Observations on the influence of water and soil pH on the persistence of insecticides

Abstract

The pH‐disappearance rate profiles were determined at ca. 25°C for 24 insecticides at 4 or 5 pH values over the range 4.5 to 8.0 in sterile phosphate buffers prepared in water‐ethanol (99: 1 v/v). Half‐lives measured at pH 8 were generally smaller than at lower pH values. Changes in half lives between pH 8.0 and 4.5 were largest (>1000x) for the aryl carbamates, carbofuran and carbaryl, the oxime carbamate, oxamyl, and the organophosphorus insecticide, trichlorfon. In contrast, half lives of phorate, terbufos, heptachlor, fensulfothion and aldicarb were affected only slightly by pH changes. Under the experimental conditions described half lives at pH8 varied from 1–2 days for trichlorfon and oxamyl to >1 year for fensulfothion and cyper‐methrin. Insecticide persistence on alumina (acid, neutral and basic), mineral soils amended with aluminum sulfate or calcium hydroxide to different pH values and four natural soils of different pH was examined. No correlation was observed between the measured pH of these solids and the rate of disappearance of selected insecticides applied to them. These observations demonstrate the difficulty of extrapolating the pH dependent disappearance behaviour observed in homogeneous solution to partially solid heterogeneous systems such as soil.     

Enhancement of UV and chromate mutagenesis by nickel ions in the Chinese hamster HGPRT Assay †

1. The HGPRT (Hypoxanthine‐Guanine‐Phospho‐Ribosyl‐Transferase) assay with Chinese Hamster V79 cells was used to measure the mutagenic effects of UV irradiation, potassium dichromate and nickel chloride. The agents were tested separately and in the combinations of UV plus nickel and dichromate plus nickel.

2. UV, Cr(VI) and Ni(II) were confirmed to be mutagenic in the V79 cell assay. The combination of UV(5J/m²) and Ni(II) (0.5 mM) caused a mutation rate 11.2 times above that corresponding to the sum of the individual mutation rates of these agents. The combined action of Cr(VI) (0.1 mM) and Ni(II) (0.5 mM) produced a mutation rate 2.8 fold above that corresponding to the sum of the individual rates of the separate agents.

3. The enhancing effect of nickel chloride on the mutagenicity of UV or Cr(VI) is interpreted by an interference of Ni(II) with the repair of DNA lesions.     

Distribution and persistence of carbaryl in some terrestrial and aquatic components of a forest environment

Abstract

An oil‐based formulation of carbaryl (1‐naphthyl N‐methyl‐carbamate) (Sevin‐2‐Oil) was applied twice by a fixed‐wing aircraft at a dosage rate of 280 g of A.I./ha/application to a coniferous forest near Allardville, New Brunswick. The highest concentrations of the chemical in fir foliage, litter and forest soil 1 h after application were respectively 4.20, 1.21 and 0.59 ppm (fresh weight). The residues dissipated rapidly and the DT50 values obtained from the depletion curves were 2.3 d for foliage and 1.5 d for litter and soil samples. Very low levels (<0.1 ppm) of carbaryl persisted in foliage and litter beyond the 10 d sampling period. The maximum residue level found in stream water was 0.314 ppm and more than 50% of it had dissipated within 1 h. Low but detectable levels (0.001 ppm) of the chemical persisted in water until the end of the 10 d sampling period. Sediment samples contained a maximum level of 0.04 ppm, which dissipated below the detection limit within 5 h. Brook trout and slimy sculpins captured in the stream 1 d after the spray contained on average about 0.04 ppm of carbaryl and none of it was found in 3 d postspray samples.     

Effect of some herbicides on activities of microorganisms and enzymes in soil

Abstract

Laboratory tests were conducted with eight herbicides, atrazine, butylate, ethalfluralin, imazethapyr, linuron, metolachlor, metribuzin and trifluralin, applied to a loamy sand at rate of 10 μg/g to determine if these materials caused any serious effects on microbial and enzymatic activities related to soil fertility. Some herbicides showed an effect on bacteria and fungi for the first week of incubation, but, subsequently, the populations returned to levels similar to those obtained in the controls. After several herbicide treatments there appeared to cause a slight depression of nitrification. Sulfur oxidation was better than that obtained with untreated soil in all treatments. Oxygen consumption was increased significantly after 96 hr incubation with atrazine. The soil dehydrogenase and amylase activities were inhibited by ethalfluralin treatment respectively for 1 wk and 1 day, and p‐nitrophenol liberation was inhibited for 2 hrs by all herbicide treatments. Results indicated that the herbicidal treatments at the level tested were not drastic enough to be considered deleterious to soil microbial and enzymatic activities which are important to soil fertility.     

Accumulation and mobility of zinc in soil amended with different levels of pig-manure compost

Applying manure compost not only results in zinc accumulation in the soil but also causes an increase in zinc mobility and enhances zinc leaching. In this study, the physical and chemical characteristics of zinc, zinc profiles, and zinc balance were investigated to characterise the fate of zinc in fields where the quality and amount of pig manure compost applied have been known for 13 years. Moreover, we determined zinc fractionation in both 0.1 mol L^?1HCl-soluble (mobile) and -insoluble (immobile) fractions. Adsorption of zinc in the soil was enhanced with increasing total carbon content following the application of pig manure compost. The 159.6 mg ha^?1 year^?1manure applied plot (triplicate) exceeded the Japanese regulatory level after only 6 years of applying pig manure compost, whereas the 53.2 mg ha^?1 year^?1 manure applied plot (standard) reached the regulatory level after 13 years. The zinc loads in the plots were 17.0 and 5.6 kg ha^?1 year^?1, respectively. However, 5.9 % and 17.2 % of the zinc loaded in the standard and the triplicate pig manure compost applied plots, respectively, were estimated to be lost from the plough layer. Based on the vertical distribution of mobile and immobile zinc content, a higher rate of applied manure compost caused an increase in the mobile zinc fraction to a depth of 40 cm. Although the adsorption capacity of zinc was enhanced following the application of pig manure compost, a greater amount of mobile zinc could move downward through the manure amended soil than through non manure-amended soil.     

Leaching,mobility and persistence of tebufenozide in columns packed with forest litter and soil

Abstract

Leaching, downward mobility and persistence of tebufenozide was investigated under laboratory conditions in columns packed with forest litter and soil, after fortification with the analytical grade material (purity > 99.6%) and with two commercial formulations, RH‐5992 2F (aqueous flowable) and RH‐5992 ES (emulsion suspension). Two types of litter and soil were used: one type with relatively high amounts of sand and the other with high amounts of clay.

The concentrations eluted in the leachates were lower when the analytical material (dissolved in acetone) was used for fortification, than when the two formulations (diluted with water) were used. The amount leached was higher for RH‐5992 2F than for RH‐5992 ES. The type of substrate, i.e., sandy or clay type, had only marginal influence on the amounts eluted in the leachates. Downward movement of tebufenozide from the top 2‐cm layer to the untreated middle and bottom layers (3‐cm segments) was consistently lower when the analytical material was used for fortification, than when the two formulations were used. Downward movement was higher for RH‐5992 2F than for RH‐5992 ES. Persistence of tebufenozide in substrates, maintained under submerged conditions for 70 days after leaching, indicated an initial 2‐week lag period prior to the onset of degradation. Formulation‐related differences were observed in the half‐life (DT₅₀) values. When the analytical material was used for fortification, the DT₅₀ ranged from ca 54 to 59 d. However, when the formulations were used for fortification, the DT₅₀ showed a higher range, i.e., from ca 62 to 67 d for RH‐5992 2F and ca 70 to 80 d for RH‐5992 ES. Formulation ingredients appear to have caused enhanced adsorption of tebufenozide onto the substrates, thus delaying degradation.     

Fate of parathion in soil under sub‐tropical field conditions

Abstract

Persistence, metabolism and binding of ¹⁴C‐parathion in alkaline sandy loam soil under sub‐tropical conditions of Delhi were studied for 545 days. After 3 days of treatment, ¹⁴C‐residues declined to 41% of the amount applied. The dissipation curve was biphasic; an initial rapid phase (up to 7 days) followed by slow dissipation. The half life of dissipation was only 3.36 days for the first phase and 84 days for the slow phase. The overall half life was 64.5 days. The total residues at zero‐time were 10.65 μg/g dry soil and were almost totally extractable. The extracts consisted of parathion, 4‐aminophenol, 4‐nitrophenol and paraoxon. The bound residues gradually increased and accounted for the total residue at the end of one year (0.7 μg/g).     

电解法处理含镍废水及纯镍的回收

采用电解回收法处理Ni2+含量为2g/L的废水,在阴极回收纯镍。研究了电解电流、极距、NH4Cl浓度、pH值等因素对Ni2+去除率、槽压、阴极能耗的影响,得出最优工艺参数为:温度20℃,电解时间20min时、电解电流300mA,极距15mm,NH4Cl浓度5g/L,pH值8.0,该条件下Ni2+去除率为96.926%,槽压16.21V,阴极能耗22.418kW.h/kg,在阴极可得到沉积6.45μm厚的镍板。     

高台位旱地石灰性紫色土培肥研究

本文研究了高台位旱地石灰性紫色土的肥力退化因子,并针对紫色母岩矿质养分丰富、易风化成土的特点,以一种培肥耕作法-聚土免耕耕作法培肥土壤。结果表明,采用此耕作法的土壤具有防蚀、抗旱、培肥和自调能力,能提高系统生产力。     

APPLICATION OF A SEDIMENT ROUTING MODEL TO A MIDDLE EUROPEAN WATERSHED1

ABSTRACT: A simulation model that computes sediment yield due to sheet and rill erosion at the outlet of a large watershed requires daily precipitation and the soil, topographic, and vegetative characteristics of the watershed. An important problem, particularly in a large watershed, is the transport of sediment produced in the sub-watersheds to the outlet of the whole watershed. This problem is approached mathematically by a sediment routing model that is used as a component of the total model.