不同裂解条件对生物炭稳定性的影响

在300⁵00℃温度下热裂解水稻秸秆、玉米秸秆制备生物炭,并采用红外光谱(FTIR)和元素分析的方法,以生物炭表面官能团和元素组成为主要考察指标,研究了不同裂解温度、不同保留时间对生物炭稳定性的影响。生物炭红外光谱图结果显示,生物质原材料经过裂解炭化过程,原材料分子结构中所含醚键(C-O-C)、羰基(C=O)等基团消失。随着裂解温度升高,生物炭中甲基(-CH3)和亚甲基(-CH2)也逐渐消失,而芳环结构增加,生物炭芳香化程度增强。延长生物炭制备过程中的保留时间亦有相同结果。生物炭元素组成的结果显示,裂解温度升高及保留时间延长均能使生物炭的H/C比下降,同时裂解温度对生物炭H/C的影响更加显著。相比水稻秸秆生物炭,玉米秸秆生物炭的芳环骨架更加明显,芳香化程度更高。     

基于ImageJ评价泥炭岩心存储对色相与彩度的影响

利用ImageJ软件对2008年在红原泥炭地开展钻探时的泥炭岩心照片和2009年分样时的岩心照片进行表面色彩分析.对比分析发现,存储以前和存储以后泥炭岩心的表面色彩发生改变,表现在样品存储后基于RGB色彩体系的三元色值和灰度值均有降低(变暗),且各色值变化幅度降低.就各色值在剖面上的变化特征而言,样品存储前和存储后的变...     

非离子表面活性剂对污泥调理脱水效果的影响

现有污泥脱水技术仅使污泥含水率降到80%左右,难以满足日益严格的污泥处置要求.以污泥比阻（SRF）、脱水率为考察指标,比较了两大类非离子型表面活性剂（辛基酚聚氧乙烯醚OPEO型和烷基糖苷APG）对剩余污泥的脱水效果,并对原泥及调理后污泥进行了显微观察.结果表明,非离子表面活性剂可使污泥絮体粒径变小,不规则程度降低,改善了污泥的脱水性能,而且烷基糖苷APG脱水效果优于OPEO型.APG投加量为0.05%干固体时,污泥比阻即可降低到原泥的42%,脱水率可达到93%.以烷基糖苷APG为调理剂进行板框脱水实验,结果表明,当APG投加量为0.05%干固体时,脱水泥饼含水率比原泥脱水泥饼含水率低约10%,脱水率可达到97%.本研究为APG应用于污泥脱水,改善污泥脱水性能提供一些参考.     

酿酒酵母吸附Pb(Ⅱ)的表面特性研究

为深入探讨酿酒酵母吸附Pb（Ⅱ）的微观作用机制,本文利用表面显微分析技术（SEM-EDS、TEM-EDS、AFM）研究了酿酒酵母细胞吸附重金属离子Pb（Ⅱ）前后的细胞表面变化.研究结果表明,酿酒酵母细胞与Pb（Ⅱ）作用后,细胞表面除吸附Pb（Ⅱ）外,同时产生大量更高浓度的含Pb（Ⅱ）沉淀,导致Pb（Ⅱ）从溶液中被去除.酵母与Pb（Ⅱ）反应前,酵母细胞表面可检测到的主要元素包括C、O、N、P、S、K、Mg;酵母与Pb（Ⅱ）作用后,细胞表面始终保持C、O、P吸收峰,而N、K、Mg、S吸收峰随反应条件不同而减弱、消失或增强.P作为细胞表面组分可能与Pb（Ⅱ）结合.酵母与Pb（Ⅱ）作用过程中,重金属离子促进酵母细胞释放细胞内含物.原子力显微镜（AFM）证实,云母片表面对酵母吸附Pb（Ⅱ）后细胞的铺展变形作用明显增大.     

电袋复合除尘技术在燃煤电厂中的应用

电袋复合式除尘技术综合了电除尘和布袋除尘的收尘优点,通过除尘负荷的合理分配,实现了电除尘和布袋除尘的有机结合;采用基于表面过滤原理的新型滤料,可克服常规滤料清灰后除尘效率降低及滤袋易破损等缺点。电袋复合式除尘器在徐州坝山环保热电有限公司的应用实践表明,电袋复合式除尘器可保持高效稳定除尘同时节能,粉尘排放浓度达到了30 ...     

Evaluation of reusing alum sludge for the coagulation of industrial wastewater containing mixed anionic surfactants

A coagulation-flocculation process is typically employed to treat the industrial wastewater generated by the consumer products industry manufacturing detergents, soaps, and others. The expenditure of chemicals including coagulants and chemicals for pH adjustment is costly for treating this wastewater. The objective of this study was to evaluate the feasibility of reusing the aluminum sulfate (alum) sludge as a coagulant or as a coagulation aid so that the fresh alum dosage can be minimized or the removal e ciency can be enhanced. The experiments were conducted in a jar-test apparatus simulating the coagulation-flocculation process for simultaneous removals of organic matters, anionic surfactants, suspended solids, and turbidity. At the optimum initial pH value of 10 and the fresh alum concentration of 400 mg/L, the total suspended solids (TSS), total chemical oxygen demand (TCOD), total anionic surfactants, and turbidity removal e ciencies were 71.5%, 76.4%, 95.4%, and 98.2%, respectively. The addition of alum sludge as a coagulant alone without any fresh alum addition could significantly remove the turbidity, TCOD, and anionic surfactants. The TSS was left in the supernatants after the settling period, but would subsequently be removed by adding the fresh alum. The TSS, TCOD, and turbidity removal e ciencies were also enhanced when both the alum sludge and the fresh alum were employed. The TCOD removal e ciency over 80% has been accomplished, which has never fulfilled by using the fresh alum alone. It is concluded that the alum sludge could be reused for the treatment of industrial wastewater generated by the consumer products industry.     

Adsorptive property of Cu^2＋-loaded montmorillonite clays for Escherichia coli K_（88） in vitro

The Cu²⁺-loaded montmorillonite clays (MMT-Cu) may be a good material for the adsorbed and eliminated pathogenic bacteria from aqueous solution.     

Reversibly enhanced aqueous solubilization of volatile organic compounds using a redox-reversible surfactant

Surfactant-enhanced remediation (SER) is an effective method for the removal of volatile organic compounds (VOCs) from contaminated soils and groundwater. To reuse the surfactant the VOCs must be separated from the surfactant solutions. The water solubility of VOCs can be enhanced using reversible surfactants with a redox-acive group, (ferrocenylmethyl)dodecyldimethylammonium bromide (Fcl2) and (ferrocenylmethyl)tetradecanedimethylammonium bromide (Fcl4), above and below their critical micelle concentrations (CMC) under reducing (I⁺) and oxidative (I²⁺) conditions. The CMC values of Fcl2 and Fcl4 in I⁺ are 0.94 and 0.56 mmol/L and the solubilization of toluene by Fcl2 and Fcl4 in I⁺ for toluene is higher than the solubilization achieved with sodium dodecyl sulfate, cetyltrimethylammonium bromide and Trition X-114. The solubilization capacity of the ferrocenyl surfactants for each tested VOCs ranked as follows: ethylbenzene > toluene > benzene. The solubilities of VOCs by reversible surfactant in I⁺ were 30% higher than those in I²⁺ at comparable surfactant concentrations. The effects of Fcl4 concentrations on VOCs removal efficiency were as follows: benzene > toluene > ethylbenzene. However, an improved removal efficiency was achieved at low ferrocenyl surfactant concentrations. Furthermore, the reversible surfactant could be recycled through chemical approaches to remove organic pollutants, which could significantly reduce the operating costs of SER technology.     

一株产生物表面活性剂菌株的筛选

从被长期受石油污染的特定环境中取样,经富集培养和平板法筛选得到9株乳化性能较好的菌株.采用排油圈法对这9株菌进行表成活性测定,其中菌株SF-6表面活性最强,通过形态观察和部分生理生化试验初步鉴定该菌株为铜绿假单胞菌(Pseudomonas Aeruginosa),其所产生物表面活性物质初步鉴定为鼠李糖脂.     

土壤阴离子表面活性剂总量亚甲基蓝法研究

文章通过设计正交试验,针对提取的主要因素提取液配比、提取时间、提取温度和提取剂用量确定最优的前处理方法,建立与国标《水质阴离子表面活性剂亚甲基蓝分光光度法》(GB7494-87)对应的土壤阴离子表而活性剂(LAS)的亚甲基蓝分光光度法.土壤样品烘干后经20 mL乙醇水溶液(70％)提取,水浴恒温振荡仪45℃下振荡2h,...