低温硝基苯降解菌选育及在土壤修复中的应用

从硝基苯污染地下水中筛选出一株以硝基苯为唯一碳源和氮源的低温、高效降解菌,命名为XJ菌;初步鉴定XJ菌为革兰氏阴性微小短杆细菌、恶臭假单胞菌属,降解硝基苯遵循部分还原降解途径;在10℃下培养96 h,XJ菌对硝基苯的降解去除率达到91.1%,其中约有67.1%的硝基氮素转变成了氨氮。在10℃下利用XJ菌修复硝基苯污染土壤,修复时间为96 h时,硝基苯去除率达到85.7%,XJ菌密度及微生物脱氢酶活性保持较高的水平。本研究可为低温下硝基苯污染土壤的生物修复提供参考。     

石墨气体扩散电极的制备与性能优化

电极的制备工艺及参数直接影响电极材料的活性。主要考察了C/PTFE质量比、碾压压力、煅烧温度、造孔剂NH4HCO3及稀土掺杂等因素对电极产出H2O2的影响规律。研究结果表明,电极最佳制备条件为:石墨和PTFE质量比为2∶1、石墨、造孔剂和稀土元素质量比为6∶1∶1、碾压压力10 MPa、煅烧温度330℃。在pH=3、电解质Na2SO4浓度为0.05mol/L条件下,电解2 h后,改性电极产生的H2O2从95 mg/L提高到350 mg/L,提高了268.4%。     

重庆主城区秋冬季逆温对空气质量影响的观测分析

2013年9—11月利用RPG-HATPRO地基多通道微波辐射计对重庆主城区大气进行连续探测,统计了大气逆温情况,并对典型重污染天气下大气逆温与空气质量状况进行综合分析。结果表明,逆温出现的频率为63.3%,基本为接地逆温类型,逆温层厚度为953 m,逆温强度为0.3℃/hm;逆温的存在为气溶胶的积聚和凝聚创造了有利条件。     

不同运行模式对同步脱氮除磷CAST工艺快速启动及其稳定维持的影响

以实际生活污水为处理对象,考察了传统进水/曝气和改良型分段进水的交替缺氧-好氧(A/O)2种运行模式对CAST工艺的快速启动及脱氮除磷性能稳定维持的影响。结果表明,传统进水/曝气运行模式下,系统达到最佳营养物去除性能所需启动时间30 d,稳定运行阶段TN平均去除80.66%,磷的去除率维持在66.30%左右;采用改良型交替运行模式,反应器达到稳定运行状态仅需18 d,系统稳定运行时TN平均去除81.36%,磷去除率稳定维持在90%以上,出水磷浓度在0.3 mg/L以下,出水水质达到国家污水综合排放标准一级A(GB8978-2002)。研究还发现,传统运行模式下,由低温引起的污泥沉降性能变差导致系统污泥严重流失,反应器几乎丧失污染物去除性能;而低温对交替运行模式下的反应器除磷性能几乎没有影响,总氮去除则因氨氮不完全硝化而大大降低。     

Effect of UV radiation and temperature on mineralization and volatilization of coumaphos in water

This study was undertaken to determine the dissipation and degradation of coumaphos [O-(3-chloro-4-methyl-2-oxo-2H-1-benzopyran-7-yl) O,O-diethyl phosphorothioate] under different sunlight conditions and at different temperatures. The effect of the ultra violet (UV) component of solar radiation was also studied using quartz tubes in addition to other radiation in the visible range using glass tubes and the results were compared with those obtained under the dark light conditions. Water suspensions of coumaphos were incubated at three temperatures viz. 22°C, 37°C and 53°C in closed systems to study the effect of temperature. Volatilization, mineralization and degradation of coumaphos increased with an increase in temperature and exposure to solar radiation, particularly under the UV component of the solar radiation. Major loss of the pesticide occurred through volatilization. The optimum temperature for the degradation of coumaphos was found to be at 37°C. The data obtained from the mineralization and degradation studies indicated that 53°C crosses the biological range for suitable growth of microorganism. UV radiation exposure along with maintaining temperature at 37°C may prove useful in the dissipation and/or degradation of coumaphos prior to its disposal as waste from cattle dipping vats.     

The characteristics of nitrate removal by the psychrotolerant denitrifying bacterium Acinetobacter johnonii DBP-3, isolated from a low-temperature eutrophic body of water

A psychrotolerant denitrifying bacterial strain, DBP-3, was isolated from a eutrophic body of water by low-temperature-oriented acclimation culture. Based on its morphologicalandbiochemicalcharacteristics and 16S rDNA gene sequence, the bacterium was identified as belonging to the genus Acinetobacter and closely related to A. johnonii. The satisfactory growth of DBP-3 was observed at 10–30°C and pH 7–9. Strain DBP-3 was able to utilize three types of carbon sources (sodium acetate > sodium citrate > glucose) to support growth and denitrification. DBP-3 grew faster, but with lower nitrate removal efficiency and higher nitrite accumulation, under aerobic conditions than under anoxic conditions. DBP-3 was extremely susceptible to tetracycline and rifampicine and less sensitive to ampicillin and penicillin. The growth of DBP-3 was significantly affected by Hg (II), Cr (VI), Pb (II), Cd (II), and As (III) at 0.32, 0.63, 1.25, 2.5, and 25.0 mg L^?1, respectively. Interestingly, chromium (VI) significantly promoted DBP-3 growth at concentrations lower than 0.32 mg L^?1. These data may be helpful to support the use of strain DBP-3 in the purification of eutrophic water bodies at low temperatures.     

如何确定高加速寿命试验的应力极限

气锤驱动的高加速寿命试验,主要目的是确定试验样品的应力极限(包括工作极限和破坏极限),并通过改进试验所暴露的缺陷,按预期目标拓宽产品的应力极限。本文对一些应力极限的名词术语作了解释性说明,并具体论述了如何确定应力极限及快速温变循环试验的高低温温度极值。     

热真空设备中与温度相关的试验技术探讨

以RZHM-1400-AB型热真空试验箱为实例,简述设备主要工作原理。强调其温度传递方式及航天产品在热真空试验中温度参数的重要性。以无数试验数据为依据,着重论证何种类型测温传感器与实际设备相匹配,同时论证选取何种外形的测温传感器为最佳温度测量工具。同时,进一步介绍几种在热真空试验中使用这些测温传感器的方法,以减少不必要的人为测量误差。     

高加速应力试验装置技术参数的测量

气锤驱动的高加速应力试验装置,能产生温度和非高斯随机振动应力,其中振动应力是由多个气锤作六自由度运动产生的。一般用来进行高温步进、低温步进、快速温度变化、振动、快速温变和振动复合试验。目前国家标准和校准规程中均无关于该试验装置的技术参数的校准方法。本文结合试验装置的技术特点,提出了几个关于温度和振动技术参数的测量方法,如:温度偏差、温度波动度、温度均匀度、温度过冲量、温度变化速率、均方根加速度、横向振动比、功率谱密度等。     

文思湖底泥COD释放规律模拟研究

采用室内模拟实验方法,研究环境因子（温度、pH、扰动强度、供气量）对底泥释放COD的影响。结果表明,水温升高能加速底泥中有机质的释放;上覆水在弱酸至中性条件下底泥释放有机质最低;扰动上覆水体会加快有机质的释放。