长炼第二污水处理场氧化沟工艺运行小结

臭伯尔氧化沟池容大，停留时间长，运行稳定，对氧化沟污泥培养及开工运行进行了小结，并结合运行过程中的几个问题进行了分析和探讨。     

电子受体类型对聚磷污泥胞外聚合物的影响研究

采用3种电子受体(硝氮、亚硝氮、氧),在SBR反应器中分别驯化了具有稳定除磷能力的聚磷污泥。对比研究了不同聚磷污泥胞外聚合物(EPS)的组分与含量,结合三维荧光光谱对EPS中有机物质进行分析。研究表明,以硝氮、亚硝氮为电子受体的聚磷污泥EPS平均浓度较为接近,分别为115.6mg/gVSS、133.5 mg/gVSS,由厌氧段至缺氧段,EPS总浓度有所下降。以氧为电子受体聚磷污泥的EPS平均浓度相对较高,为194.5 mg/gVSS,由厌氧段至好氧段,EPS总浓度略有升高。不同聚磷污泥的EPS组分均以胞外蛋白为主,占EPS总量的53%~65%,多糖与核酸占EPS总量28%~34%、5%~7%。三维荧光光谱显示3种聚磷污泥EPS均具有芳香结构蛋白质、可溶性代谢物的荧光峰,另外,以硝氮为电子受体的聚磷污泥还具有明显的腐殖酸类物质的荧光峰。研究结果表明电子受体对聚磷污泥EPS的组分、浓度、有机质类别有一定的影响。     

上流式多级处理厌氧反应器（UMAR）处理棉浆黑液

棉浆黑液是高浓度有机废水,有较好的厌氧可生化性。利用上流式多级处理厌氧反应器处理棉浆黑液,容积负荷在14．4—24kg／（m^3·d）之间,平均COD去除率可达到80％,同时可产生沼气,具有很好的应用前景。     

SBR生物反应器出水溶解态有机物性质特点研究

研究中考察了SBR生物反应器处理实际生活污水过程中,反应器内部溶解性有机物的变化情况,重点分析了污泥龄对于SBR反应器出水溶解态有机物性质特点的影响.研究结果表明,生物降解过程中,以分子量650Da、1700Da和2000Da为代表的腐殖质类有机物逐渐积累,小分子量有机物(<200Da)逐渐转化为具有中间分子量(500...     

壳聚糖絮凝剂在活性污泥调理中的应用

研究了自制的壳聚糖絮凝剂在活性污泥调理中的应用,通过污泥比阻、上清液剩余浊度、泥饼含水率及沉降性能等的测定,重点分析了活性污泥脱水的pH范围、絮凝剂投量和壳聚糖分子量及其脱乙酰度对调理效果的影响,并与絮凝剂聚丙烯酰胺(PAM)和聚合氯化铝(PAC)作了比较,在此基础上还进行了双絮凝剂两段法处理污泥的初步探索。研究发现,壳聚糖作为活性污泥调理剂,投量(干污泥质量百分比)在0.8％～1.2％,pH值在5～8时即有较好的调理效果,与PAM效果基本相当,接近于8％～16％的PAC;壳聚糖相对分子量在30×10~4左右,脱乙酰度在70％左右时有较好的调理效果;双絮凝剂两段法处理污泥,在同等用量时效果好于单絮凝剂一段法。     

好氧MBBR处理含吲哚废水的工艺优化试验研究

为了处理制药企业废水中吲哚类有机污染物,采用好氧MBBR(移动床生物膜反应器)工艺对含吲哚废水进行了试验研究,通过考察HRT、曝气量、吲哚冲击负荷等工艺条件对吲哚、COD和NH_4~+-N等去除效果的影响,确定了好氧MBBR反应器的最佳工艺条件。实验结果表明,在HRT在6~18 h变化时,MBBR工艺对吲哚去除率在8 h以上时达到100%,COD去除率在8 h达到89.65%,而NH_4~+-N去除率在12 h达到最高。在曝气量为0.1~0.12 m L/min时,MBBR工艺对COD和NH_4~+-N去除率分别为88.88%~92.95%和65%~66.83%。进水吲哚浓度25~65 mg/L变化时,好氧MBBR对吲哚去除率保持在100%,而对COD和NH_4~+-N去除率也保持在80%和40%以上,表明好氧MBBR工艺在处理难降解有机污染物方面具有显著优势。     

Effects of sludge retention time, carbon and initial biomass concentrations on selection process: From activated sludge to polyhydroxyalkanoate accumulating cultures

Four sequence batch reactors (SBRs) fed by fermented sugar cane wastewater were continuously operated under the aerobic dynamic feeding (ADF) mode with different configurations of sludge retention time (SRT), carbon and initial biomass concentrations to enrich polyhydroxyalkanoate (PHA) accumulating mixed microbial cultures (MMCs) from municipal activated sludge. The stability of SBRs was investigated besides the enrichment performance. The microbial community structures of the enriched MMCs were analyzed using terminal restriction fragment length polymorphism (T-RFLP). The optimum operating conditions for the enrichment process were: SRT of 5 days, carbon concentration of 2.52 g COD/L and initial biomass concentration of 3.65 g/L. The best enrichment performance in terms of both operating stability and PHA storage ability of enriched cultures (with the maximum PHA content and PHA storage yield (Y_PHA/S) of 61.26% and 0.68 mg COD/mg COD, respectively) was achieved under this condition. Effects of the SRT, carbon concentration and initial biomass concentration on the PHA accumulating MMCs selection process were discussed respectively. A new model including the segmentation of the enrichment process and the effects of SRT on each phase was proposed.     

Body mass estimations for <Emphasis Type="Italic">Plateosaurus engelhardti</Emphasis> using laser scanning and 3D reconstruction methods

Both body mass and surface area are factors determining the essence of any living organism. This should also hold true for an extinct organism such as a dinosaur. The present report discusses the use of a new 3D laser scanner method to establish body masses and surface areas of an Asian elephant (Zoological Museum of Copenhagen, Denmark) and of Plateosaurus engelhardti, a prosauropod from the Upper Triassic, exhibited at the Paleontological Museum in Tübingen (Germany). This method was used to study the effect that slight changes in body shape had on body mass for P. engelhardti. It was established that body volumes varied between 0.79 m³ (slim version) and 1.14 m³ (robust version), resulting in a presumable body mass of 630 and 912 kg, respectively. The total body surface areas ranged between 8.8 and 10.2 m², of which, in both reconstructions of P. engelhardti, ∼33% account for the thorax area alone. The main difference between the two models is in the tail and hind limb reconstruction. The tail of the slim version has a surface area of 1.98 m², whereas that of the robust version has a surface area of 2.73 m². The body volumes calculated for the slim version were as follows: head 0.006 m³, neck 0.016 m³, fore limbs 0.020 m³, hind limbs 0.08 m³, thoracic cavity 0.533 m³, and tail 0.136 m³. For the robust model, the following volumes were established: 0.01 m³ head, neck 0.026 m³, fore limbs 0.025 m³, hind limbs 0.18 m³, thoracic cavity 0.616 m³, and finally, tail 0.28 m³. Based on these body volumes, scaling equations were used to assess the size that the organs of this extinct dinosaur have.     

SBR法处理低C/N污水的工程应用——以某基地污水处理站改造工程为例

低C/N污水的生化处理过程中,由于碳源不足,不能满足硝化和反硝化的要求,造成出水NH3-N超标。采用SBR工艺对某基地污水处理站厌氧处理后的低C/N污水进行改造,处理后出水COD去除率达到97%以上,NH3-N去除率达到93%以上。     

Recycling of an industrial sludge and marine clay as light-weight aggregates

The geographical limitations of Singapore, its restricted natural resources and voluminous municipal and industrial waste streams, make environmental management a major challenge for the island state. In an attempt to find ways to reduce importation of raw materials and the waste sent to landfill, light weight aggregates were produced from marine clay and a CaF(2)-rich semiconductor industry sludge. Aggregates were produced in a bench-scale rotary kiln with three clay/sludge loadings (90/10, 70/30 and 50/50%). All three mixtures showed good bloating behavior during firing and the ceramic pellets (1-1.5cm diameter) had densities well below that required for light-weight aggregates. In the initial tests, the pore sizes of the aggregates were in general too large resulting in high water absorption. Comparisons between the composition of the two waste products and the aggregates showed a significant loss of fluorine (40-60%) during processing; a problem which may require flue gas treatment. Leach testing showed that the formed aggregates would not pose a human or environmental hazard in terms of fluorine mobilization.