石油亚砜萃取巯基醋酸的研究

对石油亚砜(PSO)萃取巯基醋酸的条件和影响进行了实验研究,确定了石油亚砜通过氢键和巯基醋酸形成的萃合物的组成.为从废水中回收巯基醋酸以及石油硫醚的综合利用提供了依据.     

Concentrations of disinfection by-products in swimming pool following modifications of the water treatment process: An exploratory study

The formation and concentration of disinfection by-products (DBPs) in pool water and the ambient air vary according to the type of water treatment process used. This exploratory study was aimed at investigating the short-term impact of modifications of the water treatment process on traditional DBP levels (e.g., trihalomethanes (THMs), chloramines) and emerging DBPs (e.g., Halonitromethanes, Haloketones, NDMA) in swimming pool water and/or air. A sampling program was carried to understand the impact of the following changes made successively to the standard water treatment process: activation of ultraviolet (UV) photoreactor, halt of air stripping with continuation of air extraction from the buffer tank, halt of air stripping and suppression of air extraction from the buffer tank, suppression of the polyaluminium silicate sulfate (PASS) coagulant. UV caused a high increase of Halonitromethanes (8.4 fold), Haloketones (2.1 fold), and THMs in the water (1.7 fold) and, of THMs in the air (1.6 fold) and contributed to reducing the level of chloramines in the air (1.6 fold) and NDMA in the water (2.1 fold). The results highlight the positive impact of air stripping in reducing volatile contaminants. The PASS did not change the presence of DBPs, except for the THMs, which decrease slightly with the use of this coagulant. This study shows that modifications affecting the water treatment process can rapidly produce important and variable impacts on DBP levels in water and air and suggests that implementation of any water treatment process to reduce DBP levels should take into account the specific context of each swimming pool.     

酸性水汽提及硫磺回收工艺的研究及应用研究

文章主要通过对酸性水气体及硫磺回收工艺特点的介绍与比选,着重分析“无在线炉硫磺回收及尾气处理工艺”（SSR）,其中硫回收为一段高温转化,二级催化转化的克劳斯工艺,尾气处理为加氢还原一吸收工艺,并介绍原辅材料成分及处理效率。该工艺能够有效解决石化企业的酸性气及酸水排放问题,具有良好的社会、环境效益显著。     

Concentrations of cadmium and lead heavy metals in Dardanelles seawater

Cadmium and lead were determined simultaneously in seawater by differential pulse stripping voltammetry (DPSV) preceded by adsoptive collection of complexes with 8-hydroxyquinoline (oxine) on to a hanging mercury drop electrode (HMDE). In preliminary experiments the optimal analytical condition for oxine concentration was found to be 2.10⁻⁵ M, at pH 7.7, the accumulation potential was −1.1 V, and the initial scannig potential was −0.8 V. The peak potentials were found −0.652 V for Cd and −0.463 V for Pb At the 60 s accumalation time. The limit of detection (LOD) and limit of quantitatification (LOQ) were found to be by voltammetry as 0.588 and 1.959 μg l⁻¹ (RSD, 5.50%) for Cd and 0.931 and 3.104 μg l⁻¹ (RSD, 4.10%) for Pb at 60 s stirred accumulation time respectively. In these conditions the most of the seawater samples are amenable for direct voltammetric determination of cadmium and lead using a HMDE. An adsorptive stripping mechanism of the electrode reaction was proposed. For the comparison, seawater samples were also analysed by ICP-atomic emission spectrometry method (ICP-AES). The applied voltammetric technique was validated and good recoveries were obtained.     

UASB-FEO-氨吹脱-CASS工艺在垃圾渗滤液处理中的应用

针对垃圾渗滤液可生化性差、氨氮含量高等特点和国内处理工艺现状,采用UASB-FEO-氨吹脱-CASS工艺处理合肥市龙泉山城市垃圾填埋场垃圾渗滤液。介绍了工艺的重要构筑物及其设计参数。运行实践表明,整套装置运行平稳,出水水质满足设计要求。根据出水水质对该工艺进行技术分析以及运行结果的讨论,并与新发布的技术规范及排放标准进行对比分析。     

超声吹脱去除氨氮的机理和动力学研究

采用超声吹脱技术对某印染厂印染废水中的氨氮进行了处理实验,探索了其反应机理并进行了动力学研究。研究表明,叔丁醇的存在没有降低废水中氨氮的去除率,证明.OH不是超声吹脱去除氨氮反应中的主导氧化物种。通过对反应产物的分析发现,超声吹脱去除氨氮的机理主要是氨氮以游离态的方式在空化效应下高温高压热解成氮气和氢气排出,同时氨气在空化效应产生的超临界状态下传质速度加快,在吹脱条件下更易于从废水中散失。动力学分析表明,印染废水中氨氮的超声去除反应属于一级反应,符合一级反应动力学。     

基于方波溶出伏安法的电化学传感器检测水体中痕量铅

基于方波溶出伏安法运用丝网印刷电极探索了一种利用电化学传感器检测水样中痕量铅的方法.得到了该检测方法的最佳参数:方波频率30 Hz,振幅80 mV,电位增量5 mV;0.5 mol/L的支持电解质(KCl);沉积电位-1.1 V,沉积时间400 s.在该优化条件下,在浓度为25 ～ 500μg/L范围内溶出峰电流与铅离子浓度呈良好的线性关系(R2=0.9945).对于几种其他金属离子的干扰实验结果表明,Mn2的存在严重抑制铅离子的峰电流.     

Electrochemical study of the fungicide acibenzolar-s-methyl and its voltammetric determination in environmental samples

The electrochemical behavior of new generation fungicide acibenzolar-s-methyl (S-methyl 1,2,3-benzothiadiazole-7-carbothioate, ASM) on the hanging mercury drop electrode (HMDE) was investigated using square wave adsorptive stripping voltammetry. This method of determination is based on the irreversible reduction of ASM at the HMDE. The well-defined ASM peak was observed at ?0.4 V (vs. Ag/AgCl) in BR buffer at pH 2.2. The reduction peak current was proportional to concentration of ASM from 1.0 × 10^?8 to 6.0 × 10^?8 mol L^?1 with detection and quantification limit 3.0 × 10^?9 and 1.0 × 10^?8 mol L^?1, respectively. The applicability of the developed method for analysis of spiked samples of tap water, river water, and soil is illustrated. The effect of adsorption on the mercury electrode was studied in detail using the AC impedance method. Possible interferences with other common pesticides and heavy metal ions were examined. Clarification of the electrode mechanism was made using cyclic voltammetry (CV) technique.     

NaOH溶液对有机相苯酚反萃取的研究

本文系统进行了ＮａＯＨ溶液对负载苯酚的ＴＢＰ＋煤油溶剂的反萃取平衡实验。考虑苯酚的支萃取平衡和解离平衡,建立了反萃取的计算模式,并证明了模型的可行性。本文还讨论了ＮａＯＨ溶液浓度,油水相比,萃取平衡分配系数,溶剂中的负载苯酚浓度和ＮａＯＨ溶液中初始酚含量对反萃取率的影响。     

Analysis of chromium and copper by cathodic stripping voltammetry with mixed ligands

Cathodic adsorptive stripping voltammetry is one of the most sensitive analytical methods for ultratrace analysis. The detection limit is usually lower than 10⁻⁹ mol/L. Most adsorptive stripping procedures have been focused on the one ligand/one analyte approach. In order to reduce analysis time and sample volume, the possibility of simultaneously determining several metals by cathodic stripping voltammetry using a mixture of ligands was explored, e.g., by Colombo and van den Berg (1997). Here, we describe a new procedure for quantifying chromium and copper using 2,2′-bipyridine and 8-hydroxyquinoline (oxine). The effect of various operational parameters such as buffer type, ligand concentration, potential and time collection were assessed and optimized. Possible interferences by trace metals and organic matter were also investigated. Applicability for fresh water is illustrated. Electronic Publication