催化剂Ru/ZrO2-CeO2催化湿式氧化苯酚

催化剂Ru/ZrO₂-CeO₂催化湿式氧化苯酚的过程表明,Ru/ZrO₂-CeO₂可以显著提高COD和苯酚去除效果,当反应温度为170℃,压力为3 MPa,反应120 min后,COD和苯酚的去除率分别达到了99％和100％.试验还考察了不同反应条件对苯酚溶液COD去除的影响,并获得了最优的反应条件：温度为170℃,压力为3 MPa,催化剂的投加量为5　g/Ｌ,搅拌速度为500 r/min.通过对中间产物的分析,本研究提出了催化湿式氧化苯酚的简单路径图,认为苯酚首先被氧化成小分子有机酸,接着小分子有机酸被氧化成二氧化碳和水.前一个过程是快速反应,后一个过程中的乙酸氧化是慢速过程,需要在高温下才能完成.乙酸的氧化主要是自由基攻击α碳上的C—H键,先生成甲酸,并最终生成二氧化碳和水.     

铁氧化物改性黏土对Cr(Ⅵ)的吸附性能研究

利用铁氧化物对黏土进行了包覆改性,采用静态吸附法对该改性黏土吸附Cr(Ⅵ)的特性进行了研究,并考虑了反应时间、pH、浓度、温度对吸附的影响。实验结果表明,整个吸附过程基本在3h内完成;改性黏土对Cr(Ⅵ)的吸附量随溶液初始pH的增大而明显减小;随着溶液初始浓度和温度的增大而增大。同时,在初始pH为3.0的条件下,研究了改性黏土吸附Cr(Ⅵ)的动力学和热力学特性,结果表明,改性黏土对Cr(Ⅵ)吸附能较好地符合准二级动力学方程和Langmuir等温式。由Langmuir等温式得出,在293K、初始pH为3.0条件下的单层饱和吸附量为12.91 mg•g-1。确定了改性黏土吸附Cr(Ⅵ)的热力学参数,表明该吸附过程是一个吸热的自发过程。与原土的对比实验表明,改性黏土对Cr(Ⅵ)的吸附能力大大增强。     

基于CFD的内构件强化内循环流化床流场结构分析

针对流化床内部流体结构的复杂性和缺乏有效放大设计理论的问题,以漏斗型导流内构件强化的内循环流化床的气液运动为研究对象,利用欧拉-欧拉双流体模型构建了能描述其复杂流动的CFD数学模型,通过宏观流场、气含率分布、液体速度分布解析内构件对气液混合传质的作用原理.数值模拟结果表明:双流体模型能较好地揭示流化床内气液流场结构,流...     

微电解-生化法处理大蒜废水工程实例

针对大蒜废水特点,采用了铁屑微电解-UASB-接触氧化工艺进行处理.运行结果表明:在设计进水水质、水量范围内,COD、BOD5、氨氮和ss去除率分别为98%、99%、70%和98%,出水各项指标均达到GB 8978--1996<污水综合排放标准>中的一级排放标准,系统运行费用为1.19元/m3.     

己内酰胺生产废水的铁碳微电解深度处理与机理研究

采用铁碳微电解方法对己内酰胺生产废水进行深度处理,探讨了pH值、停留时间、铁碳质量比对处理效果的影响。在pH为4、停留时间为120 min、铁碳质量比为4的最佳处理条件下,COD去除率可达57.8%,色度去除率可达68.4%。微电解对己内酰胺废水的作用主要通过铁的絮凝作用,处理过程中的酸性条件、微电解的氧化还原和电场作用,从而提高其去除效率。     

Preparation and coagulation efficiency of polyaluminium ferric silicate chloride composite coagulant from wastewater of high-purity graphite production

The aim of the present work was to produce a polyaluminium ferric silicate chloride (PAFSiC) coagulant from acidic and alkaline wastewater of purifying graphite by roasting, and subsequently to evaluate coagulation efficiency of the reagent by treating surface water from the Yellow River as well as municipal wastewater in comparison with the conventional coagulant polyaluminium chloride (PAC). The PAFSiC coagulant was prepared by co-polymerization. The effects of (Al+Fe)/Si molar ratio, OH/(Al+Fe) molar ratio (i.e., value), coagulant dosage and pH value of test suspension on the coagulation behavior of FAFSiC and the stability of the PAFSiC were also examined. Results showed that PAFSiC performed more efficiently than PAC in removing turbidity, chemical oxygen demand (COD), and total phosphate (TP). The PAFSiC with a value of 2.0 and (Al+Fe)/Si ratio of 5 (PAFSiC 2.0/5) showed excellent coagulation effect for both turbidity and COD, while PAFSiC 1.0/5 was the best for TP. The optimum coagulation pH range of PAFSiC 2.0/5 was 5.0–9.0, slightly wider than that of PAC (6.0–8.0). The process can be easily incorporated into high-purity graphite production plants, thereby reducing wastewater pollution and producing a valuable coagulant.     

Evaluation of adsorption capacities of humic acids extracted from Algerian soil on polyaniline for application to remove pollutants such as Cd(Ⅱ), Zn(Ⅱ) and Ni(Ⅱ) and characterization with cavity microelectrode

The adsorption capacities of new humic acids isolated from Yakouren forest (YHA) and Sahara (Tamenrasset: THA) soils (Algeria) and commercial humic acid (PFHA) on polyaniline emeraldine base (PEB) were studied at pH 6.6. Also the adsorption of heavy metals such as Cd2+, Zn2+ and Ni2+ on humic acid-polyaniline systems (HA-PEB) was investigated at the same conditions. HA-PEB compounds were characterized by scanning electron microscopy (SEM), infrared spectrometry and cavity microelectrode. In addition, batch adsorption and cavity microelectrode were used in the adsorption study of Cd2+, Zn2+ and Ni2+ on HA-PEB. To develop biocaptors of polluting metals using a cavity microelectrode modified by HA-PEB systems, the adsorption kinetic and adsorption capacity were investigated. The SEM analysis showed that the presence of humic acid affected the PEB surface and caused the formation of a granular morphology. The maximum adsorption capacities (qmax) of PFHA, THA and YHA determined by adsorption isotherms were 91.31, 132.1 and 151.0 mg/g, respectively. Batch adsorption results showed that qmax of Cd2+, Zn2+ and Ni2+ on HA-PEB followed the order: THA-PEB > YHA-PEB > PFHA-PEB. The voltammograms obtained with HA-PEB modified cavity microelectrode showed the appearance of new redox couples reflecting the adsorption of HA on PEB. Metal-humic acid-polyaniline voltammograms were characterized by appearance of oxidation-reduction couples or reduction wave corresponding to metal. Finally, the result may be exploited to develop a biocaptor based on the cavity microelectrode amended by THA-PEB and YHA-PEB.     

低温等离子体-催化协同降解挥发性有机废气

低温等离子体-催化协同技术适合于各类挥发性有机物的治理,特别是大气量低浓度的有机废气的处理.高效催化剂的加入可 以显著提高等离子体反应中有机废气的降解效率,减少有害副产物的生成以及提高反应器的能量利用率.从反应器、催化剂以及背景气体等方面探讨了该技术实现产业化需要解决的问题,结合低温等离子体与催化剂的相互作用、等离子体...     

La-Co-Fe-Cu/HZSM-5在尾气碳颗粒燃烧中的催化性能

采用柠檬酸络合低温浸渍法制备分子筛负载钙钛矿型复合氧化物催化剂。采用XRD、SEM和H2-TPR等手段对催化剂性能进行表征,并在微型固定床反应器中对催化剂进行活性评价。结果表明,在钙钛矿型复合氧化物中进行B位离子掺杂,可以改善催化活性,碳颗粒燃烧温度降低。在20%LaCoO3/HZSM-5催化剂中用铁离子部分取代钴离子可以改善碳颗粒的燃烧性能,取代量增加碳颗粒燃烧温度降低,但是生成CO2的选择性也降低,以20%LaCo0.2Fe0.8O3/HZSM-5为催化剂,Tig、Tm和Tf分别为256℃、399℃和403℃,但生成CO2的选择性只有72.5%。在20%LaCo1-xFexO3/HZSM-5中的钙钛矿型复合氧化物B位离子中加入铜离子后,在碳颗粒燃烧反应中生成CO2的选择性得到明显改善,Sco2提高10个单位以上。以20%LaCo0.2Fe0.6Cu0.2O3/HZSM-5为催化剂,在碳颗粒燃烧反应中生成CO2的选择性可以达到94.7%,Tig、Tm和Tf分别为242℃、427℃和445℃。     

燃煤电厂烟气氮氧化物排放控制技术发展现状

在广泛查阅文献的基础上,对近年来国内外已成功应用和正在研究开发的一些主要的燃煤烟气氮氧化物控制技术进行了介绍。结合我国目前脱硝行业整体水平和国家环保政策要求,对我国脱硝行业技术研发方向提出了建议。