生物活性炭去除水中挥发性苯系物的基础研究

采用连续流生物活性炭(BAC)工艺处理水中挥发性苯系物(BTEX,包括苯、甲苯、乙苯、二甲苯),评价进水负荷、活性炭炭型等因素对于BAC处理性能的影响.研究表明,在40d的处理时间内,除苯之外,其余BTEX的BAC出水中均未检出苯系物(进水为6mg/L).为了检验BAC在高BTEX负荷情况时的处理效果,将进水浓度设定为19~32mg/L左右,在EBCT为1.2min条件下同样只有苯的出水浓度上升至10mg/L(C/Cin为0.45),然后略有下降,最终保持在5~10mg/L(C/Cin为0.3以下),其余苯系物出水浓度均一直保持小于5mg/L.这表明BAC可以有效地处理高负荷BTEX(8.68~12.9kgTOC/(m3·d))的进水.生物活性炭对于活性炭吸附容量的恢复有比较明显的作用,煤质炭和椰壳炭的生物再生效率分别为53.6%和26.6%,煤质炭再生效率高的原因可能是其具备更多的大型中孔和大孔.     

Evaluation of adsorption capacities of humic acids extracted from Algerian soil on polyaniline for application to remove pollutants such as Cd(Ⅱ), Zn(Ⅱ) and Ni(Ⅱ) and characterization with cavity microelectrode

The adsorption capacities of new humic acids isolated from Yakouren forest (YHA) and Sahara (Tamenrasset: THA) soils (Algeria) and commercial humic acid (PFHA) on polyaniline emeraldine base (PEB) were studied at pH 6.6. Also the adsorption of heavy metals such as Cd2+, Zn2+ and Ni2+ on humic acid-polyaniline systems (HA-PEB) was investigated at the same conditions. HA-PEB compounds were characterized by scanning electron microscopy (SEM), infrared spectrometry and cavity microelectrode. In addition, batch adsorption and cavity microelectrode were used in the adsorption study of Cd2+, Zn2+ and Ni2+ on HA-PEB. To develop biocaptors of polluting metals using a cavity microelectrode modified by HA-PEB systems, the adsorption kinetic and adsorption capacity were investigated. The SEM analysis showed that the presence of humic acid affected the PEB surface and caused the formation of a granular morphology. The maximum adsorption capacities (qmax) of PFHA, THA and YHA determined by adsorption isotherms were 91.31, 132.1 and 151.0 mg/g, respectively. Batch adsorption results showed that qmax of Cd2+, Zn2+ and Ni2+ on HA-PEB followed the order: THA-PEB > YHA-PEB > PFHA-PEB. The voltammograms obtained with HA-PEB modified cavity microelectrode showed the appearance of new redox couples reflecting the adsorption of HA on PEB. Metal-humic acid-polyaniline voltammograms were characterized by appearance of oxidation-reduction couples or reduction wave corresponding to metal. Finally, the result may be exploited to develop a biocaptor based on the cavity microelectrode amended by THA-PEB and YHA-PEB.     

Modification of Ce02-ZrO2 catalyst by potassium for NOx-assisted soot oxidation

Potassium-modified ceria-zirconia catalyst was synthesized by wetness impregnation method. The ageing treatment was performed in static air at 800℃ for 20 hr to evaluate the thermal stability of the catalyst. The catalysts were characterized by X-ray diffraction,BET surface area, oxygen storage capacity, NOx-temperature programmed desorption and soot-temperature programmed oxidation measurements. By introduction of potassium, the maximum soot oxidation rate temperature (Tm) of the ceria-zirconia based catalyst decreased from 525 to 428℃ in the presence of NO under a loose contact mode. The shift of Tm of the K-modified catalyst after ageing is only 15℃. The enhanced activity of the aged catalyst mainly lies in the promotional effect of potassium on the NOx/oxygen storage cacity as well as the soot-catalyst contact.     

Groundwater contamination and natural attenuation capacity at a petroleum spilled facility in Korea

As a remedial option, the natural attenuation capacity of a petroleum contaminated groundwater at a military facility was examined. Hydrogeological conditions, such as high water level, permeable uppermost layer and frequent heavy rainfall, were favorable to natural attenuation at this site. The changes in the concentrations of electron acceptors and donors, as well as the relevant hydrochemical conditions, indicated the occurrence of aerobic respiration, denitrification, iron reduction, manganese reduction and sulfate reduction. The calculated BTEX expressed biodegradation capacity ranged between 20.52 and 33.67 mg/L, which appeared effective for the reduction of the contaminants levels. The contribution of each electron accepting process to the total biodegradation was in the order: denitrification > iron reduction > sulfate reduction > aerobic respiration > manganese reduction. The BTEX and benzene point attenuation rates were 0.0058-0.0064 and 0.0005-0.0032 day^-1, respectively, and the remediation time was 0.7-1.2 and 2.5-30 years, respectively. The BTEX and benzene bulk attenuation rates were 8.69 × 10^-4 and 1.05 × 10^-3 day^-1, respectively, and the remediation times for BTEX and benzene were 7.2 and 17.5 years, respectively. However, most of the natural attenuation occurring in this site can be attributed to dilution and dispersion. Consequently, the biodegradation and natural attenuation capacities were good enough to lower the contaminants levels, but their rates appeared to be insufficient to reach the remediation goal within a reasonable time frame. Therefore, some active remedial measures would be required.     

改性海泡石除磷剂除磷过程热力学的研究

通过研究改性海泡石对磷的吸附性能,确定了除磷剂用量、温度、含磷废水流量、添加剂等因素对改性海泡石磷吸附热力学平衡的影响.研究结果表明:改性海泡石除磷剂对废水中PO43-离子的吸附容量随除磷剂质量的增加而减小;去除率随除磷剂用量的增加而增大;提高酸改性温度有利于复合除磷剂对磷的吸附;除磷剂的吸附量随海泡石焙烧温度的提高而...     

路面径流水环境下交通承载力分析

为了对路面径流水容许污染总量控制下的交通承载力问题进行探讨,利用神经网络具有的非线性映射能力和遗传算法具有的全局随机搜索能力,结合公路路面径流水质检测数据,提出了一种基于遗传神经网络进行公路交通环境承载力反计算的分析方法,应用该方法可根据路面径流水质污染数据反演出路段交通量大小,并可据此进行交通量与路而径流水质污染的关...     

型煤产业发展与提高

本文论述发展工业型煤产业的重要意义和技术质量保证,洁净煤技术是控制污染和节约能源,提高煤炭资源利用率的重要技术项目,将粉煤生产成型煤,为工业、民用提供洁净的燃料,既充分利用煤炭资源同时改善能源结构,又有显著的环保效益,国家把煤炭产业列入中国洁净煤技术有限发展项目,目前制约型煤产业的发展要造气型和燃烧型煤并举,同时有利于用户的节能效益。     

葫芦岛市工业源二氧化硫普查结果分析与对策

通过对葫芦岛市工业源二氧化硫普查结果全面系统分析,阐明了各区域、行业、企业的二氧化硫产生、排放及分布特点,指出了葫芦岛地区工业源二氧化硫存在的主要问题,提出了具体的对策措施。     

2014年APEC期间北京市PM10和PM2.5氧化性损伤能力研究

为评估APEC会议期间联防联控措施对北京市大气可吸入颗粒物毒性的影响,采集2014年APEC会议前后3个月北京市大气PM₁₀和PM_2.5样品,应用质粒DNA损伤评价法来研究其氧化性损伤能力. 结果表明,APEC会议期间PM₁₀对DNA的损伤率高于PM_2.5,颗粒物对 DNA损伤率随剂量的增加而增加. 本研究用TD30值来指示颗粒物氧化性损伤能力,TD30为引起30%的DNA损伤率所需要的颗粒物剂量（单位为 μg·mL^-1）,TD30值越低,颗粒物氧化性损伤能力越强,APEC会议前后样品的TD30值表现为 APEC期间（11月）>APEC前（10月）>APEC后（12月）,说明氧化能力APEC后 >APEC前 >APEC期间. 用PM₁₀质量浓度乘上其在250 μg·mL^-1 剂量下的DNA损伤率得到颗粒物暴露毒性指数TI（toxic index）,与往年具有代表性月份样品的数据对比,TI大小顺序为2004年 >2014年 >2008年,说明大气中颗粒物暴露毒性随着政策控制力度的加大而降低.     

乌鲁木齐大气PM2.5对质粒DNA的损伤研究

2012年1月~2012年12月采集乌鲁木齐大气PM2.5样品,使用质粒DNA评价法研究了不同季节PM2.5的氧化能力,并进行氧化性毒性与相应气象因素和质量浓度之间的相关性研究.结果表明,乌鲁木齐大气PM2.5的质量浓度具有冬季最高,春季和秋季次之,夏季最低的季节性变化特征;PM2.5全样和水溶部分氧化能力的季节差异较大,对质粒DNA的氧化性损伤具有冬季最大,春季和夏季之次,秋季最低.冬、春、夏、秋季大气PM2.5全样的TD30(PM2.5对质粒DNA造成破坏达到30%所需要的颗粒物的剂量)平均值分别为440,491,503,515μg/mL,水溶部分分别为474,721,666,600μg/mL.绝大部分PM2.5样品全样的TD30值均小于水溶部分样,表明全样的毒性大于相应的水溶部分样.全样TD30值与平均温度显著(P<0.05)正相关,表明寒冷的天气/季节可能造成PM2.5的高毒性.水溶样TD30值与风速显著(P<0.01)正相关,与相对湿度显著负相关.这表明,高的风速和低的相对湿度可能跟较低和较高的PM2.5的毒性有关.PM2.5氧化性损伤能力的大小与其质量浓度之间的相关性不明显,表明仅以颗粒物的质量浓度来评价大气颗粒物氧化性损伤能力大小的方法并不能真实地反映其对人体健康的危害程度,起决定作用的还是颗粒物的化学组成及其表面吸附的有害成分.