利用印染厂碱减量废水脱硫试验及其应用研究

介绍了化纤印染厂坯布前处理工序产生的碱减量废水作锅炉烟气SO2脱硫剂的试验研究结果，分析了碱减量废水脱硫反应过程及其机理，同时设计了一套经济适用的新型的文丘里旋流湿式脱硫除尘器。工业性试验运行结果表明，利用碱减量废水脱硫以废治废，经济效益和环境效益显著。     

高效菌活性污泥法处理分散染料废水实验研究

针对复合微生物的筛选和分离进行了研究 ,分离出处理分散染料废水起高效降解作用的 2株菌种。结果表明 ,2株高效菌对分散染料废水降解能力很强 ,与普通菌结果对比CODCr去除率提高 17% ,并且高效菌对废水浓度的耐受性也明显提高     

低床层烟炱吸附法脱硫试验及机理探讨

研究了以锅炉烟气沉降物为吸附剂的烟炱吸附法脱除SO2的工艺条件，结果表明该法较适宜的工艺条件为SO2浓度小于2400mg/L,烟气流速小于36m/h，烟气温度低于100℃，此时脱硫效率可达30％以上。初步探讨了烟炱吸附法脱硫的作用机理。     

絮凝法分离谷氨酸菌体的研究

采用絮凝法对味精发酵生产过程中发酵液中的菌体进行研究，得到无机凝聚剂与高分子絮凝剂复合配比使用是发酵液去除菌体的有效办法。对复合用药除菌后的谷氨酸发酵液和原谷氨酸发酵液进行谷氨酸回收的比较，谷氨酸的回收率提高了8．8％。     

黄磷尾气现场脱硫试验

黄磷尾气的主要成分是CO，其中含硫杂质主要以硫化氢的形式存在。测定了黄磷尾气中硫化氢、氧气的含量，分别采用吸收、吸附工艺及其组合工艺对黄磷尾气进行了现场脱硫试验，得出了最佳的黄磷尾气净化脱硫工艺，即吸收、活性炭变温吸附。出口气中H2s的质量浓度为1—5mg/m^3，净化效率达到99．7％。     

国内采油废水处理现状

从水污染的定义出发，依次介绍了采油废水的组成及特点、处理采油废水的难点及传统物化方法和生物法处理采油废水的现状。     

细菌B1胞外活性物质对球形棕囊藻的溶藻机制初探

为探讨溶藻细菌B1对球形棕囊藻的溶藻作用机理及起作用的胞外活性物质的类别,研究了从珠海香洲码头赤潮海水中分离获得的溶藻细菌BI的无菌滤液对球形棕囊藻生长过程中的叶绿素a含量、丙二醛含量(MDA)、超氧化物歧化酶(SOD)和过氧化氢酶(CAT)活性的影响,并对溶藻细菌B1分泌的胞外活性物质进行了初步分析.当100 mL藻液中加入1 mL的无菌滤液,除藻率达到了83％.B1无菌滤液使藻中丙二醛的含量显著上升,48 h达到最大值153％,球形棕囊藻的SOD、CAT活性在处理开始后保持下降趋势,分别在96 h、48 h达到最低值27％、33％.研究表明B1无菌滤液(不大于1 mL)对棕囊藻的溶藻效果与加入的量成正比,且主要通过降低机体中保护酶的活性和加剧膜脂质过氧化的程度等来抑制球形棕囊藻的生长;细菌B1分泌的胞外活性物质中可能含有芳香醛类且包括载有磷基团的有机物,但不含蛋白质.     

2株降解菲的植物内生细菌筛选及其降解特性

为了获得具有菲降解特性的植物内生细菌,通过选择性富集培养,本研究从多环芳烃污染区植物体内分离得到2株能够降解液体培养基中高浓度菲(200 mg·L-1)的植物内生细菌(菌株P1和P3).经形态观察、生理生化特征鉴定和16S rDNA序列同源性分析,分别将菌株P1和P3鉴定为寡养单胞菌属(Stenotrophomonas sp.)和假单胞菌属(Pseudomonas sp.)的细菌.菌株P1和P3均为好氧生长,28℃、150 r·min-1摇床培养7 d,2株菌对无机盐培养基中菲(100 mg·L-1)的降解率均高于90%.条件实验表明,温度20～30℃,pH 6.0～8.0,盐含量0%～4%,装液量10～30 mL(100 mL三角瓶)2菌株生长良好且对菲降解率高于70%.其最适生长和降解温度为30℃,pH为7.0,盐含量≤4%,装液量≤30 mL.综合比较2株菌对菲的降解特性,P1菌株高温耐受性稍强,而P3菌株对环境pH改变和缺氧的耐受性稍强.     

Interface-mediated synthesis of monodisperse ZnS nanoparticles with sulfate-reducing bacterium culture

We have created a new method of ZnS nanospheres synthesis. By interface-mediated precipitation method (IMPM), monodisperse ZnS nanoparticles was synthesized on the particle surface of sulfate-reducing bacterium nutritious agar culture. Sulfate-reducing bacterium (SRB) was used as a sulfide producer because of its dissimilatory sulfate reduction capability, meanwhile produced a variety of amino acids acting as templates for nanomaterials synthesis. Then zinc acetate was dispersed into nutritious agar plate. Subsequently agar plate was broken into particles bearing much external surface, which successfully mediated the synthesis of monodisperse ZnS nanoparticles. The morphology of monodisperse ZnS nanospheres and SRB were examined by scanning electron microscopy (SEM), and the microstructure was investigated by X-ray diffraction (XRD). The thermostability of ZnS nanoparticles was determined by thermo gravimetric-differential thermo gravimetric (TG-DTG). The maximum absorption wavelengh was analysed with an ultraviolet-visible spectrophotometer within a range of 199–700 nm. As a result, monodisperse ZnS nanoparticles were successfully synthesized, with an average diameter of 80 nm. Maximum absorption wavelengh was 228 nm, and heat decomposed temperature of monodisperse ZnS nanoparticles was 596°C.     

Interface-mediated synthesis of monodisperse ZnS nanoparticles with sulfate-reducing bacterium culture

We have created a new method of ZnS nanospheres synthesis. By interface-mediated precipitation method (IMPM), monodisperse ZnS nanoparticles was synthesized on the particle surface of sulfate-reducing bacterium nutritious agar culture. Sulfate-reducing bacterium (SRB) was used as a sulfide producer because of its dissimilatory sulfate reduction capability, meanwhile produced a variety of amino acids acting as templates for nanomaterials synthesis. Then zinc acetate was dispersed into nutritious agar plate. Subsequently agar plate was broken into particles bearing much external surface, which successfully mediated the synthesis of monodisperse ZnS nanoparticles. The morphology of monodisperse ZnS nanospheres and SRB were examined by scanning electron microscopy (SEM), and the microstructure was investigated by X-ray diffraction (XRD). The thermostability of ZnS nanoparticles was determined by thermo gravimetric-differential thermo gravimetric (TG-DTG). The maximum absorption wavelengh was analysed with an ultravioletvisible spectrophotometer within a range of 199-700 nm. As a result, monodisperse ZnS nanoparticles were successfully synthesized, with an average diameter of 80 nm. Maximum absorption wavelengh was 228 nm, and heat decomposed temperature of monodisperse ZnS nanoparticles was 596℃.