环境中多氯联苯（PCBs）的分析方法研究

探讨了环境中多氯联苯（PCBs）来源特性和分析检测方法。讨论了目前较为常用的样品前处理方法,如溶剂萃取法、固相萃取法、固相微萃取法等,常见的检测方法包括化学分析法和生物分析法,并对PCBs分析检测的发展前景进行了展望。     

水喷淋液滴的动力学参数研究

本文详细介绍了喷淋液滴的一些动力学参数:(1)液滴动量喷淋的最大动量和体积流量与流量系数有关.水流碰到溅水盘和盘臂后,动量减少,其动量减少量约63%.(2)液滴粒径分布当液滴直径小于平均体积直径DV50时,分布符合log-normal分布,当液滴直径大于DV50时,分布符合Rosin-Rammler分布.(3)水流量分布对不同的喷头,其水量分布是不同的.有的喷头水流量沿径向逐渐降低,有的喷头中心地带流量最高.(4)液滴路径分析液滴越大,自由沉降速度越大,水平通过的距离越大.最后对喷头的进一步发展进行展望.     

Cloud point extraction coupled with HPLC-UV for the determination of phthalate esters in environmental water samples

A method based on cloud point extraction was developed to determine phthalate esters including di-ethyl-phthalate （DEP）, di- （2-ethylhexyl）-phthalate （DEHP） and di-cyclohexyl-phthalate （DCP） in environmental water samples using high-performance liquid chromatography separation and ultraviolet detection （HPLC-UV）. The non-ionic surfactant Triton X-114 was chosen as extraction solvent. The parameters affecting extraction efficiency, such as concentrations of Triton X-114 and Na2SO4, equilibration temperature, equilibration time and centrifugation time were evaluated and optimized. Under the optimum conditions, the method can achieve preconcentration factors of 35, 88, 111 and detection of limits of 2.0, 3.8, 1.0 ng/ml for DEP, DEHP and DCP in 10-ml water sample, respectively. The proposed method was successfully applied to the determination of trace amount of phathalate esters in effluent water of the wastewater treatment plant and the lixivium of plastic fragments.     

Determination of haloacetic acids concentrations in hospital effluent after chlorination by ion chromatography

The ion chromatography combined solid phase extraction (SPE) method was developed for the analysis of low concentration haloacetic acids(HAAs),a calss of disinfection by-products formed as a result of chlorination of hospital wastewater. The monitored HAAs included monochloroacetic acid, monobromoacetic acid, dichloroacetic acid, dibromoacetic acid and trichloroacetic acid. The method employed a sodium hydroxide eluent at a flow rate of 0.8 ml/min, electrolytically generated gradients, and suppressed conductivity detection. To analyze the HAAs in real hospital wastewater samples, C18 pretreatment cartridge was utilized to reduce samples' turbidity. Preconcentration with SPE and matrix elimination with treatment cartridges were investigated and were found to be able to obtain acceptable detection limits. Linearity, repeatability and detection limits of the above method were evaluated. The detection limits of monobromoacetic acid and dibromoacetic acid were 2.61 μg/L and 1.30 μg/L respectively, and the other three are ranging from 0.48 to 0.82 μg/L under 25-fold preconcentration. When the above optimization procedure was applied to three hospital wastewater samples with different treatment processes in Tianjin, it was found that the dichloroacetic acid is the major compound, and the growth ratios of the HAAs after disinfection by sodium hypochlorite were 91.28%, 63.61% and 79.50%, respectively.     

Formation of multiple trimethylsilyl derivatives in the derivatization of 17α-ethinylestradiol with BSTFA or MSTFA followed by gas chromatography-mass spectrometry determination

N,O-bis(trimethylsily)trifluoroacetamide (BSTFA) and N-methyl-N(trimethylsily) trifluoroacetamide (MSTFA) are common derivatization reagents used in the GC-MS analysis of estrogen steroids such as estrone (E1) and 17(-ethinylestradiol (EE2). In this study, three trimethylsilyl (TMS) steroid derivatives, mono-and di-trimethylsilyl EE2 and mono-trimethylsilyl E1, were observed during the derivatization of EE2 with BSTFA or MSTFA and/or GC separation. Factors influencing the production of multiple TMS derivatives and their relative abundance were examined. It was found that both methanol and bisphenol A competed with estrogenic esteroids when reacting with silylation reagents, and thus affected the formation of TMS derivatives and their relative abundance in the derivatization products. Methanol was found to be more reactive than bisphenol A with the BSTFA reagent. None of the three solvents tested in this study could prevent the generation of multiple TMS derivatives during the derivatization of EE2 with BSTFA, followed by GC analysis. A similar result was observed using MSTFA as the derivative reagent followed by GC analysis. Thus, the suitability of BSTFA or MSTFA as the derivatization reagent for the determination of E1 and EE2 by GC-MS, under the conditions reported here, is questionable. This problem can be solved by adding trimethylsilylimidaz (TMSI) in the BSTFA reagent as recommended, and the performance of the method has been proved in this study.     

Community analysis of ammonia and nitrite oxidizers in start-up of aerobic granular sludge reactor

A lab-scale sequencing batch reactor (SBR) was setup and the aerobic granular sludge was successfully incubated by using anaerobic granular sludge as seed sludge. Nitrogen was partially removed by simultaneous nitrification and denitrification (SND) via nitrite with free ammonia (FA) of about 10 mg/L. The denaturing gradient gel electrophoresis (DGGE) method was used to investigate community structure of α-Proteobacteria, β-Proteobacteria, ammonia oxidizing bacteria (AOB), and Nitrospira populations during start-up. The population sizes of bacteria, AOB and Nitrospira were examined using real-time PCR method. The analysis of community structure and Shannon index showed that stable structure of AOB population was obtained at the day 35, while the communities of α-Proteobacteria, β-Proteobacteria, and Nitrospira became stable after day 45. At stable stage, the average cell densities were 1.1×1012, 2.2×1010 and 1.0×1010 cells/L for bacteria, AOB and Nitrospira, respectively. The relationship between characteristics of nitrifying bacteria community and nitrogenous substrate utilization constant was discussed by calculating Pearson correlation. Certain correlation seemed to exist between population size, biodiversity, and degradation constant. And the influence of population size might be greater than that of biodiversity.     

Conceptualizing Discourses on Ecological City and Its Planning

Abstract

Ecological city (eco-city) and its planning approach are emerging concepts in urban study, urban planning, ecological economics, environmental policy and corporate environmental management. However, opinions remain divided over the connotation and denotation of the term “ecological city”, what key issues ecocity planning can solve, and its specific contents. In this study, we present 10 basic propositions that define the eco-city and clarify its key parameters, thereby providing the basis for discussing the assumptions and principles underlying different approaches to sustainable urban development. We then summarize the concept and principles of an eco-city, and define the main requirements for ecocity planning. We conclude that an eco-city is a city in which the urban population, scale of land use and intensity of human activities are limited to the regional resource and environmental carrying capacity, which does not cause increasing or irreversible damage to the regional ecosystem’s structure, functions and processes.     

基于大气超级站观测的2017年5月北京市沙尘天气过程分析

结合常规污染物监测、PM_2.5化学组分监测、激光雷达监测和颗粒物数浓度及粒径监测等手段,对2017年5月影响北京市的一次沙尘天气过程进行分析。结果表明：5月4日凌晨起沙尘天气开始影响北京市,延庆、官园和通州3个站点PM₁₀峰值浓度分别为2 091、2 245、2 590 μg/m³,体现了该次沙尘天气影响程度之重。PM_2.5浓度与PM₁₀变化一致,也达到重度污染的水平。沙尘天气移动路径是沿着区域西北至东南方向。沙尘天气主体从3 km左右的高空进入北京市,随后逐渐渗透至1 km高度以及地面,且沙尘层厚度较高,覆盖了地面至3 km的高度。沙尘天气过程中OM和Ca²⁺组分增幅最大。在沙尘天气影响严重时间段,沙尘天气源与生物质燃烧源比例之和大于50%,最高值为67.6%。沙尘天气过程中颗粒物峰值粒径为0.965~1.037 μm。     

尾矿坝浸润线数据挖掘预测模型的样本选取研究

本文分别应用时间序列功能模型和回归模型,在原始数据的基础上建立样本,并运用支持向量回归机算法对样本进行训练,得出了尾矿坝浸润线埋深预测模型并进行了实例应用。研究证明,运用时间序列模型选取训练样本能够得出更为精确的预测结果。     

改进的QuEChERS-LC/MS/MS法快速检测蔬菜中7种农药残留

研究建立了蔬菜中农药多残留的快速检测QuEChERS-LC/MS/MS方法,优化了实验方案,样品以0.1%乙酸的乙腈（V/V）作为溶剂,Agilent Bond Elut提取试剂盒对样品进行1 min提取后,用C18和Agilent Bond Elut净化试剂盒净化。结果表明：7种农药的平均回收率为72%～127%,相对标准偏差为1.3%～16.3%,检出限为0.004～0.022 mg·kg^-1。该方法减少了溶剂用量,缩短了检测时间,每个样品溶剂用量仅为20 mL,每个样品的前处理费用大约为30元,一个实验人员每日可以处理50～60个蔬菜样品,真正实现农残的快速、简便、廉价、有效、灵敏、安全检测。