活塞式压缩机的降噪治理

对天然气活塞式压缩机产生噪声的原因进行了分析,依据噪声产生机理,提出了相应的治理措施和对策,经过治理,达到了GB12348-90《工业企业厂界噪声标准》Ⅱ级标准,减少了噪声危害;保证了设备的正常操作及维护。     

顺丁橡胶塑化起火及处置技术

对顺丁橡胶生产过程中的塑化原因进行分析,提出了预防塑化及塑化后起火的处置技术。     

海洋水体原油污染存在形态及处置技术研究

详细描述了原油在海洋中存在的形态及对溢油事故的处置技术和方法,并结合原油的特性、气象水文条件等叙述了如何选择溢油处置方法。     

湿式电除尘器在细颗粒物控制中的应用

论述了湿式电除尘器的工作原理、技术特点、结构及设计形式,探讨了湿式电除尘器在我国的应用前景。     

“二级厌氧-微氧-好氧”组合工艺处理模拟碳纤维生产废水

对模拟碳纤维生产废水进行“厌氧-好氧”静态小试,根据COD的去除效果确定该碳纤维废水的可生化性。采用“二级厌氧-微氧-好氧”组合工艺进行动态中试,考察废水的处理效果及系统的抗冲击性能。试验结果表明：该工艺对碳纤维生产废水的处理效果较好;系统具有厌氧池出水pH增大的特点,且抗冲击能力较强;在厌氧池水温为28~38 ℃、好氧池水温不低于15 ℃、废水流量为100 L/h、进水COD为660 mg/L、进水ρ（氨氮）为4.9 mg/L的条件下,出水COD稳定在50 mg/L以下,ρ（氨氮）稳定在5 mg/L以下,能够满足GB 8978-1996《污水综合排放标准》的要求。     

改性兰炭末对硝基苯生产废水的吸附处理

采用H_2O_2溶液对兰炭末进行改性,并将改性后的兰炭末用于硝基苯生产废水(COD为560 mg/L)的吸附处理。对改性前后的兰炭末进行了表征,考察了吸附效果的影响因素,并对吸附前后改性兰炭末的燃烧热进行了测定。表征结果显示,兰炭末经改性后比表面积和孔径均增大。实验结果表明:在改性兰炭末投加量为0.2 g/m L、吸附时间为180 min、吸附温度为30℃的条件下,废水的COD去除率为93.4%,处理出水达到GB 8978—1996《污水综合排放标准》中规定的排放标准;改性兰炭末对废水中COD的吸附过程符合准二级动力学方程和Freundlich等温吸附模型;吸附后的改性兰炭末燃烧热值增大。     

喷淋工艺处理PVC塑料生产废气

采用喷淋工艺处理PVC塑料生产废气,将专利的吸收液与改型的喷淋塔相结合,在中试成功的基础上进行了实际工业化应用。应用结果表明:采用该工艺处理某PVC塑料生产企业的生产废气,吸收液在喷淋塔循环液中所占体积分数为15%时,废气中各污染物指标的去除率达85%以上,对于难处理的苯系物也能较好地去除;处理后废气中各污染物指标的含量满足GB 14554—1993《恶臭污染物排放标准》和DB 44/27—2001《大气污染物排放限值》的要求;该工艺装置运行费用较低,仅为电费和少量药剂费用,吸收液可循环使用,设备保养及维护简单,可满足市场需求。     

细砂卵砾石互层隧道围岩-支护失稳成因和处治措施

为避免细砂卵砾石互层隧道施工中发生隧道坍塌、砂涌、冒顶等安全事故,以在建的国道317线岗托隧道为工程依托,采用三维数值模拟计算和现场测试相结合的方法进行分析,探讨了施工过程中隧道围岩-支护的失稳机理,提出了相应的处治措施,最后通过对失稳前和处治后拱顶下沉、水平收敛的测试比较验证了处治效果。结果表明,细砂卵砾石互层隧道围岩-支护失稳的原因是围岩自稳能力差,超前支护适宜性差致使互层围岩不能有效固结,砂涌造成衬砌背后空洞,致使结构承载力降低,现场采用大管棚配合水平旋喷桩进行超前支护,实施效果明显。     

Occurrence, distribution, and potential influencing factors of sewage sludge components derived from nine full-scale wastewater treatment plants of Beijing, China

Millions of tons of waste activated sludge (WAS) produced from biological wastewater treatment processes cause severe adverse environmental consequences. A better understanding of WAS composition is thus very critical for sustainable sludge management. In this work, the occurrence and distribution of several fundamental sludge constituents were explored in WAS samples from nine full-scale wastewater treatment plants (WWTPs) of Beijing, China. Among all the components investigated, active heterotrophic biomass was dominant in the samples (up to 9478 mg/L), followed by endogenous residues (6736 mg/L), extracellular polymeric substances (2088 mg/L), and intracellular storage products (464 mg/L) among others. Moreover, significant differences (p < 0.05) were observed in composition profiles of sludge samples among the studied WWTPs. To identify the potential parameters affecting the variable fractions of sludge components, wastewater source as well as design and operational parameters of WWTPs were studied using statistical methods. The findings indicated that the component fraction of sewage sludge depends more on wastewater treatment alternatives than on wastewater characteristics among other parameters. A principal component analysis was conducted, which further indicated that there was a greater proportion of residual inert biomass in the sludge produced by the combined system of the conventional anaerobic/anoxic/oxic process and a membrane bioreactor. Additionally, a much longer solids retention time was also found to influence the sludge composition and induce an increase in both endogenous inert residues and extracellular polymeric substances in the sludge.     

挥发性有机污染物及恶臭生物处理技术综述

工业生产、污水及垃圾处理等过程产生的挥发性有机污染物(VOCs)和恶臭物质逸散到空气中会对环境和人体健康产生危害。利用生物技术处理大流量、低浓度VOCs和恶臭物质具有处理效果好、投资及运行费用低、无二次污染的优点。阐述了生物滤池、生物洗涤塔和生物滴滤池等常规生物处理技术,以及真菌生物反应器、膜生物反应器、生物转鼓过滤器、生物物化组合反应器等新型生物处理技术的特性、适用范围、应用现状及研究进展,并对废气生物处理技术的前景进行了展望。