Feasibility of honeycomb monolith supported sugar catalyst to produce biodiesel from palm fatty acid distillate (PFAD)

Carbon coated monolith was prepared by sucrose solution 65 wt.% via dip-coating method. Sulfonation of incomplete carbonized carbon coated monolith was carried out in order to synthesize solid acid catalyst. The textural structure characteristics of the solid acid catalyst demonstrated a low surface area and pore volume. Palm fatty acid distillate (PFAD), a by-product of palm oil refineries, was utilized as oil source in biodiesel production. The esterification reaction subjected to different reaction conditions was performed by using the sulfonated carbon coated monolith as heterogeneous catalyst. The sulfonation process had been performed by using vapour of concentrated H₂SO₄ that was much easier and efficient than liquid phase sulfonation. Total acidity value of carbon coated monolith was measured for unsulfonated sample (0.5 mmol/g) and sulfonated sample (4.2 mmol/g). The effect of methanol/oil ratio, catalyst amount and reaction time were examined. The maximum methyl ester content was 89% at the optimum condition, i.e. methanol/oil molar ratio (15:1), catalyst amount (2.5 wt.% with respect to PFAD), reaction time (240 min) and temperature 80 °C. The sugar catalyst supported on the honeycomb monolith showed comparable reactivity compared with the sugar catalyst powder. However, the catalyst reusability studies showed decrease in FFA% conversion from 95.3% to 68.8% after four cycles as well as the total acidity of catalyst dropped from the value 4.2 to 3.1 mmol/g during these cycles. This might be likely due to the leaching out of SO₃H group from the sulfonated carbon coated monolith surface. The leaching of active species reached a plateau state after fourth cycle.     

Nanoencapsulation of hexavalent chromium with nanoscale zero-valent iron: High resolution chemical mapping of the passivation layer

Solid phase reactions of Cr(Ⅵ) with Fe(0) were investigated with spherical-aberration-corrected scanning transmission electron microscopy(Cs-STEM) integrated with X-ray energy-dispersive spectroscopy(XEDS). Near-atomic resolution elemental mappings of Cr(Ⅵ)–Fe(0) reactions were acquired. Experimental results show that rate and extent of Cr(Ⅵ) encapsulation are strongly dependent on the initial concentration of Cr(Ⅵ) in solution. Low Cr loading in nZⅥ(1.0 wt%) promotes the electrochemical oxidation and continuous corrosion of n ZⅥ while high Cr loading(1.0 wt%) can quickly shut down the Cr uptake. With the progress of iron oxidation and dissolution, elements of Cr and O counter-diffuse into the nanoparticles and accumulate in the core region at low levels of Cr(Ⅵ)(e.g., 10 mg/L). Whereas the reacted n ZⅥ is quickly coated with a newly-formed layer of 2–4 nm in the presence of concentrated Cr(Ⅵ)(e.g., 100 mg/L). The passivation structure is stable over a wide range of pH unless pH is low enough to dissolve the passivation layer. X-ray photoelectron spectroscopy(XPS) depth profiling reconfirms that the composition of the newly-formed surface layer consists of Fe(Ⅲ)–Cr(Ⅲ)(oxy)hydroxides with Cr(Ⅵ) adsorbed on the outside surface. The insoluble and insulating Fe(Ⅲ)–Cr(Ⅲ)(oxy)hydroxide layer can completely cover the n ZⅥ surface above the critical Cr loading and shield the electron transfer. Thus, the fast passivation of nZⅥ in high Cr(Ⅵ) solution is detrimental to the performance of nZⅥ for Cr(Ⅵ) treatment and remediation.     

HNO_3─KI─MIBK萃取／原子吸收光谱法测定固体废物浸提液中的微量银

采用选择性较好的ＨＮＯ３—ＫＩ—ＭＩＢＫ萃取体系对铋渣和尾矿渣浸出液中的痕量银进行预分离富集后，用火焰原子吸收法（ＡＡＳ）进行测定。此法不仅变异系数小（约为３．１％），而且检出限比直接火焰ＡＡＳ法降低两个数量级，达０．５ｎｇ／ｍｌ．另外，还就作品细度对银测定结果的影响原因做了初步探讨。     

高温嗜粪菌的选育和猪粪发酵研究

筛选得到了８株嗜高温（５５℃）嗜粪细菌，均具有较强的发酵猪粪能力。加入所选育菌株进行的猪粪高温（５５℃）固体好氧发酵实验发明，２４ｈ内可将猪粪发酵成无臭味、深褐色的稳定和无害化产物，常温下长时间放置也不会产生腐败和臭味。此发酵产物的氮试验法结果显示，猪粪已发酵至表观成熟和稳定化，可作为进一步制取优质有机复合肥料的良好前体物。     

Z形弯曲件及其模具的特点分析

此文对Z形弯曲件做了较系统的分析归类,并介绍了几种常用的Z形弯曲模的特点,以及这些模具的适应范围。     

Molecular behavior and interactions with microbes during anaerobic degradation of bio-derived DOM in waste leachate

It is the key to control bio-derived dissolved organic matters (DOM) in order to reduce the effluent concentration of wastewater treatment, especially for waste leachate with high organic contaminants. In the present study, the anaerobic degradation of aerobically stabilized DOM was investigated with DOM substrate isolated through electrodialysis. The degradation of bio-derived DOM was confirmed by reduction of 15% of total organic carbon in 100 days. We characterized the molecular behavior of bio-derived DOM by coupling molecular and biological information analysis. Venn based Sankey diagram of mass features showed the transformation of bio-derived DOM mass features. Occurrence frequency analysis divided mass features into six categories so as to distinguish the fates of intermediate metabolites and persistent compounds. Reactivity continuum model and machine learning technologies realized the semi-quantitative determination on the kinetics of DOM mass features in the form of pseudo-first order, and confirmed the reduction of inert mass features. Furthermore, network analysis statistically establish relationship between DOM mass features and microbes to identify the active microbes that are able to utilize bio-derived DOM. This work confirmed the biological technology is still effective in controlling recalcitrant bio-derived DOM during wastewater treatment.     

脉冲电晕等离子体脱硫脱氮与除尘技术

脉冲电晕放电是产生等离子体的方法之一，目前已达到工业性试验阶段，该文对脉冲电晕等离子脱硫脱氮与除尘技术的形成过程进行了回顾，对其理论作了分析，并简介了工艺流程，还指出了目前存在的主要问题和需研究的关键技术。     

炼油企业固体废弃物的防治

就炼油企业固体废物产生的数量和主要种类进行了分析和总结，对目前的防治进行了论述，并提出了对固废进一步减量化、资源化、无害化管理和治理的途径。     

脉冲电晕等离子体净化正己烷的实验研究

对脉冲电晕等离子体技术净化有机污染物－正己烷进行了实验研究，考察脉冲成形电容、脉冲峰值电压、脉冲频率、气体流量、气体人口浓度等因素对净化效率的影响，结果表明，成形电容有一最佳值，净化效果随峰值电压、脉冲频率增大而升高；随气体流量、进口浓度增大而降低。     

一个填埋场的气体排放控制系统的建立及其从中得到的几点启示

介绍位于纽约州北汉姆斯特城的ＰｏｒｔＷａｓｈｉｎｇｔｏｎ城市固体废弃物填埋场填埋气体的排放、监测和处理系统及其有关测试数据和从中得到的启示．