受污染原水中有机物去除中试集成系统的工艺对比研究

在中试集成系统水平上对比研究了常规工艺、预臭氧化工艺、粒状活性炭吸附工艺、臭氧-生物活性炭工艺对受污染源水中的有机物及消毒副产物前体的去除效果.结果表明,前2种工艺对有机物的去除效能大致在50%～60%,后2种则能达到75%～90%.与前2种相比,后2种为更有效地去除受污染原水中有机物的方法.建议采用Ⅱ类及更优水体为水源的水厂考虑使用常规处理或季节性水质变化时采用预氧化工艺;而对于那些以Ⅲ类或更差水体为主水源的水厂则应考虑增设GAC或BAC设备,以满足饮用水水质新标准要求.     

长江口沙洲表层沉积物磷的赋存形态及生物有效性

利用磷的连续分级提取方法,研究了长江口沙洲沉积物中磷的赋存形态分布特征,并探讨了沉积物中磷的生物有效性.结果表明,沙洲沉积物中总磷的含量为437.6～1103.7μg·g-1,其中79.5%以无机磷的形式存在,而无机磷中以碎屑态磷灰石磷为主;有机磷约占总磷的20.5%.磷的生物有效性分析结果显示,潜在的生物有效性磷主要包括弱吸附态磷、铁结合态磷和有机磷等3种赋存形态,而长江口沙洲沉积物中潜在的生物有效性磷含量较少,约为60.5～510.9μg·g-1,平均仅占沉积物总磷的28.86%.     

沸石在水污染控制中的研究与应用进展

综述了沸石在水污染控制领域的理论研究和应用的进展。     

钢渣预处理含铬废水及其废渣与铬渣的固化

用钢渣对含铬废水进行预处理,探讨了钢渣粒度、用量、废水pH值和添加硫酸亚铁还原剂的影响.结果表明,经硫酸亚铁还原处理后再用钢渣处理比单纯用钢渣处理的效果明显提高,采用钢渣/总铬质量比为40的100目钢渣处理经硫酸亚铁还原后的含铬废水,总铬和Cr6 去除率分别达79%和84%,采用钢渣柱进行的两级淋滤实验进一步表明该方法可作为工业上含铬废水处理的预处理段.处理后的废钢渣同工业铬渣一起进行水泥固化,标准养护20 d后固化体表面Cr6 浸出率、破碎至5 mm粒径以下和酸雨淋溶下的浸出液Cr6 浓度均符合安全标准,可作为普通建材或进行填埋处置.     

含有机物铁泥的超临界水氧化法资源化

氨基染料生产过程中产生大量含有机物的铁泥,对环境造成严重污染并造成资源的极大浪费.利用超临界水氧化法对含有机物铁泥进行资源化处理研究,并对产物进行了X射线衍射分析(XRD)、色差实验与电子探针分析.研究结果显示,用超临界水氧化法处理铁泥可以将铁泥中所含的有机物完全氧化,真正实现环境友好;超临界水首先将铁泥氧化成α-Fe2O3与γ-Fe2O3,再经过800℃煅烧后可以作为氧化铁红颜料使用;超临界反应压力对样品的晶型与颜色影响不大.     

城市污水厂水质相关性及分布状态的研究和应用

采用统计学及质量控制的一些基本理论及方法对污水处理厂的运行数据进行分析,得出城市污水处理厂BOD5、COD、SS、TN、TP等主要出水指标呈正态分布的规律;城市污水BOD5、COD、TN、TP等指标间存在显著线性相关性的结论.研究结论可用于污水处理厂制定经济合理的出水监测方案以及对污水处理厂运行可靠性等进行评估.     

催化超临界水氧化处理1,5-萘二磺酸

采用Mn2O3/γ-AL2O3和V2O5/γ-Al2O/为催化剂,在一连续流固定床反应器中进行了超临界水氧化1,5-萘二磺酸实验.实验结果表明,在380～440℃,24 MPa条件下,Mn2O3/γ-Al2O3和V2O5/y-Al2O3催化剂对1,5-萘二磺酸的氧化降解具有显著的促进作用,TOC去除率达到90%以上;催化剂的催化效果随反应温度的升高而增强,随pH值的降低而增强,随停留时间的延长先增强后趋于平缓.     

Assessment of Environmental Water Demands (EWD) of Forests for Two Distinct Indian Ecosystems

Sustainable use of water and land resources requires that these scarce resources be appropriately allocated among various competing human activities. Worldwide, there is a realization now that sustainable river basin management should be accorded the highest priority, because it deals not only with technical, but also with ecological and socioeconomic aspects, and thus calls for a multidisciplinary and integrated approach. However, most of the policy and planning documents have either remained silent, or have made only implicit reference to the importance of environmental water demand (EWD) and its quantification. Therefore, in the light of its importance, a methodology has been evolved in this article for quantifying EWD for various forested areas in two distinctly different Indian river basins: Brahmani (humid zone) and Sabarmati (dry zone). The article analyzes and discusses EWD estimates at three different spatial levels: river basins, states, and districts within them, and finally presents a comparative analysis of all these results. Findings of the present study will be immensely useful in understanding various ecological issues connected with water resource projects and proposals in these river basins.     

Applying Integrated Urban Water Management Concepts: A Review of Australian Experience

This article explores recent Australian experiences in the application of the concept of integrated urban water management (IUWM) to land development sites through the review of 15 case studies. It discusses lUWM’s emergence and comments on the success or otherwise of Australian experience in its application. The understanding of IUWM is maturing within the Australian water industry, an occurrence that has been facilitated by demonstration sites such as those reviewed. Successes include the translation of IUWM concepts into well-functioning operational urban developments, significant reductions in the impact of the urban developments on the total water cycle, and the increasing acceptance of the concept within the water and land development industries. However, there is still room for greater integration of the water supply, stormwater, and wastewater components of the urban water cycle, improved dissemination of knowledge, enhancement of skills in both public and private organisations, and monitoring the performance of systems and technologies.     

硫化物生物氧化脱硫技术研究现状

介绍了近年来国内外硫化物生物氧化为单质硫的各种脱硫技术.分析总结了硫化物生物氧化为单质硫工艺的各种影响因素,包括氧硫比、溶解氧浓度、硫化物浓度、化学氧化、微生物菌种、pH值、温度等因素.提出了生物氧化脱硫技术的发展前景.该技术将脱硫和单质硫的回收和为一体,是一种安全、低成本将含硫废液变废为宝的工艺技术.