温度对生物强化除磷工艺反硝化除磷效果的影响

以处理城市污水的中试规模生物强化除磷A2/O活性污泥工艺系统为研究对象,考察了温度对系统COD去除和脱氮除磷效果的影响,特别是温度对活性污泥反硝化除磷性能的影响.结果表明,当温度从(30.9±0.8)℃降低到(9.1±0.6)℃时,A2/O系统的脱氮除磷效果显著下降,系统对TN和TP的污泥去除负荷明显下降.通过污泥反硝化除磷活性实验发现,随着温度的降低,系统中活性污泥的最大厌氧释磷速率、最大好氧吸磷速率和最大缺氧吸磷速率都降低.活性污泥中反硝化除磷菌(DPB)占聚磷菌(PAOs)总量的比例随温度降低稍有下降,但平均值仍维持在47.5％左右.用阿伦尼乌斯公式对实验结果进行拟合,得到系统中活性污泥聚磷菌厌氧释磷反应活化能Ea1为148.0 kJ· mol-1,聚磷菌好氧吸磷反应活化能Ea2为228.8 kJ·mol-1,发生在缺氧条件下反硝化除磷菌的吸磷反应活化能Ea3为315.8 kJ·mol-1.对不同温度下污泥絮体粒径分析结果表明,随温度降低,粒径分布更加集中,系统中活性污泥絮体颗粒平均粒径减小,不利于污泥絮体内部反硝化除磷缺氧微环境的形成.     

污水的微生物除磷技术的研究

污水中含磷物质主要来源于人类活动的排泄物及废弃物、工业合成洗涤剂等。本文分析了应用微生物除磷的环境影响因子,并对这一技术在我国的应用前景做出展望。     

两级SBR工艺去除磷、氮及有机物效能分析

以模拟生活污水为处理对象,在常温条件下,采用对比试验与机制分析方法,研究了两级SBR工艺分级除磷、去除有机物及脱氮的特性,分析了工艺的效能优势.结果表明,通过控制泥龄(除磷级5~7 d,脱氮级约50 d),可以将异养的PAOs与硝化菌分别控制在2个反应器中优势生长,在出水水质更优的情况下,系统的处理效率可比单级SBR提高1倍以上;两级SBR系统可以有效地缓解有机负荷对硝化过程的冲击影响,在进水COD浓度较高的情况下,能够保持其脱氮级(SBS2)具有稳定的硝化速率,且系统的最终出水可以容易并稳定地达到TP≤0.5 mg.L-1的国家标准;另外,两级SBR的脱氮级(SBS2)除具有优势的硝化菌种外,还能培养出适合降解难降解有机物的异养菌,使其好氧硝化结束时COD浓度较单级SBR系统更低.     

聚磷菌在不同碳源下的反硝化研究

利用SBR系统对聚磷菌进行了培养,并通过荧光原位杂交手段检测了系统中聚磷菌Candidatus Accumulibacter phosphatis的富集程度.聚磷菌也是一种普通异养菌,为了研究它的反硝化能力,排除了聚磷菌的正常释磷和吸磷过程,仅考察在不同碳源下反硝化性能.结果表明,乙酸和PHB都能成为聚磷菌反硝化的电子供体.当以乙酸为外在单一碳源时,其反硝化速率和PHB生成速率与起始硝酸盐浓度无关,但是当起始状态硝酸盐浓度越高时,消耗单位乙酸生成的PHB和硝酸盐还原量越小.以PHB为内在碳源和能源时,聚磷菌的反硝化速率呈现对于基质(硝酸盐)的零级动力学反应,比反硝化速率为0.973 3mg/(g.h),此外PHB平均比消耗速率为(以PHB计)2.462 6 mg/(g.h).     

Preparation and performance of novel APP/NaY–Fe suppressant for coal dust explosion

Coal dust explosion occurs easily in the coal chemical industry. To ensure safety in industrial production, NaY zeolite was used as carrier modified with Fe ions and combined with ammonium polyphosphate (APP) to prepare a novel composite suppressant for coal dust explosion. The explosion suppression performance of novel APP/NaY–Fe suppressant was investigated by flame propagation inhibition experiments. The results show that Fe ion modification can effectively improve the explosion suppression performance. By increasing content, the explosion suppression performance of the explosion suppressant increases. The maximum explosion pressure P_max of coal dust drops to 0.13 MPa when 50 wt% explosion suppressants were added, and the coal dust explosion cannot continue to expand. Complete suppression of explosion could be achieved by adding 66 wt% explosion suppressants. Combined with XRD, SEM and TG results, the explosion suppression mechanism was proposed. The novel explosion suppressant has high thermal stability, good dispersity and its explosion suppression components distribute uniformly. It shows good explosion suppression performance by the synergistic effect among explosion-suppression components.     

Simulation of long-term nutrient removal in a full-scale closed-loop bioreactor for sewage treatment: an example of Bayesian inference

In this study, the performance of nitrogen and phosphorus removal in a full-scale closed-loop bioreactor (oxidation ditch) system was simulated using the ASM2d model. Routine data describing the process for two years were compiled for calibration and validation. To overcome the identifiability problem, the classic Bayesian inference approach was utilized for parameter estimation. The calibrated model could describe the long-term trend of nutrient removal and short-term variations of the process performance, showing that the Bayesian method was a reliable and useful tool for the parameter estimation of the activated sludge models. The anoxic phosphate uptake by polyphosphate accumulating organisms (PAO) contributed 71.2% of the total Poly-P storage, which reveals the dominance of denitrifying phosphorus removal process under the oxygen limiting conditions. It was found that 58.7% of the anoxic Poly-P storage and denitrification by PAO in the reactor was achieved in the aerated compartment, implying that the PAO’s anoxic activity was significantly stimulated by the low dissolved oxygen (DO) level in this compartment due to the oxygen gradient caused by brush aerator.     

固定化反硝化聚磷菌同步除磷脱氮实验研究

实验采用海藻酸钠和PVA添加膨润土包埋固定经富集驯化的以反硝化聚磷菌(DNPAOs)为主的活性污泥,利用体视显微镜和扫描电子显微镜考察了固定化小球的形态和表面结构,并对厌氧/好氧条件下,包埋小球除磷脱氮性能进行探讨,结果表明:固定化小球具有良好的强化生物除磷和较好的反硝化脱氮性能,体系的COD去除率平均达74.9%,平均除磷效率为95.3%,氨氮平均去除率达到95.2%左右。小球若长时间缺氧,在其内部会出现厌氧区,并产生厌氧放磷现象。     

聚磷菌厌氧时吸收乙酸和丙酸的代谢模型

水体中存在过多的磷是造成水体富营养化的重要原因之一,聚磷菌（polyphosphate accumulating organisms）因为能过量吸收磷而倍受关注。厌氧时,聚磷菌能大量吸收污水中的挥发性脂肪酸,经过一系列的生化反应,为好氧吸磷做准备。经过总结在厌氧条件下,聚磷菌Accumulibacter吸收乙酸和丙酸代谢转化的化学计量方程,并对模型中系数、还原力的产生、糖原降解途径以及厌氧条件下最终产物PHA的组成进行了讨论,得出挥发酸是通过主动运输进入细胞,且糖原经过ED途径提供还原力,多聚磷酸盐水解提供ATP和释放磷酸盐于体外,最终产生PHA的假设过程。但是,经过众多模型试验,一些假设仍没有得到最后的结论,所以应该进一步用富集程度较高的污泥进行精确研究。本文最终希望利用聚磷菌的代谢模型在工程运用中发挥最大效用。     

不同聚合度的聚磷酸铵灭火性能研究*

为考察聚磷酸铵（APP）干粉灭火剂的聚合度对其灭火性能的影响,选用3种不同聚合度的APP,结合其晶体结构、粒度分布及热性能测试,并通过粉体杯式燃烧器进行小尺寸灭火实验,对比3种样品的灭火性能及灭火机理,研究聚合度与其灭火性能的关系。热性能测试结果显示,聚合度的升高会导致APP的热稳定性下降,随着聚合度从80升至1 500,其初始分解温度从326.11 ℃降低至321.54 ℃,失重率从75.21%增加至79.66%。实验结果表明:随着APP聚合度的增加,火焰降温速率升高,最小灭火浓度（MEC）降低,灭火性能增强,当聚合度为1 500时,MEC为118.143 g/m3。聚合度的升高有助于APP在进入火场后更早、更充分地与火焰发生反应,从而使灭火性能得到提升。     

Bioabsorbable Soy Protein Plastic Composites: Effect of Polyphosphate Fillers on Biodegradability

The use of biodegradable polymers made from renewable agricultural products such as soy protein isolate has been limited by the tendency of these materials to absorb moisture. A straightforward approach for controlling the inherent water absorbency of the biodegradable polymers involves blending special bioabsorbable polyphosphate fillers, biodegradable soy protein isolate, plasticizer, and adhesion promoter in a high-shear mixer followed by compression molding. The procedure yields a relatively water-resistant, biodegradable soy protein polymer composite, as previously reported. The aim of the present study is to determine the biodegradability of the new polyphosphate filler/soy protein plastic composites by monitoring the carbon dioxide released over a period of 120 days. The results suggest that the composites biodegrade satisfactorily, with the fillers having no significant effect on the depolymerization and mineralization of the soy protein plastic, processes that would otherwise result in nonbiodegradable composites. Further, the results indicate that the biodegradation and useful service life of these biocomposites may be controlled by changing the filler concentration, making the biocomposites useful in applications in which the control of water resistance and biodegradation is critical.