SiO_2-TiO_2纳米管的制备及其光催化性能的研究

文章采用水热法制备SiO2-TiO2纳米管,通过扫描电镜(SEM)和透射电镜(TEM)考察了该纳米管的结构形态,并用X-射线衍射考察其晶体结构。实验结果表明所制得的纳米管是锐钛晶型,其两端开口,具有多层管壁;管径为8nm左右,管壁厚1～2nm。光催化降解酸性橙Ⅱ实验表明:SiO2-TiO2纳米管光催化速率比TiO2纳米管高出10%。这可能是因为Si元素的存在增大了钛纳米管的比表面积,同时SiO2的存在能降低光生电子和空穴的复合率。     

Achondrogenesis type 2 diagnosed by transvaginal ultrasound at 12 weeks' gestation

Ultrasound examination at 12 weeks' gestation revealed severe generalised subcutaneous oedema in a pregnancy at risk for achondrogenesis type II. Transvaginal scanning confirmed the oedema and suggested abnormal limb development. The prenatal diagnosis was confirmed by X-ray examination after transvaginal termination.     

化学发光流动注射法测定雨水中过氧化氢

用化学发光流动注射分析装置,将16孔阀连接成异步双流路,以过氧化氢-鲁米诺-钴(Ⅱ)为化学发光体系,建立了快速测定雨水中过氧化氢的方法,最低检测限为0.1ng/ml,在0.1—400ppb范围内有良好的线性关系,相对标准差为0.78—3.03％,每小时可分析480个以上的样品.     

磁性PEI功能化秸秆的制备及对Pb (Ⅱ)的吸附

为获得同时具有优良的吸附性能和磁分离特性的生物吸附材料,以汽爆秸秆为基质,采用戊二醛交联剂法制备了磁性聚乙烯亚胺功能化秸秆吸附剂（Fe₃O₄-PEI-RS）,通过SEM、XRD、FTIR、XPS和VSM等手段表征了材料的结构和性质,测定了Pb（Ⅱ）在Fe₃O₄-PEI-RS上的吸附性能,考察了pH、吸附时间、吸附剂投加量、Pb（Ⅱ）初始浓度、温度等因素对吸附的影响.结果表明,Fe₃O₄-PEI-RS对Pb（Ⅱ）的吸附具有强烈的pH依赖性;吸附时间对Pb（Ⅱ）的吸附效率有明显的影响,在180 min时吸附达到平衡,吸附过程符合准二级动力学模型;Langmuir和Freundlich模型都能很好地描述Pb（Ⅱ）在Fe₃O₄-PEI-RS上的吸附行为,20、30和40℃时最大吸附量分别为192.31、200.00和212.77 mg/g;热力学参数△G < 0,而焓变△H>0、△S>0,说明该吸附属于熵增加的自发吸热反应过程,升温有利于吸附.重复试验表明,EDTA作解吸剂,经5次吸附/解吸附循环后吸附剂仍能保持较高的吸附容量.研究显示,所制Fe₃O₄-PEI-RS对Pb（Ⅱ）具有较高的吸附容量,稳定性好、可循环利用,能在磁场下实现快速分离.      

某城市污水处理厂二期污水处理工程设计研究

详细介绍了某城市第一污水处理厂在现有工程的基础上二期工程的工艺设计以及构筑物、设备参数;二期工程充分利用原有工程场地,本着现有、新建运行管理便捷统一原则,采用改良型A/A/O生化池作为二级处理主体工艺;二期工程投入运营后,某城市污水处理厂达到20×104 m3/d的污水设计规模.最终污水厂出水水质达到了《城镇污水处理厂污染物排放标准》(GB 18918-2002)一级 A排放标准.污水处理厂运营后,经济效益显著,可保本经营,并具有企业自我发展的能力.     

Effects of Cu（Ⅱ） and humic acid on atrazine photodegradation

This work was designed to explore the characteristics of photodegradation of herbicides in the copper-polluted water body. The results showed that Cu(II) alone could induce a photo Fenton-like reaction to enhance the degradation of atrazine, in which hydroxyl radical ( OH) was a main active species. Humic acids restrained atrazine degradation, nevertheless, when introducing Cu(II), the photodegradation was accelerated, in which singlet oxygen (1O2) replaced OH acting as the prevailing species. A feasible mechanism for the photochemical process was also proposed, which is helpful for better understanding the environmental photochemistry of atrazine in the copper-polluted water.     

Efficacy of natural biocide on control of microbial induced corrosion in oil pipelines mediated by Desulfovibrio vulgaris and Desulfovibrio gigas

We compared the efficacy of a natural biocide with four chemical tetrakishydroxymethyl phosphonium sulfonate, benzyl trimethyl ammonium chloride, and formaldehyde, glutaraldehyde, to control microbial induced corrosion in oil pipelines. The efficacy of biocides were monitored against Desulfovibrio vulgaris and Desulfovibrio gigas in experimental pipes by measuring cell counts, H2S production, Fe(II) production, production of extracellular polymeric substances and structure of biofilm. The treatment with cow urine had minimum planktonic cell counts of 3 102 CFU/mL as well as biofilm cell counts of 9 101 CFU/mL as compared with tetrakishydroxyl methyl phosphonium sulfonate, benzyl trimethyl ammonium chloride, formaldehyde and glutaraldehyde. Sulfide production was the lowest with cow urine (0.08 mmol/L), followed by tetrakishydroxymethyl phosphonium sulfonate 0.72 mmol/L. On day 90 of treatment, Fe(II) production was also found to be the lowest with cow urine. The scanning electron microscopic studies indicated that the biofilm bacteria were killed by cow urine. These results demonstrate the cow urine mediated control of microbially induced corrosion, and this is indicative of its potential as a viable substitute of toxic biocides. To the best of our knowledge, this seems to be the first report which screens possible biocidal activity by cow urine as compared to the most common biocides which oil industry is currently using.     

Temperature Effect on Migration of Zn and Cd Through Natural Clay

To investigate the effect of temperature on effective diffusion coefficients and retardation factors for Zn and Cd, combined diffusion and sequential extraction analyses were conducted at 15 ^˚C and 55 ^˚C. The effective diffusion coefficients of the metals increased up to ten times according to the increased temperature. On the other hand, the effect of temperature on the retardation factor depended on the retention mechanisms of the metals. The distribution coefficient for Zn, which was mainly partitioned in the carbonate phase, increased up to two times with the increase in temperature. On the other hand, the distribution coefficient for Cd, which was mainly partitioned in the exchangeable phase, was hardly affected by the temperature change. Results of combined diffusion and sequential extraction analysis showed that the effect of temperature on the heavy metals’ (Zn and Cd) migration through the compacted natural clay was influenced by the combined effects of the diffusion coefficient and the retardation factor. Additionally, we could also observe the change in retention mechanism for the metals with the change in pore water concentration.     

The potential of cost-effective coconut husk for the removal of toxic metal ions for environmental protection

Coconut (Cocos nucifera) husk, an agricultural waste, has been thoroughly investigated for the removal of toxic Cd(II), Cr(III) and Hg(II) ions from aqueous media. The parameters like nature and composition of electrolyte, concentration of toxic ions, dosage of coconut husk, and equilibration time between the two phases were optimized for their maximum accumulation onto the solid surface. The effect of common ions on the uptake of metal ions has been monitored under optimal conditions. The variation of retention of each metal ion with temperature was used to compute the thermodynamic quantities DeltaH, DeltaS and DeltaG. The values 18.1+/-0.6 kJmol(-1), 74+/-2 Jmol(-1)K(-1), and -3.8+/-0.04 kJmol(-1) at 298 K; 10.8+/-0.8 kJmol(-1), 48.8+/-2.7 Jmol(-1)K(-1), and -4.6+/-0.3 kJmol(-1) at 298 K; and -37.4+/-2k Jmol(-1), 105+/-7 Jmol(-1)K(-1) and -2.58+/-0.5 kJmol(-1) at 298 K were obtained for Cd(II), Cr(III) and Hg(II) ions, respectively. The sorption data were analysed by applying different sorption isotherms. The sorption capacity and energy were evaluated for each metal ion. The values of the Freundlich constants 1/n and C(m) were 0.92+/-0.04 and 52.6+/-22.2 mmolg(-1); 0.85+/-0.05 and 56.0+/-0.03 mmolg(-1); and 0.88+/-0.03 and 6.84+/-0.45 mmolg(-1) for Cd(II) Cr(III) and Hg(II) ions, respectively. Similarly, the Dubinin-Radushkevich (D-R) constants beta, X(m,) and E were evaluated for the three metal ions. To check the selectivity of the sorbent, sorption of a number of elements was measured under similar conditions. Separation of Zn(II) from Cd(II); Cr(III) from I(I), Zr(IV), Se(IV), and Hg(II) from Se(IV) and Zn(II) can be achieved using this sorbent. This cheap material has potential applications in analytical chemistry, water decontamination, industrial effluent treatment and in pollution abatement.     

Biosorption of nickel(II) from aqueous solution by Aspergillus niger: Response surface methodology and isotherm study

In the present study, the effects of biosorbent Aspergillus niger dosage, initial solution pH and initial Ni(II) concentration on the uptake of Ni(II) by NaOH pretreated biomass of A. niger from aqueous solution were investigated. Batch experiments were carried out in order to model and optimize the biosorption process. The influence of three parameters on the uptake of Ni(II) was described using a response surface methodology (RSM) as well as Langmuir and Freundlich isotherm models. Optimum Ni(II) uptake of 4.82 mg Ni(II) g⁻¹ biomass (70.30%) was achieved at pH 6.25, biomass dosage of 2.98 g L⁻¹ and initial Ni(II) concentration of 30.00 mg L⁻¹ Ni(II). Langmuir and Freundlich were able to describe the biosorption isotherm fairly well. However, prediction of Ni(II) biosorption using Langmuir and Freundlich isotherms was relatively poor in comparison with RSM approaches. The biosorption mechanism was also investigated by using Fourier transfer infrared (FT-IR) analysis of untreated, NaOH pretreated, and Ni(II) loaded A. niger biomass.