电站锅炉水冷壁和过热器爆管分析

采用宏观形貌分析、化学成分分析、金相显微组织分析、材料力学性能测试、SEM微观形貌分析等手段,对某电站锅炉水冷壁管和过热器管破裂进行了分析。结果表明,热（硫）腐蚀导致的过热器管局部穿孔破裂,以及泄漏产生的高温水汽流对水冷壁管的,中刷磨损是爆管的主要原因,过热器管补焊点的再次泄漏是本次事故的直接原因。     

Experimental analysis of thermal performance of evacuated tube and flat-plate solar air collectors at different air flow rates

The thermal performances of an evacuated tube collector (ETC) and flat-plate solar air collector (FPC) are experimentally investigated at different air flow rates. To investigate the performance of the ETC and FPC, experimental set-ups were fabricated. Air was used as a working fluid and tested at the same climatic conditions. The ETC had 15 evacuated tubes with a surface area of 1.66 m². The experimental set-up consisted of a header with a hollow pipe (square pipe) in the centre through which the air flowed. The flat-plate collector had a surface area of 1.35 m². The FPC had a black painted absorber sheet which divides the collector into two sections. The air flowed through the upper and the lower sections parallel to the collector to minimize the overall heat loss. The temperature of the outlet air depends on several factors along with the airflow rate and the intensity of the solar radiation. It was found that during the day at high flow rates, the efficiency of the ETC varies from 0.12 to 0.5, and for the flat plate it was from 0.29 to 0.68. The maximum temperature of the air was 56.7°C for the ETC and 25.7°C for the FPC.     

爆炸形成过程中火焰加速的试验研究

为预防和控制工业爆炸事故,并为脉冲爆轰发动机的研究提供理论指导,分析火焰加速导致的燃烧转爆轰过程的影响因素。采用爆轰管探讨障碍物的阻塞比、混合物的组成、初始压力和点火能等4个因素对爆炸性气体火焰速度和爆轰压力的影响规律。试验结果表明:障碍物的存在能大大提高火焰速度和爆轰压力;爆轰压力随管内障碍物阻塞比的增大先变大后减小,并在阻塞比为0.498,燃料种类为天然气,化学当量比为1时达到最大;爆轰压力还随混合气体初始压力的增大和点火能的提高而增大。选择适宜的条件可大大提高火焰加速速率,促进燃烧向爆轰过程转变。     

Numerical simulation of propane detonation in medium and large scale geometries

A modelling strategy has been developed for consequence analysis of medium and large scale gaseous detonation. The model is based on the solution of Euler equations with one-step chemistry. The Van Leer flux limited method which is a total variation diminishing scheme is used for shock capturing. Preliminary calculations were firstly conducted for small domains with fine grids which resolve the wave, relatively coarse grids which have less than 10 grids across the wave and coarse grids in which the minimum grid size is larger than the wave thickness to ensure that the reaction scheme has been properly tuned to capture the correct detonation pressure, temperature and velocity in the resolutions used in the different cases. The model was firstly tested against a medium scale detonation test in a shock tube with U-bends. Reasonably good agreement is achieved on detonation pressure and mean shock wave velocities at different measuring segments of the tube. Following the validation, the detonation of a hypothetical planar propane-air cloud is simulated. The predictions uncovered some interesting features of such large scale detonation phenomena which are of significance in the safety context, especially for accidental investigations. The findings from the present analysis are in line with the forensic evidence on damages in some historic accidents and challenges previous analysis of a major accident in which forensic evidence suggested localised detonation but was considered as the consequence of fire storms by the investigation team.     

毛细管柱气相色谱法测定环境空气中1,2-二氯乙烷

采用毛细管柱气相色谱法测定环境空气中的1,2-二氯乙烷,用活性碳吸附,二硫化碳解析,FID检测器分析.方法在0 mg/L～311mg/L范围内线性良好,当采样体积为20 L时,最低检出质量浓度为0.006 mg/m3,标准溶液平行测定的RSD≤2.2%,加标回收率为98.4%～101%.     

机载设备的噪声环境试验研究

介绍了标准中所规定的试验载荷的计算方法,2种噪声试验装置——高声强混响室和高声强行波管,以及高声强试验系统和测试系统的组成。以GJB 150．86—17的图1声谱为基准,开展了机载设备的噪声环境试验研究,对噪声试验中试验夹具的设计和制造、试验样品的安装、试验前的检查和试验程序进行了说明,采用了开环和闭环方式控制声场,试验结果达到了国军标的要求。     

气溶胶粒子在毛细管中沉积与再悬浮

采用亚微米单分散聚苯乙烯球形硬气溶胶粒子和脉冲进样技术,测定了气溶胶粒子在管道中的沉积率,研究了沉积率与流体速度、管道长度、管道直径和气溶胶粒子大小之间的关系.结果发现,在相同条件下,沉积率随管长增加而增大;随流体速度增加而减小.在相同体积流量下,沉积率与管径关系不大;而沉积率与气溶胶粒子大小之间的关系比较复杂.沉积的气溶胶粒子如果在更大流速冲击下,将发生反弹,部分气溶胶粒子从黏附表面上分离再次悬浮于流体中.     

电化学产电菌的分离及性能评价

利用兼性滚管法分离了折流板空气阴极微生物燃料电池(BAFMFC)A、B两格室的阳极生物膜,共获得19株纯菌.将菌株投加至无菌立方型反应器中,检验其产电特性.利用交流阻抗法测量各纯菌电池的内阻,结果显示38个电池的欧姆内阻为25Ω±5Ω,说明了各电池的产电差异来源于菌株本身的活性.其他运行条件均保持不变,在1000Ω外阻下,7株纯菌电池的输出电压在200mV以上.其中,A格室产电活性最高的菌株(A2)产生的最大电压为328mV,输出的最大功率密度为165.1mW/m2,B格室产电活性最高的菌株(B1)最大电压为241mV,最大功率密度为214.4mW/m2.原子力显微镜和脂肪酸快速鉴定表明,A2为肠杆菌科的杆菌,B1为厚壁菌门的芽孢杆菌.     

原油加热炉炉管剩余寿命评估

根据加热炉炉管温度分布,提出了加热炉炉管剩余寿命评估方法:即炉管蠕变损伤后剩余寿命的评估和腐蚀损伤后剩余寿命的评估,采用此方法对在用加热炉进行了评估,并对评价结果进行了验证.     

硅胶管吸附气相色谱法测定气体中的乙酸、丙酸

建立了用GC-FID同时测定空气中乙酸、丙酸的方法.乙酸、丙酸经硅胶管吸附后,用丙酮溶剂解吸,气相色谱分析.优化条件下,在20 ～2 000 mg/L范围内有良好的线性关系.方法检出限分别达到了1.0 mg/m3和0.5 mg/m3,相对标准偏差2.2％和1.9％,回收率在94％以上.