低温条件IASBR处理养猪沼液脱氮性能研究

以实际养猪沼液为研究对象,考察分步进水间歇曝气序批式生物反应器(IASBR)在低温条件下的脱氮性能.结果表明:IASBR反应器的硝化性能临界水温为10℃,水温低于10℃时硝化性能急剧下降,水温10℃以上时氨氮去除率达到90%以上,且水温15℃以上氨氮负荷极限可达到0.30 kg·m~(-3)·d~(-1);低碳氮比(COD/TN)1.7±0.3条件下,反硝化性能临界水温为20℃,20℃以上时TN去除率可保持在80%以上,最高达90%,20℃以下时脱氮效率明显降低,出现亚硝态氮积累现象.此外,IASBR反应器脱氮除磷效率高,温度对TOC和TP去除率的影响不敏感.不排泥条件下,进水COD/TN为3.1±0.4时,TN去除率高达90%以上,TOC和TP去除率分别高达83.6%±3.9%和58.5%±17.8%;随后COD/TN降低至1.7±0.3后,TN去除率仍高达80%以上,TOC和TP去除率仅略有降低分别为77.3%±4.6%、53.1%±10.1%.     

硫酸盐还原菌包覆矿石控制酸性废水排放及碳源的优选研究

本研究基于实验室筛选、培养的硫酸盐还原菌(Sulfate-reducing bacteria,简称SRB)菌群,分别考察以麦芽糊精、污泥、乙醇、乳酸钠等为碳源时SRB的生长状况,同时模拟野外环境进行柱淋滤实验,分析在不同碳源作用下原位控制酸性矿山废水的效果.结果表明,采用这4种碳源时,SRB还原硫酸盐能力的大小依次为:...     

波浪与抛石潜堤相互作用的MPS法数值模型研究

为了研究波浪与抛石潜堤相互作用过程中大自由表面变形和堤内渗流等强非线性紊流运动问题,利用改进的MPS法,建立了模拟波浪与抛石潜堤相互作用的MPS法数值计算模型。模型将抛石潜堤假定为均质多孔介质,采用Drew的二相流运动方程描述多孔介质内外的流体运动;通过在动量方程中增加非线性阻力项,并引入亚粒子尺度紊流模型,模拟波浪与可渗结构物相互作用过程中的紊流运动。选取“U”型管中多孔介质内渗流过程和孤立波与可渗潜堤相互作用两个典型的渗流问题,通过将数值计算结果与理论解和实测值的对比分析,对所提出的MPS法紊流渗流模型的模拟精度进行验证。结果表明：基于改进的MPS法构建的垂向二维紊流渗流模型可以很好地再现 “U”型管中多孔介质内渗流以及波浪作用下可渗潜堤内外的复杂流场,显著缓解流-固界面处的压力震荡与粒子分布不均匀问题,实现了较高的模拟精度。     

Emergency shutdown of fluidized bed reaction systems

With several industrial applications of fluidized bed technology recently commercialized worldwide, it becomes essential to develop safe operation methods for fluidized bed reaction systems (FBRSs) to prevent any influence on their process values, which lead to accidents. To preventing any disaster or malfunction in an FBRS, an emergency shutdown system (ESD) is initiated, closing the reaction system in case of any abnormality by effectively isolating the flammable gas. However, an ESD is also prone to the “inactivation problem,” in which in the case of failure it initiates the emergency shutdown, even when the operating conditions of the reaction system are abnormal. It is also vulnerable to a “malfunction problem,” where the emergency shutdown is performed even when the operating conditions of the reaction system are normal. In this study, these problems were solved by investigating a reaction system through the monitoring of appropriate parameters and setting up of trigger levels, which reflect the uniqueness of an FBRS using an ESD. The parameters were identified by analyzing the scenario leading to an accident. The trigger levels were determined as the points at which the loss is smaller in the presence of an ESD, as compared to the value of the loss function in the presence or absence of an ESD. Furthermore, the ESD design model was applied as a case study in the ammoxidation process of propylene. The results showed that an ESD can prevent an approximately 8 billion yen of loss due to accidents in plant operations, against an investment of 200 million yen.     

Monitoring Biofilm Thickness Using A Non-Destructive, On-Line, Electrical Capacitance Technique

Abstact The present study was designed to evaluate indirect, non-invasive, on-line measurement of biofilm thickness using an electrical capacitance technique. Several assays were carried out and the results showed that, at a frequency of 1 kHz, electrical capacitance could be used to measure biofilm thickness indirectly (with a correlation coefficient of 0.9495). The reproducibility revealed by the assays was also highly satisfactory.However, in contrast to what was expected, there was an inverse relationship between electrical capacitance and biofilm thickness, i.e. electrical capacitance diminished with the increase in the biofilm thickness.The tests were also carried out at different frequencies (1 kHz, 10 kHz and 100 kHz)     

ABR反应器的碱度变化及调控研究

研究了折流厌氧反应器(ABR)运行中碱度的变化情况及其与ABR各格室中VFA、pH和COD变化之间的关系.结果表明,碱度沿程变化与反应器的VFA浓度变化密切相关,碱度和pH值的最低点出现在VFA浓度最高点.碱度条件是通过pH值影响系统的运行.ABR沿程碱度和pH值变化都存在一个先降低后上升的过程.碱度控制一般以保证ABR沿程最低pH值不低于6.0为准,6.5以上为佳.进水碱度的下限与反应器的进水浓度密切相关.在低负荷COD条件下[3.7 kg/(m³·d)],保持ABR运行良好的最低碱度为800 mg/L.     

内置转盘式膜-生物反应器处理污水的工艺条件研究

对内置转盘式膜-生物反应器(SRMBR)处理污水工艺进行了研究.进水COD 160～368 mg/L时,出水COD在运行1d后降低到20 mg/L以下,去除率大于90%;转盘式膜组件的转速在0～25 r/min范围内,平衡膜通量随转速增大而快速增加,继续增大转速则平衡膜通量的增加变得不显著;在一定范围(0～1min)内延长停抽时间有助于缓解膜污染;SRMBR在较低的气水比(15∶1)下运行,也可达到较高的平衡膜通量.研究表明,SRMBR在最佳组合操作条件(转速为25r/min,抽/停为9min/1min,气水比为15∶1,抽吸压力为25kPa)下运行,其平衡膜通量高达53.75L/(m²·h).     

喷淋环栅式除尘脱硫反应器的数学模拟

研制了一种由内外圈构成的喷淋环栅式除尘脱硫反应装置,气、液两相在内外圈之间通向运动,紊流冲激环栅时接触传质。基于溶质渗透理论,提出了以内塔穿孔速率V,液气比L/G,吸收浆液pH值为参数的脱硫效率模型。对比某电厂工况条件下测得的一系列实验数据,显示出该模型与实际情况具有良好的一致性,表明该模型可以用来作为工程设计、最优化技术和推测工业数据的理论参考工具。     

超临界水氧化处理高浓度丙烯酸废水

采用超临界水氧化（SCWO）技术在连续蒸发壁式反应器内处理高浓度丙烯酸废水。实验结果表明：SCWO能有效地处理丙烯酸废水,废水COD和TOC去除率分别达到99％左右,且反应时间短;反应温度、反应压力和氧化剂加入量的增加有利于COD和TOC去除率的提高。实验得出的废水处理最佳工艺条件：反应温度693K、反应压力24～26MPa、氧化剂加入量1．0～1．5倍。对反应器出口试样进行色谱-质谱联用分析结果表明,小分子醇、醚类以及CO2和CO是主要的液相产物和气相产物。针对腐蚀和盐沉积问题,提出了预防措施。     

含碳纳米TiO2光催化降解甲醇

采用管式光催化反应器,在石英玻璃管壁上涂镀含碳纳米TiO2薄膜,研究含碳纳米TiO2对甲醇气体的光催化降解性能。实验结果表明：随气体流量增加,甲醇降解率呈线性降低;在气体流量为200mL／min、相对湿度为40％、甲醇初始质量浓度为90～170mg／m^3的较佳条件下,甲醇降解率维持在80％以上,最高达85％;在甲醇初始质量浓度为150mg／m^3、气体流餐为200mL／min、相对湿度为40％的条件下,德国Degusa—P25光催化剂对甲醇的平均降解率为89％,含碳纳米TiO2对甲醇的平均降解率为82％,最人降解率为85％。