森林合理年伐量分析确定方法研究

森林合理年伐分析确定是年森林采伐限额编制的关键技术之一,也是森林经理学的重要内容之一。本文从森林永续利用理论出发,以消长比度、成熟林采伐度、龄级结构改善度、流量均衡度、需要满足度５个指标建立了分析确定的综合评价模型,提出了森林合理年伐量分析确定的精确化方法,从而有效地保证了结果的科学性和准确性。     

Measurement of respiration amount of white birch(Betula platyphylla) population in the mountainousregion of Beijing

Ｍｅａｓｕｒｅｍｅｎｔｏｆｒｅｓｐｉｒａｔｉｏｎａｍｏｕｎｔｏｆｗｈｉｔｅｂｉｒｃｈ（Ｂｅｔｕｌａｐｌａｔｙｐｈｙｌｌａ）ｐｏｐｕｌａｔｉｏｎｉｎｔｈｅｍｏｕｎｔａｉｎｏｕｓｒｅｇｉｏｎｏｆＢｅｉｊｉｎｇＦａｎｇＪｉｎｇｙｕｎ，ＷａｎｇＸｉａｏｋｅ（...     

大直径TA2卷焊坯制备工艺

此文介绍尺寸为φ1547×L900×δ30的大直径TA2卷焊坯的制备工艺。主要包括卷焊坯设计、展开下料的计算、卷圆工艺、焊接工艺等,可供同类材质圆筒件卷圆时参考。     

呼和浩特市不同粒径空气颗粒物中汞的分布规律

采用分级采样装置 ,于冬夏两季采集呼市三个不同功能区不同粒径空气颗粒物中的汞进行分析 ,结果表明 :呼市空气颗粒物中的汞含量冬季明显高于夏季 ;冬季空气颗粒物中的汞含量为居民区 >交通区 >对照区 ,夏季为交通区 >居民区 >对照区 ;空气中汞主要富集在可吸入粒子中。     

南京市城区气溶胶粒度分布特征

以九段串级式撞击采样器对南京市气溶胶进行采样测定。经统计分析发现，气溶胶呈双峰分布，粒度分布规律明显，峰值粒径在0.37μm-0.65μm和4．3μm-5.6μm之间，气溶胶浓度季节变化显著，秋季＞夏秋，秋季颗粒物中细粒子质量百分比较夏季的多，两季质量中位位直径分别为6．5μm,4,4μm，说明与季节变化密切相关。     

Effect of catalyzed diesel particulate filter and its catalyst loading on emission characteristics of a non-road diesel engine

In this study, the effects of a diesel oxidation catalyst (DOC) coupled with a catalyzed diesel particulate filter (CDPF) with different catalyst loadings on the power, fuel consumption, gaseous and particulate emissions from a non-road diesel engine were investigated. Results showed that the after-treatment had a negligible effect on the power and fuel consumption. The reduction effect of the DOC on the CO and hydrocarbon (HC) increased with the engine load. Further reductions occurred coupling with the CDPF. Increasing the catalyst loading resulted in a more significant reduction in the HC emissions than CO emissions. The DOC could increase the NO₂ proportion to 37.9%, and more NO₂ was produced when coupled with the CDPF below 250°C; above 250°C, more NO₂ was consumed. The after-treatment could reduce more than 99% of the particle number (PN) and 98% of the particle mass (PM). Further reductions in the PN and PM occurred with a higher CDPF catalyst loading. The DOC had a better reduction effect on the nucleation particles than the accumulation ones, but the trend reversed with the CDPF. The DOC shifted the particle size distribution (PSD) to larger particles with an accumulation particle proportion increasing from 13% to 20%, and the geometric mean diameter (GMD) increased from 18.2 to 26.0 nm. The trend reversed with the CDPF and the accumulation particle proportion declined to less than 10%. A lower catalyst loading on the CDPF led to a higher proportion of nucleation particles and a smaller GMD.     

高耸建筑物定向爆破中切口长度安全范围的研究

爆破拆除高耸筒体结构时 ,爆破切口长度的合理选取是爆破成功的重要因素。目前的实践经验 ,爆破切口长度取为切口处筒体圆周长的 6 0 %～ 6 6 % (即 3/ 5～ 2 / 3) ,按此取值范围进行施工 ,爆破效果的好坏并存 ,事故仍有发生 ,这说明此取值范围偏大。借助有限元软件ANSYS ,通过数值计算 ,可获得起爆瞬间 ,在结构自重作用下引起的爆破切口支撑部的应力与应变状态 ,因而 ,可分析出爆破切口长度较安全的取值范围。对比实际拆除爆破的效果 ,爆破切口长度取切口处筒体圆周长的 6 2 %～ 6 4 %是比较安全适宜的。数值分析所得出的结论 ,对爆破设计施工有一定的借鉴意义     

水泥土搅拌桩的桩径分析

针对搅拌桩施工会引起周围土体的位移及产生很高的超静孔隙水压力的工程现象,首先分析了搅拌桩施工中固化剂的注入体积与膨胀压力、成桩直径的关系。结果表明,5%~10%的注入浆液的体积可以对周围土体产生1.8~3.0倍不排水抗剪强度的膨胀压力,成桩直径比搅拌叶片的名义直径大5%~10%。然后量测室内模型桩、现场搅拌桩的成桩直径,分析了注入浆液的体积与成桩直径的关系。结果表明,对于深度不太大的水泥土搅拌桩,有约45%的注入体积会通过上浮隆起的土体损失掉;大约5%的注入体积通过劈裂裂缝渗入到周围土体中;大约50%的注入体积会转化为成桩直径,使桩体膨胀5%~10%,即实测桩径比搅拌叶片的名义直径大5%~10%。     

Adsorption of lead on multi-walled carbon nanotubes with different outer diameters and oxygen contents: Kinetics, isotherms and thermodynamics

The effects of different outer diameters and surface oxygen contents on the adsorption of heavy metals onto six types of multi-walled carbon nanotubes (MWCNTs) were investigated in an aqueous solution and lead was chosen as a model metal ion. The results indicated that the percentage removal and adsorption capacity of lead remarkably increased with decreasing outer diameter due to larger specific surface area (SSA). The SSA-normalized maximum adsorption capacity (qm /SSA) and SSA-normalized adsorption coefficient (Kd /SSA) were strongly positively correlated with surface oxygen content, implying that lead adsorption onto MWCNTs significantly increases with the rise of oxygen content and decreases with decreasing SSA. The calculated thermodynamic parameters indicated that adsorption of lead on MWCNTs was endothermic and spontaneous. When the oxygen content of MWCNTs increased from 2.0% to 5.9%, the standard free energy (△ G0 ) became more negative, which implied that the oxygenated functional groups increased the adsorption affinity of MWCNTs for lead. Through calculation of enthalpy (△ H0 ), G0 and free energy of adsorption (Ea ), lead adsorption onto MWCNTs was recognized as a chemisorption process. The chemical interaction between lead and the phenolic groups of MWCNTs could be one of the main adsorption mechanisms due to highly positive correlations between the phenolic groups and K d /SSA or q m /SSA.     

高径比对猪场废水脱氮与沼气脱硫耦联反应器的影响

采用填料鼓泡塔反应器研究其高径比对猪场废水脱氮与沼气脱硫耦联过程的影响,比较了3种不同高径比(8∶1、3∶1、2∶1)反应器的废水脱氮与沼气脱硫效能.在温度30～32℃、空塔停留时间6.70 min、水力停留时间3.35 d、沼气中H2 S浓度1 414～1 838 mg.m-3、进水NO x--N浓度114～243 mg.L-1的条件下,高径比2∶1反应器的运行较稳定,且处理效果较好,硫化氢去除率平均值为96.7%,NO x--N去除率平均值达到88.7%;而高径比8∶1和3∶1反应器的运行不太稳定,硫化氢去除率的平均值分别为68.0%、80.4%,NO x--N的去除率平均值分别为89.7%、90.2%.主要是因为高径比2∶1反应器的实际气速(3.12×10-2 m.s-1)比高径比3∶1、8∶1反应器的实际气速(分别为3.62×10-2 m.s-1和6.64×10-2 m.s-1)更慢,其气液传质系数(1.79×10-5 s-1)比高径比3∶1、8∶1反应器的气液传质系数(分别为1.64×10-5 s-1和1.55×10-5 s-1)更大,传质效果更好.处理效能试验结果以及反应器流体力学特征参数均表明,高径比2∶1反应器为最适合的反应器.