Biological pretreatment of Yellow River water

Bio-ceramic filter(BF) and moving-bed biofilm reactor(MBBR) were used for biological pretreatment of Yellow River water in this study. The BF only had slight advantage over MBBR for TOC and ammonia removal. However, like UV254, the average removal rate of THMFP in the BF was much higher than that in the MBBR. UV254 removal did not show obvious correlation with trihalomethane formation potential(THMFP) removal. Hexachlorocyclohexane could be effectively removed in both BF and MBBR. As for diatom and cyanobateria removal the MBBR had better performance than the BF, which was contrary to the average chlorophyll-a(Chl-a) removal rate. The proposal was made in this study that biological flocculation and sedimentation of sloughed biofilm should play a more important role on algae removal in the MBBR than in the BF. The BF and MBBR could effectively remove microcystins. Moreover, MBBR could be a promising technology for biological pretreatment.     

缺氧MBBR耦合部分厌氧氨氧化强化城市生活污水深度脱氮

缺氧MBBR是强化传统城市污水处理系统脱氮的一种方法,本研究通过向城市污水后置反硝化SBR中投加填料构建了缺氧双污泥系统,实现了城市生活污水部分厌氧氨氧化深度脱氮.在250d的运行中脱氮性能逐渐提高并实现稳定,出水总氮在5 mg·L~(-1)左右. 211～250 d的平均硝氮、氨氮和总氮去除率分别为(97. 7±2. 9)%、(93. 3±2. 9)%和(94. 3±2. 7)%.长期运行中观测到氨氮和硝氮的同步去除.针对氨氮去除途径进行分析,系统同化、硝化作用微弱.缺氧MBBR中存在厌氧氨氧化活性且对脱氮有不可忽视的作用.实时定量PCR结果进一步说明缺氧MBBR中厌氧氨氧化菌富集,特别是缺氧填料生物膜中厌氧氨氧化菌丰度由初始的4. 37×10~7copies·g~(-1)增长到了2. 28×10~(10)copies·g~(-1).本研究表明缺氧填料生物膜在厌氧氨氧化的富集强化城市污水深度脱氮中或许具有可应用的潜能.     

脉冲上流式厌氧污泥床反应器的应用

将传统的连续式改为间歇式配水,可改善反应器的水力环境,促进基质与生物体之间的有效接触。脉冲配水使污泥的有机负荷ＣＯＤ达２７．５ｇ／（Ｌ．ｄ）．ＨＲＴ降到约３ｈ,加速了污泥的颗粒化进程,４７ｄ培养出良好的颗粒污泥。脉冲配水不会造成冲击负荷和中间产物积累,也不会造成大量的污泥流失。在高负荷条件下,颗粒污泥中确实出现了大量的八叠甲烷球菌凝块。     

运用三维荧光光谱解析高温厌氧产氢反应过程对温度变化的响应

为建立反应器运行状态的荧光光谱快速监测方法,应用三维荧光光谱表征了高温厌氧反应器的出水,采用平行因子分析方法分析后得到3种荧光组分——蛋白质、辅酶NADH和核黄素,并获得它们的激发发射光谱图及相对浓度.结果表明,当温度从50 ℃上升到60 ℃的过程中,3种荧光物质的相对浓度均呈现相应的变化,它们与反应器的运行参数呈现明显相关性.进一步研究表明,核黄素是高温厌氧产氢反应中的特有荧光物质,采用标准加入法和二阶校正方法可以测定其实际浓度,出水中核黄素浓度变化范围为0.04~0.13 mg·L^-1.该研究为厌氧产氢反应器的运行监控提供了理论基础.     

一体式膜-生物反应器长期运行中的膜污染控制

考察一体式膜－生物反应器运行过程中的膜污染情况,探讨造成膜污染的原因和膜污染的控制方法．结果表明,膜内表面微生物的滋生和膜外表面污泥层的附着是造成本试验膜污染的重要因素．采用２％ ～５％ 的次氯酸钠溶液进行在线药洗可以有效地去除膜内表面滋生的微生物,使膜过滤压差下降７．７～５２ｋＰａ;停止进出水,加大曝气量进行空曝气是去除膜外表面附着污泥层的重要手段,可以使膜过滤压差下降３．８～１０．８ｋＰａ;采用处理出水进行反冲洗虽然有时可以使膜过滤压差出现较大程度的降低,但随之会出现出水水质恶化,膜过滤压差急剧升高的现象．     

Alga-lysing bioreactor and dominant bacteria strain

Alga-lysing bacteria have been paid much attention to in recent years. In this study, the alga-lysing strain P05 which was isolated from an immobilizing biosystem was immobilized by coke and elastic filler, forming two biological reactors. The removal efficiencies of algae, NH4^＋-N and organic matter using the two reactors were studied. The results showed that strain P05 was an ideal algal-lysing bacteria strain because it was easy to be immobilized by coke and elastic filler which are of cheap, low biodegradability and the simple immobilization procedure. After 7 d filming, the biological film could be formed and the reactors were used to treat the eutrophic water. These two reactors were of stability and high effect with low cost and easy operation. The optimal hydraulic retention time （HRT） of each reactor was 4 h. The algae removal rates were 80.38% and 82.1% （in term of Chl-α） of coke reactor and filler reactor, respectively. And that of NH4^＋-N were 52.3% and 52.7%. The removal rates of CODMn were 39.03% and 39.64%. The strain P05 was identified as Bacillus sp. by PCR amplification of the 16S rRNA gene, BLAST analysis, and comparison with sequences in the GenBank nucleotide database.     

UASB反应器中颗粒污泥的沉降性能与终端沉降速度

从流体力学角度,通过建立沉降速度模型探讨了UASB反应器中颗粒污泥的沉降性能与终端沉降速度．计算结果表明,(1)绝大多数颗粒污泥的沉降过程属于过渡区(1＜Re＜100)而非层流区,其沉降速度与直径成正比,可用Allen公式进行计算;(2)颗粒污泥的终端沉降速度远高于厌氧反应器中废水的上流速度,其良好的沉降性能解决了在高负荷情况下污泥的流失问题．所建模型能较好地反映实际条件下的情况．为厌氧反应器的工艺设计与正常运行提供理论依据．     

生物膜净化含苯废气的性能研究

在生物法净化废气装置中生物膜是设备的主体和关键．研究以净化含苯废气的生物滴滤塔为对象,采用静态反应器对塔内生物膜的净化性能进行研究,探索其过程机理,为生物滴滤器的优化提供技术支持．结果表明,在生物滴滤器中单位体积生物膜的呼吸速率和苯去除速率都沿气流方向逐渐减小,但单位质量生物膜的苯去除速率却是塔中部高两边低．研究发现,当生物膜经过3d的闲置后,苯的消除能力提高了70％左右,但闲置时间超过5d后,生物净化性能开始下降．综合实验结果,推测在生物膜中同时存在苯的生物降解过程和生物储备能源的合成过程,在苯浓度越高的地方储备能源的量也越多,储备能源的存在降低了生物膜的净化能力但增强了生物膜的稳定性．     

无机膜-生物反应器处理生活污水试验研究

用无机膜－生物反应器进行处理生活污水试验,结果表明,当ＨＲＴ为５ｈ,膜通量为７５－１５０Ｌ／（ｍ＾２．ｈ）膜面流速为４ｍ／ｓ,ＳＲＴ为５,１５,３０ｄ时,分别经过１０,１６,１４ｄ,运行,生物反应器ＭＬＳＳ达到稳定值３．１,１０．７,１７．３ｇ／Ｌ,对ＣＯＤ,ＮＨ３－Ｎ和浊度的去除率分别为超过９６％,９５％,９８％,对ＳＳ和Ｅ．ｃｏｌｉ的去除率则达１００％;试验出水水质优于建设部生活杂用水水质标准     

生物膜系统中部分反硝化实现特性

以移动床生物膜反应器（moving-bed biofilm reactor,MBBR）为例,考察生物膜系统中部分反硝化NO₂^--N积累特性,并通过耦合厌氧氨氧化验证生物膜系统中部分反硝化耦合厌氧氨氧化（partial denitrification with anaerobic ammonium oxidation,PD+ANAMMOX）工艺的可行性.结果表明,在C/N为3.0,填充率为20%的条件下,经过40 d的富集培养,实现部分反硝化,NO₂^--N积累率达（69.38±3.53）%;接种生物膜NO₃^--N还原酶（nitrate reductase,NAR）活性为0.03 μmol·（min·mg）^-1,NO₂^--N还原酶（nitrite reductase,NIR）活性为0.18 μmol·（min·mg）^-1,富集培养后生物膜NAR活性增至0.45 μmol·（min·mg）^-1,NIR活性降至0.02 μmol·（min·mg）^-1,从酶学角度验证了部分反硝化实现;高通量测序结果显示,Thauera属从0.3%增加至37.27%,在微生物群落中占主导地位,该菌属被认为是部分反硝化过程的主要功能菌.随后与厌氧氨氧化耦合,出水总氮达（6.41±1.50） mg·L^-1,总氮去除率达（88.16±2.71）%,证明了生物膜系统中PD+ANAMMOX的可行性及稳定性.