, China as to predict well as the growth and control of alga. The observed and predicted values of main pollutants showed a good trend at all study locations and the different between them can be ignored. Simulation results illustrated that phosphate was one of limited factors to control algal growth at the location near the sewage outfall, meanwhile, away from the sewage outfall, the synergy of ammonium nitrogen and phosphate was the limited factor.     

基于熵权的长沙市城市生态安全综合评估与预测

城市是一个社会-经济-自然复合生态系统,区域资源与城市自然系统是城市社会经济发展的重要基础和载体。城市生态安全评估是对未来的安全状态进行预测,以实现城市的可持续发展。文章以长沙市为例,在城市生态安全主要影响因素识别的基础上,应用PSR模型、熵权法等建立城市生态安全评估指标及计算方法,研究了长沙市近11年来生态安全的变化趋势。研究结果表明,1999-2009年间长沙生态安全的趋势由较不安全向较安全状态发展,生态安全值从25.4提高到60.7,人文环境响应是长沙生态安全改善的主导因素,资源环境压力,水土资源保持是限制长沙市生态安全的主要因素。     

基于生态足迹改进模型的生态安全及其预测研究

由William Rees提出的生态足迹模型已经成为近年来生态可持续发展的重要的度量工具,但是该模型仅考虑了土地的基本生产功能,忽视了土地生态系统的服务功能。文章借鉴生态系统服务功能理论改进了传统的生态足迹模型,将生态系统服务功能价值当量因子引入生态足迹模型均衡因子和产量因子的计算中,改进后的模型体现了生态系统功能的完整性;同时,文章以江苏省2010年的统计数据为基础,应用改进模型计算了其2010年生态压力指数,结果表明,江苏省生态压力指数达到1.495,其安全状况已经超过了极不安全边界,处于极不安全状态;最后利用灰色理论GM(1,1)模型对其2011-2015年的生态安全状况进行了预测,发现江苏省未来5年生态压力指数快速增大,年平均增长速度为6.89%,表明江苏省未来5年生态安全状况将继续恶化,这将严重影响其生态可持续发展和经济可持续发展。     

选矿废水污染的土壤铜量与生物累积的研究

通过对花石头河沿岸研究区植物的根部、茎叶进行采样分析,探讨了土壤铜含量和铜在植物体内的累积状况。结果表明,光叶蕨、三叶鬼针草、野牡丹、紫茎泽兰4种植物体内铜含量随着土壤铜含量的增加而增加,光叶蕨增量最大。植物根部铜生物累积系数(BF)与茎叶铜生物累积系数(BF)之间相关性不显著,但根部BF为1.311,茎叶BF为0.159,前者是后者的8.2倍。光叶蕨铜的累积能力最强,其次是紫茎泽兰,植物间铜生物累积系数没有显著性差异。各采样区土壤铜含量差异大,它们之间的差异达到显著性水平。无论是全株植物、根部,还是茎叶,BF值:公路边>山坡上>河边。青蒿铜的迁移系数(TF)最大,与其余植物的迁移系数存在显著性差异,而这4种植物之间铜的迁移系数没有显著性差异,不同采样区TF均值以公路边TF值最高,其次是河边,最后才是山坡上。     

Modulation-assisted high speed machining of compacted graphite iron (CGI)

The application of controlled, low-frequency modulation (～100 Hz) superimposed onto the cutting process in the feed-direction – modulation-assisted machining (MAM) – is shown to be quite effective in reducing the wear of cubic boron nitride (CBN) tools when machining compacted graphite iron (CGI) at high machining speeds (>500 m/min). The tool life is at least 20 times greater than in conventional machining. This significant reduction in wear is a consequence of the multiple effects realized by MAM, including periodic disruption of the tool–workpiece contact, formation of discrete chips, enhanced fluid action and lower cutting temperatures. The propensity for thermochemical wear of CBN, the principal wear mode at high speeds in CGI machining, is thus reduced. The tool wear in MAM is also found to be smaller at the higher cutting speeds (730 m/min) tested. The feed-direction MAM appears feasible for implementation in industrial machining applications involving high speeds.     

3D numerical investigation of thermally assisted high efficiency ductile machining of nanocrystalline hydroxyapatite

This study investigates the effects of four different variables (initial workpiece temperature, side rake angle, edge radius/feed rate, and nose radius/depth of cut) on ductile regime machining of a bioceramic material known as nanohydroxyapatite (nano-HAP) using 3D numerical simulation. AdvantEdge FEM Version 5.9 is used to conduct turning simulations of the nano-HAP workpiece. Tecplot 360 is used to analyze the results of the simulations. Because the workpiece is thin, the entire workpiece is set to a uniform initial temperature to simulate laser preheating of the material. Initial workpiece temperature, rake angle (side rake angle), edge radius, and nose radius are varied, and the effects of these operating conditions on critical feed are investigated. It is found that critical feed increases as initial workpiece temperature increases, and also as negativity of rake angle increases. For the edge radius, it is concluded that an initial increase causes an increase in critical feed – however, at some value of edge radius, critical feed shows no further increase; for the nose radius, critical feed appears to show no significant dependence.     

燃煤电厂电-袋复合式除尘器优化控制的仿真运行研究

以电-袋复合式除尘器为仿真研究对象,在Windows界面下利用Visual Basic6．0编程语言开发出燃煤电厂电-袋复合式除尘器优化控制的仿真运行软件。该软件通过建立数学模型,进行仿真实验,模拟工况变化、优化运行参数等对电-袋复合除尘系统进行整体的优化控制,并综合分析电-袋复合除尘器运行过程中的能耗以及运行费用,对运行电压、电流、运行阻力、喷吹周期等参数进行了优化。该仿真软件达到了电一袋除尘系统的节能降耗的目的,同时也降低了电～袋复合除尘器的运行成本。     

土地利用变化对土壤硝化及氨氧化细菌区系的影响

以西藏高原相邻的原始森林、天然草原和农田土壤为研究对象,分别采用室内培养法和nested PCR-DGGE技术,对比研究了这3个生态系统的土壤硝化势、硝态氮浓度以及土壤氨氧化细菌（AOB）菌群区系.结果表明,农田土壤的硝化势和硝态氮（NO 3--N）浓度显著高于相邻的草原和森林土壤,硝化势分别是森林和草原土壤的9倍和11倍,NO 3--N是农田土壤无机氮（Nmin）的主要成分,占无机氮的70%～90%.铵态氮（NH 4＋-N）则是森林和草原土壤中主要的无机氮形态.原始森林和天然草原间的硝化势和硝态氮浓度没有显著差异.原始森林的土壤AOB菌群数量、多样性及均匀度最低.天然草原生态系统转换为农田后,土壤AOB菌群的多样性和均匀度显著降低,但是农田土壤的AOB菌群结构仍与其前身草原生态系统有较高的相似性.原始森林的AOB菌群数量、多样性及均匀度最低直接导致了其硝化势最低;农田土壤的硝化势和硝态氮浓度最高意味着农田生态系统中优势AOB的活性最高.以上结果表明,土地利用变化导致土壤氮素内循环及其关键微生物AOB的多样性与活性均发生显著变化,这些变化会影响土壤环境质量以及生态系统的持续与稳定.