Benchmarking Optical/Thermal Satellite Imagery for Estimating Evapotranspiration and Soil Moisture in Decision Support Tools

Generally, one expects evapotranspiration (ET) maps derived from optical/thermal Landsat and MODIS satellite imagery to improve decision support tools and lead to superior decisions regarding water resources management. However, there is lack of supportive evidence to accept or reject this expectation. We “benchmark” three existing hydrologic decision support tools with the following benchmarks: annual ET for the ET Toolbox developed by the United States Bureau of Reclamation, predicted rainfall‐runoff hydrographs for the Gridded Surface/Subsurface Hydrologic Analysis model developed by the U.S. Army Corps of Engineers, and the average annual groundwater recharge for the Distributed Parameter Watershed Model used by Daniel B. Stephens & Associates. The conclusion of this benchmark study is that the use of NASA/USGS optical/thermal satellite imagery can considerably improve hydrologic decision support tools compared to their traditional implementations. The benefits of improved decision making, resulting from more accurate results of hydrologic support systems using optical/thermal satellite imagery, should substantially exceed the costs for acquiring such imagery and implementing the remote sensing algorithms. In fact, the value of reduced error in estimating average annual groundwater recharge in the San Gabriel Mountains, California alone, in terms of value of water, may be as large as $1 billion, more than sufficient to pay for one new Landsat satellite.     

Experimental investigation of a 250-kW turbine organic Rankine cycle system for low-grade waste heat recovery

An organic Rankine cycle (ORC) is generally used for converting low-grade heat into electricity. In this study, an extensive literature survey was conducted to identify current research gaps on experimental ORC systems. Specifically, there is limited experimental data and limited details on thermal and expander efficiencies of ORC systems. In order to address these gaps, the objective of this study included developing a turbine ORC with a power output exceeding 50 kW and thermal efficiency exceeding 8% for a heat source temperature < 120°C. The experimental results indicated that the system achieved a net power output of 242.5 kW and a thermal efficiency of 8.3% (the highest value for a turbine ORC system for the heat source temperature below 120°C). Thus, the study addressed the gaps identified in the research area of ORCs.     

热处理时间对餐厨垃圾高温干式厌氧发酵的影响

餐厨垃圾中有机物大部分以大分子的形式存在,对其进行热处理,破坏大分子有机物的存在形式,将会影响其干式厌氧发酵的过程。实验对餐厨垃圾进行了热处理(100℃),处理后将其在含固率(TS)20%、接种率25%的条件下进行高温55℃厌氧发酵。实验结果表明,热处理后,餐厨垃圾的理化性质发生显著变化,累计产气量、TS和VS的去除率均增大。当热处理时间为15 min时,餐厨垃圾的SCOD值最高,为59.49 g/L,比未处理时提高了3.3倍。同样该条件下,累计产气量也最高,为2 782.8 m L,与未处理相比累积产气量提高58.30%,第二产气高峰比未处理提前3天。各发酵瓶发酵前后TS、VS去除率的变化趋势与累计产气量的变化基本一致,累计产气量越大,TS、VS的去除率越大。     

密相塔半干法烟气脱硫塔内加湿降温及其对脱硫效率的影响

为了实现密相塔半干法脱硫工艺的精确加湿进一步提高系统脱硫效率,利用推导出的传热传质计算方法,得到烟气温度降低和加水量的关系.结合3组密相塔半干法工程实际数据,发现理论计算值和实测值误差区间仅为2.9％ ～5.4％.通过选取河北某钢厂210 m2烧结烟气密相塔半干法脱硫项目实际在线检测数据,发现循环脱硫灰含湿量为3％的系统脱硫效率整体高于含湿量为5％和4％的样品,最大值达93.56％.通过粒度分析、扫描电镜、X射线衍射及差热-热重对2种不同含湿量的循环脱硫灰进行表征,结果表明,含湿量为3％的循环脱硫灰较含湿量为5％的样品粒径小、比表面积大,无团聚现象,物相分析还证实相对于含湿量为5％样品,其Ca(OH)2和结晶水含量少,几乎都是CaSO4和CaS03干态物质,因此脱硫反应进行彻底,脱硫效率较高.     

磁性生物膜载体的规模化制备、表征和应用

利用机械力化学表面改性原理设计了卧式双旋搅拌混合反应设备,通过磁铁矿粉和适量浓硫酸的球磨混合反应制备得到磁性生物膜载体,其XRD、IR、SEM和BET表征分析结果表明,磁性生物膜载体表层生成了多羟基硫酸铁为主的活性组分.进而在膜生物反应器实验装置中投加磁性生物膜载体进行了中试实验,结果表明,磁性生物膜载体能与活性污泥中的微生物聚合形成稳定的菌胶团,活性污泥SV30从实验初期89％降到了稳定期的39％,此外,磁性生物膜载体还具有稳定膜生物反应池出水COD,强化脱氮除磷的能力.     

城市污水处理厂预热处理混合污泥的高温厌氧消化特性研究

针对165℃、30min预处理后的混合污泥,进行高温厌氧消化的连续试验.研究了在不同的水力停留时间(HRT)下的产气量、有机物的分解率等指标,探讨了"热处理 高温消化"实用化的可行性.结果表明,总固体(TS)为70g·L-1、预热处理后的混合污泥经高温厌氧消化,在HRT.为10、20、30d的条件下,产气率为2.82、1.70和1.19 L·L-1·d-1;降解单位COD的产气量为968、1053和1091 L·kg-1;COD分解率为47%～52%;有机物分解率与HRT的关系符合一级反应动力学关系.COD物质平衡计算结果表明,基质中50%的固态有机物被分解转化,生物气中的甲烷含量可达59.1%.本研究中的厌氧消化反应可归纳为C8.38H19.7O7.59N 3.86H2O→4.38CH4 2.99CO2 NH4 HCO3-.     

热解析-固相微萃取-气相色谱法测定空气样品中挥发性有机化合物

建立了热解析-固相微萃取-气相色谱法测定空气样品中挥发性有机化合物的分析方法,并对色谱分离条件、玻璃针筒保存样品的稳定性、固相微萃取萃取纤维、萃取时间、色谱进样时间等条件进行了优化,9种挥发性有机化合物的峰面积与其质量浓度在所测范围内有较好的线性关系,相对标准偏差＜8.8%,检出限为0.05～0.75 μg/100 mL,满足实际空气样品测定需要。     

污水污泥间壁热干燥实验研究

研究了污泥间壁热干燥的工艺过程,分析了其工艺参数、冷凝水水质和产生的污染气体,探讨了有机物水解机理.结果表明,污泥含水率与停留时间呈负指数函数相关.收集到的干燥冷凝水属高浓度有机废水,其总有机碳（TOC）、挥发性有机酸（VFA）和氨氮（NH₃-N）浓度均很高,pH值保持在9～9.5.干燥冷凝水中挥发性有机酸和氨氮来源于2部分：低温110 ～130℃时,主要发生蛋白质的水解,生成有机酸和氨氮;高温140～150℃时,主要发生脂肪类的水解,生成有机酸.干燥温度低于150 ℃时,污泥间壁热干燥过程无污染气体产生.     

Isolation, characterization and phylogenetic analysis of a bacterial strain capable of degrading acetamiprid

An aerobic bacterium, capable of degrading the new chloronicotine pesticide acetamiprid, was isolated from the sludge of pesticide factory after successive enrichment cultures and named strain FH2 which is a Gram-negative, rod-shaped, obligate aerobic org     

热阻力概念的修正及计算方法

以隧道火灾为背景,对一维加热管流中的热阻力进行了研究。通过压力场数值模拟与理论分析,直接证实了热阻力的存在,并表明传统概念上的热阻力明显大于实际的能量损失。根据能量方程提出水平无粘管流的热阻力应等于气流经过加热区的全压力降,而非静压力降;等截面管流的热阻力大小应为传统热阻力值的1/2。这一修正使热阻力概念具有了严格的流体力学意义。在定义新的热阻力系数基础上,建立了2个热阻力系数表达式及低马赫数条件下热阻力的近似表达式。将该近似表达式与热损失方程进行对比,表明两者在低马赫数条件下具有一致性。研究成果进一步发展了热阻力理论体系,对隧道火灾及其它相关工程热物理问题的研究与应用都具有重要价值。