首页 | 本学科首页   官方微博 | 高级检索  
文章检索
  按 检索   检索词:      
出版年份:   被引次数:   他引次数: 提示:输入*表示无穷大
  收费全文   12454篇
  免费   1822篇
  国内免费   6483篇
安全科学   1941篇
废物处理   500篇
环保管理   958篇
综合类   12802篇
基础理论   1311篇
污染及防治   2707篇
评价与监测   229篇
社会与环境   149篇
灾害及防治   162篇
  2024年   345篇
  2023年   1037篇
  2022年   1088篇
  2021年   1043篇
  2020年   824篇
  2019年   887篇
  2018年   488篇
  2017年   521篇
  2016年   613篇
  2015年   839篇
  2014年   1271篇
  2013年   900篇
  2012年   1050篇
  2011年   1060篇
  2010年   878篇
  2009年   1079篇
  2008年   1029篇
  2007年   990篇
  2006年   951篇
  2005年   672篇
  2004年   592篇
  2003年   466篇
  2002年   349篇
  2001年   272篇
  2000年   253篇
  1999年   200篇
  1998年   132篇
  1997年   139篇
  1996年   141篇
  1995年   118篇
  1994年   94篇
  1993年   135篇
  1992年   90篇
  1991年   82篇
  1990年   63篇
  1989年   51篇
  1988年   9篇
  1987年   5篇
  1986年   2篇
  1979年   1篇
排序方式: 共有10000条查询结果,搜索用时 250 毫秒
501.
针对传统的污泥处理方法存在消化时间长、投资及运行费用高、运行管理较复杂等问题,开发了污泥同时浓缩与消化——新型ISTD反应器,并对城市污水厂剩余污泥进行试验研究。试验结果表明:在3035℃,COD有机负荷0.65 kg/(m3·d),水力停留时间5 d的条件下,有机物分解率为53.88%,排泥含水率为91.91%,出水SS平均为612 mg/L。  相似文献   
502.
利用微乳化法对含油污泥进行资源化处理。通过对现场采得的SLGD含油污泥样品处理,得到该油泥的最佳微乳液组成为:SDS 0.16 g/mL,OTAC 0.04 g/mL,正丁醇0.47 g/mL,NaCl 0.034 g/mL,脱油率最高可达42.53%。最佳单次处理量为12 g(以10 mL水为基准);处理温度为30℃,最佳处理时间为30 min;在保证脱油率的前提下,微乳液可重复使用3次。  相似文献   
503.
研究了餐厨垃圾与污水污泥在不同混合比例、不同污泥停留时间条件下的共消化产酸效果。试验结果表明:当餐厨垃圾与污水污泥TS比为1∶3时,SRT=1 d的反应器酸化效率最高,且乙酸含量占优,产酸效果较佳;当TS之比为1∶1时,各反应器产酸量普遍高于1∶3时,其中SRT=5 d产酸反应器,最高酸化效率达5.94,产酸量最大,且乙酸含量占优,运行效果最佳。  相似文献   
504.
谭静亮  孙力平  李亚静 《环境工程》2013,(Z1):184-186,169
为考察曝气强度对SBR(A/O)系统N2O产生量的影响,试验采用人工合成废水长期驯化2个月后的污泥,分别考察了在0.2,0.4,0.6L/min三个曝气强度下对污染物的去除情况及N2O的产生情况。结果表明:在三种曝气强度下磷酸盐的平均去除率均可达95%98%,低曝气强度下N2O释放量明显高于中等曝气强度,高曝气强度下N2O释放量最大,0.4L/min曝气强度下污染物去除率最好N2O释放量低,因此确定为最佳曝气强度。  相似文献   
505.
王兵  宫航  任宏洋 《环境工程》2013,(Z1):247-250
目前常见的活性污泥减量技术主要包括解偶联技术、微生物的捕食作用以及隐性生长三种方法。基于臭氧氧化溶胞作用从而强化细菌隐性生长的污泥减量技术具有较好的处理效果及良好的应用前景。着重探讨了臭氧溶胞作用的机理及溶胞过程的影响因素。考虑到污泥减量技术在实际污水处理系统中的应用,探讨了臭氧溶胞对污水生物处理系统的影响。  相似文献   
506.
王剑飞  冯媛媛 《环境工程》2013,(Z1):325-328
以博哈特(Bohart)和亚当斯(Adams)方程为推导依据,结合连续进水活性炭模型实验,证明了活性炭吸附法处理冶金废水的可行性,且得出了活性炭吸附高度、工作周期、污染物去除率等重要设计参数之间的关系,为活性炭的工程设计提出了一套有效的参考计算方法和设计程序。  相似文献   
507.
Fluoride removal by traditional precipitation generates huge amounts of a water-rich sludge with low quality, which has no commercial or industrial value. The present study evaluated the feasibility of recovering fluoride as low water content cryolite from industrial fluoride-containing wastewater. A novel pilot-scale reaction-separation integrated reactor was designed. The results showed that the seed retention time in the reactor was prolonged to strengthen the induced crystallization process. The particle size of cryolite increased with increasing seed retention time, which decreased the water content. The recovery rate of cryolite was above 75% under an influent fluoride concentration of 3500 mg/L, a reaction temperature of 50℃, and an influent flow of 40 L/hr. The cryolite products that precipitated from the reactor were small in volume, large in particle size, low in water content, high in crystal purity, and recyclable.  相似文献   
508.
This work was conducted to determine the practicability of using a new adsorbent 4-ethyl thiosemicarbazide intercalated,organophilic calcined hydrotalcite(ETSC-OHTC) for the removal of uranium(U(VI)),and thorium(Th(IV)) from water and wastewater.The FTIR analysis helped in realizing the involvement of nitrogen and sulphur atoms of ETSC in binding the metal ions through complex formation.Parameters like adsorbent dosage,solution pH,initial metal ions concentration,contact time and ionic strength,that influence adsorption phenomenon,were studied.The optimum pH for maximum adsorption of U(VI) and Th(IV) was found to be in the range 4.0-6.0.The contact time required for reaching equilibrium was 4 hr.The pseudo second-order kinetic model was the best fit to represent the kinetic data.Analysis of the equilibrium adsorption data using Langmuir,Freundlich and Sips models showed that the Freundlich model was well suited to describe the metal ions adsorption.The K F values were 25.43 and 29.11mg/g for U(VI) and Th(IV),respectively,at 30°C.The adsorbent can be regenerated effectively from U(VI) and Th(IV) loaded ones using 0.01mol/L HCl.The new adsorbent was quite stable for many cycles,without much reduction in its adsorption capacity towards the metals.  相似文献   
509.
不同Fe(Ⅲ)对活性污泥异化铁还原及除磷影响研究   总被引:1,自引:0,他引:1  
以SBBR反应器活性污泥作为铁还原菌菌种来源,采用兼性厌氧/严格厌氧恒温培养试验,投加不同Fe(Ⅲ)考察各条件下的异化铁还原能力同时比较对磷的去除效果.结果表明:2种条件下Fe(Ⅲ)还原能力具有较好的一致性,依次为:Fe(OH)3>氧化铁皮>青矿>红矿,其中严格厌氧条件下较好.同时,除磷效果与其呈正相关,富集培养至7d,Fe(OH)3及氧化铁皮体系出水磷浓度均达到2mg/L以下,之后继续降低,最终达到0.5mg/L以下.结合异化铁还原除磷机理,可以证明,不同Fe(Ⅲ)表面吸附作用对TP的去除贡献较小,其主要作用为铁还原菌驱动下的化学沉淀去除.  相似文献   
510.
瞿贤  周珉  刘琴 《环境工程》2013,(Z1):40-43
实验利用复合膜生物反应器处理以甘油为原料制备环氧氯丙烷产生的废水,考察了不同进水COD、水力停留时间以及盐度对处理能力的影响,并进行盐度冲击实验。生物处理后出水进行了深度处理的研究。结果表明:进水COD对处理能力影响较小;适当延长水力停留时间能优化出水水质;废水盐度高于22g/L时会对微生物产生抑制作用;深度处理能进一步降低出水COD;微生物通过一定时间的驯化期能适应并处理高盐度废水。  相似文献   
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号