Polycyclic aromatic hydrocarbons in surface sediments held in experimental mesocosms

Sediment was collected from three locations along a pollution gradient in Narragansett Bay and transplanted to controlled mesocosms. Total hydrocarbons and eleven individual polycyclic aromatic hydrocarbons (PAHs) were measured in these sediments over a period of 394 days. Total hydrocarbon concentrations increased in the “relatively uncontaminated”; (Rhode Island Sound) sediment that was held in the mesocosms, but did not change in the two other sediments. The concentrations of four PAHs: naphthalene, 2‐methyl naphthalene, 1‐methyl naphthalene and biphenyl, decreased in the “contaminated”; (Providence River) sediment during the experiment and the calculated half‐lives for these compounds were 287, 353, 321 and 333 days, respectively.     

应用水滑石实时合成分离模拟核素钕

应用水滑石实时合成的方法从高放废液中分离模拟放射性核素钕,通过酸碱滴定、单因素试验及X-射线衍射(XRD)研究确定了最佳分离条件,用红外光谱(FT-IR)、扫描电镜(SEM)、透射电镜(TEM)等对合成的含钕水滑石的结构、形貌进行了分析. 结果表明:模拟放射性核素钕的最佳分离条件,初始ρ(Nd3+)为150 mg/L,pH为10,n(Mg)/［n(Al)+n(Nd)］为3,在该条件下5次平行试验钕的去除率平均值为96.40%,并且钕嵌入到了水滑石的晶格中,合成的含钕水滑石形貌大多为层状六边形;含钕水滑石煅烧产物主要为尖晶石,煅烧产物中未见氧化钕相,表明嵌入到水滑石晶格中的钕在煅烧后仍存在于尖晶石的晶体结构中.      

间位羟基/甲氧基多溴联苯醚的合成

本文设计了3种合成路线,通过偶合反应、Baeyer-Villiger氧化水解、硝基还原、加溴反应、去甲基化等一系列反应,合成了多种间位羟基/甲基多溴联苯醚.产物经过气相色谱-质谱仪(GC-MS)和核磁共振测试表明实验所合成得到的产物与设计的目标产物结构完全一致,其纯度达到标样要求.     

A Literature Review of Poly(Lactic Acid)

A literature review is presented regarding the synthesis, and physicochemical, chemical, and mechanical properties of poly(lactic acid)(PLA). Poly(lactic acid) exists as a polymeric helix, with an orthorhombic unit cell. The tensile properties of PLA can vary widely, depending on whether or not it is annealed or oriented or what its degree of crystallinity is. Also discussed are the effects of processing on PLA. Crystallization and crystallization kinetics of PLA are also investigated. Solution and melt rheology of PLA is also discussed. Four different power-law equations and 14 different Mark–Houwink equations are presented for PLA. Nuclear magnetic resonance, UV–VIS, and FTIR spectroscopy of PLA are briefly discussed. Finally, research conducted on starch–PLA composites is introduced.     

Mn/γ-Al2O3催化剂的制备及头孢合成废水的催化臭氧氧化法深度处理

对Mn/γ-Al₂O₃催化剂的制备条件及头孢合成废水的催化臭氧氧化法深度处理工艺条件进行了优化。实验结果表明：以Mn（NO₃）₂溶液为浸渍液,Mn/γ-Al₂O₃催化剂的最优制备条件为浸渍液浓度0.10 mol/L、浸渍时间9 h、焙烧温度400 ℃、焙烧时间2 h;在反应时间为30 min、废水pH为9.0、臭氧通量为4.6 mg/min、催化剂加入量为5 g/L的条件下,当进水COD、BOD₅、ρ（氨氮）和色度分别为220~250 mg/L,8~10 mg/L,10~12 mg/L和60~70倍时,出水COD、BOD₅、ρ（氨氮）和色度的平均去除率分别为53%,30%,33%和93%,出水水质满足GB 21904—2008《化学合成类制药工业水污染物排放标准》的要求。     

Interface-mediated synthesis of monodisperse ZnS nanoparticles with sulfate-reducing bacterium culture

We have created a new method of ZnS nanospheres synthesis. By interface-mediated precipitation method (IMPM), monodisperse ZnS nanoparticles was synthesized on the particle surface of sulfate-reducing bacterium nutritious agar culture. Sulfate-reducing bacterium (SRB) was used as a sulfide producer because of its dissimilatory sulfate reduction capability, meanwhile produced a variety of amino acids acting as templates for nanomaterials synthesis. Then zinc acetate was dispersed into nutritious agar plate. Subsequently agar plate was broken into particles bearing much external surface, which successfully mediated the synthesis of monodisperse ZnS nanoparticles. The morphology of monodisperse ZnS nanospheres and SRB were examined by scanning electron microscopy (SEM), and the microstructure was investigated by X-ray diffraction (XRD). The thermostability of ZnS nanoparticles was determined by thermo gravimetric-differential thermo gravimetric (TG-DTG). The maximum absorption wavelengh was analysed with an ultraviolet-visible spectrophotometer within a range of 199–700 nm. As a result, monodisperse ZnS nanoparticles were successfully synthesized, with an average diameter of 80 nm. Maximum absorption wavelengh was 228 nm, and heat decomposed temperature of monodisperse ZnS nanoparticles was 596°C.     

石墨烯基磁性复合材料吸附水中亚甲基蓝的研究

建立了一种超声辅助共沉淀法制备磁性Fe3O4/氧化石墨烯(Fe3O4/GO)纳米粒子.透射电镜和磁滞回线研究表明,该复合物具有小的颗粒尺寸和超顺磁性.该磁性纳米材料可以吸附废水中的染料亚甲基蓝,实验研究了溶液pH值、吸附剂的用量、时间和温度对亚甲基蓝去除率的影响.结果表明,pH值在6~9范围内,Fe3O4/GO都能高效地吸附亚甲基蓝.反应过程在前25 min反应速率很快,到180 min内达到吸附平衡.该磁性纳米材料对亚甲基蓝的吸附符合Langmuir吸附等温模型和准二级动力学方程,吸附过程是一个自发和吸热过程.该吸附材料对亚甲基蓝吸附容量高,在313 K时Fe3O4/GO的饱和吸附量为196.5 mg·g-1.另外,可以方便地通过外部磁场分离回收吸附剂,利用过氧化氢可以再生重复使用,是一种优良的吸附染料废水的材料.     

Ce-MCM-22分子筛的合成与吸附动力学研究

采用静态水热晶化法,以硅溶胶为硅源、六亚甲基亚胺(HMI)为模板剂,通过掺杂Ce合成了具有MWW层状结构的Ce-MCM-22分子筛。并利用粉末X-射线衍射(XRD)、扫描电镜(SEM)、透射电镜(TEM)等方法对其进行了表征,对其进行了吸附动力学的研究。研究表明,Ce-MCM-22吸附动力方程拟一级方程为y=-0.028 1x-0.136,R2=0.983 4。Ce-MCM-22吸附动力方程拟二级方程为y=0.465 7x+1.2005,R2=0.999 5,说明拟二级反应模型更能真实地反映分子筛吸附亚甲蓝溶液的反应机理。     

Inverse modeling of Asian Rn flux using surface air Rn concentration

When used with an atmospheric transport model, the ²²²Rn flux distribution estimated in our previous study using soil transport theory caused underestimation of atmospheric ²²²Rn concentrations as compared with measurements in East Asia. In this study, we applied a Bayesian synthesis inverse method to produce revised estimates of the annual ²²²Rn flux density in Asia by using atmospheric ²²²Rn concentrations measured at seven sites in East Asia. The Bayesian synthesis inverse method requires a prior estimate of the flux distribution and its uncertainties. The atmospheric transport model MM5/HIRAT and our previous estimate of the ²²²Rn flux distribution as the prior value were used to generate new flux estimates for the eastern half of the Eurasian continent dividing into 10 regions.The ²²²Rn flux densities estimated using the Bayesian inversion technique were generally higher than the prior flux densities. The area-weighted average ²²²Rn flux density for Asia was estimated to be 33.0 mBq m⁻² s⁻¹, which is substantially higher than the prior value (16.7 mBq m⁻² s⁻¹). The estimated ²²²Rn flux densities decrease with increasing latitude as follows: Southeast Asia (36.7 mBq m⁻² s⁻¹); East Asia (28.6 mBq m⁻² s⁻¹) including China, Korean Peninsula and Japan; and Siberia (14.1 mBq m⁻² s⁻¹). Increase of the newly estimated fluxes in Southeast Asia, China, Japan, and the southern part of Eastern Siberia from the prior ones contributed most significantly to improved agreement of the model-calculated concentrations with the atmospheric measurements. The sensitivity analysis of prior flux errors and effects of locally exhaled ²²²Rn showed that the estimated fluxes in Northern and Central China, Korea, Japan, and the southern part of Eastern Siberia were robust, but that in Central Asia had a large uncertainty.     

卤氧化铋光催化剂改性的研究进展及应用

随着全球环境问题与能源问题的不断加剧,人们迫切需要开发一些高效、环保、稳定的光催化剂。卤氧化铋(BiOX,X=Cl、Br、I)因其独特的层状结构,优异的光学、电学性能,在光催化领域受到了越来越多的关注。虽然BiOX光催化剂在光催化反应中展现出了优异性能,但其光催化效率仍有待提高。简要叙述了BiOX的结构与性能以及当前主流的制备方法,主要概述了最近几年卤氧化铋光催化剂改性的研究进展。改性方法主要有微结构调控、晶面与缺陷调控、掺杂、构造异质结等,这些方法主要是通过提高卤氧化铋或卤氧化铋复合物的光吸收能力、光生载流子的分离和运输效率、以及活性位点的暴露量来实现改性。介绍了其在环境、能源和生物等领域的应用,同时对BiOX的发展提出了问题和展望。